Benchmark experiment of large-angle scattering reaction cross section of iron at 14 MeV using two shadow bars – Comparison of experimental results with ENDF/B-VIII –

ABSTRACT

It is important to perform neutron transport simulations with accurate nuclear data in the neutronics design of a fusion reactor. However, absolute values of large-angle scattering cross sections vary among nuclear data libraries even for well-examined nuclide of iron. Benchmark experiments focusing on large-angle scattering cross sections were thus performed to confirm the correctness of nuclear data libraries. The series benchmark experiments were performed at a DT neutron source facility, OKTAVIAN of Osaka University, Japan, by the unique experimental system established by the authors’ group, which can extract only the contribution of large-angle scattering reactions. This system consists of two shadow bars, target plate (iron), and neutron detector (niobium). Two types of shadow bars were used and four irradiations were conducted for one experiment, so that contribution of room-return neutrons was effectively removed and only large-angle scattering neutrons were extracted from the measured four Nb reaction rates. The obtained experimental results were compared with calculations for five nuclear data libraries including JENDL-4.0, JEFF.-3.3, FENDL-3.1, ENDF/B- VII, and recently released ENDF/B-VIII. It was found from the comparison that ENDF/B-VIII showed the best result, though ENDF/B-VII showed overestimation and others are in large underestimation at 14 MeV.     

Supramolecular Zn(II)-Dipicolylamine-Azobenzene-Aminocyclodextrin-ATP Complex: Design and ATP Recognition in Water

Cyclodextrins (CyDs) are water-soluble host molecules possessing a nanosized hydrophobic cavity. In the realm of molecular recognition, this cavity is used not only as a recognition site but also as a reaction medium, where a hydrophobic sensor recognizes a guest molecule. Based on the latter concept, we have designed a novel supramolecular sensing system composed of Zn(II)-dipicolylamine metal complex-based azobenzene (1-Zn) and 3A-amino-3A-deoxy-(2AS,3AS)-γ-cyclodextrin (3-NH₂-γ-CyD) for sensing adenosine-5′-triphosphate (ATP). 1-Zn showed redshifts in the UV-Vis spectra and induced circular dichroism (ICD) only when both ATP and 3-NH₂-γ-CyD were present. Calculations of equilibrium constants indicated that the amino group of 3-NH₂-γ-CyD was involved in the formation of supramolecular 1-Zn/3-NH₂-γ-CyD/ATP. The Job plot of the ICD spectral response revealed that the stoichiometry of 1-Zn/3-NH₂-γ-CyD/ATP was 2:1:1. The pH effect was examined and 1-Zn/3-NH₂-γ-CyD/ATP was most stable in the neutral condition. The NOESY spectrum suggested the localization of 1-Zn in the 3-NH₂-γ-CyD cavity. Based on the obtained results, the metal coordination interaction of 1-Zn and the electrostatic interaction of 3-NH₂-γ-CyD were found to take place for ATP recognition. The “reaction medium approach” enabled us to develop a supramolecular sensing system that undergoes multi-point interactions in water. This study is the first step in the design of a selective sensing system based on a good understanding of supramolecular structures.     

Approximate cutting pattern optimization of frame-supported and pneumatic membrane structures

International Journal of Mechanics and Materials in Design - A simple iterative method is presented for cutting pattern optimization of frame-supported and pneumatic membrane structures for...     

Asymptotic optimality of the GMD and Chase decoding algorithms

The generalized minimum distance (GMD) and Chase (1972) decoding algorithms are some of the most important suboptimum bounded distance decoding algorithms for binary linear block codes over an additive white Gaussian noise (AWGN) channel. We compute the limitation of the ratio between the probability of decoding error for the GMD or any one of the Chase decoding algorithms and that of the maximum-likelihood (ML) decoding when the signal-to-noise ratio (SNR) approaches infinity. If the minimum Hamming distance of the code is greater than 2, the limitation is shown to be equal to 1 and thus the GMD and Chase decoding algorithms are asymptotically optimum.     

Design for Consecutive Testability of System-on-a-Chip with Built-In Self Testable Cores

This paper introduces a new concept of testability called consecutive testability and proposes a design-for-testability method for making a given SoC consecutively testable based on integer linear programming problem. For a consecutively testable SoC, testing can be performed as follows. Test patterns of a core are propagated to the core inputs from test pattern sources (implemented either off-chip or on-chip) consecutively at the speed of system clock. Similarly the test responses are propagated to test response sinks (implemented either off-chip or on-chip) from the core outputs consecutively at the speed of system clock. The propagation of test patterns and responses is achieved by using interconnects and consecutive transparency properties of surrounding cores. All interconnects can be tested in a similar fashion. Therefore, it is possible to test not only logic faults but also timing faults that require consecutive application of test patterns at the speed of system clock since the consecutively testable SoC can achieve consecutive application of any test sequence at the speed of system clock.     

Influence of initial growth layer and Ti underlayer on magneticproperties and recording characteristics of very thin films ofevaporated Co-Cr media

A Co-Cr film deposited directly on a substrate has an initial growth layer with low coercivity. However, the existence of a Ti underlayer prevents the formation of such a layer. As a result, Co-Cr film deposited on a Ti underlayer has high perpendicular anisotropy and coercivity even in cases of extremely thin film thickness (200 Å). As for the read-write characteristics of Co-Cr thin-film media, the existence of such an initial growth layer greatly improves the reproduced output level. The cause for this is considered to be that the free charges which appear on the back surface of the perpendicular recording layer are reduced and the demagnetization field acting on the recorded magnetization subsequently decreases due to the existence of the initial growth layer     

Novel hepatitis C virus protease inhibitors: thiazolidine derivatives

This study evaluated the inhibitory effects of thiazolidine derivatives on hepatitis C virus (HCV) protease and other human serine proteases. The inhibition efficacy was tested with a reversed-phase high-performance liquid chromatography (HPLC) assay system using a NS3-NS4A fusion protein as the HCV protease and a synthetic peptide substrate that mimics the NS5A-5B junction. Nine thiazolidine derivatives showed more than 50% inhibition at 50 microg/ml. The most potent derivative was RD4-6250, with 50% inhibition at a concentration of 2.3 microg/ml; this concentration was lower than those of other protease inhibitors reported previously. The most selective derivative was RD4-6205, with 50% inhibition at a concentration of 6.4 microg/ml, a lower concentration than those on other serine proteases (chymotrypsin, trypsin, plasmin, and elastase). These results suggest that the RD4-6205 skeleton is an important structure for inhibitory activity on the HCV protease NS3-NS4A.     

Solution synthesis of crystallized AMO4 (A=Ba, Sr, Ca; M=W, Mo) film at room temperature

A well-crystallized AMO₄ (A=Ba, Ca, Sr; M=W, Mo) films have been prepared at room temperature through a simple solution reaction in respective alkaline solution at higher pH ranging from 12–14. Adopting the corrosion principle for oxidation of metal substrate, these double oxide films were carried out in presence of chemical driving force without any special apparatus or devices. Hydrogen peroxide was used to enhance the dissolution rate of metal substrates. The driving force for the film formation and growth were high concentration of A²⁺, MO₄²⁻ ions with high pH conditions. Average grain sizes of 8–10 μm with bipyramidal shaped particle were grown to the thickness of about 10–14 μm after 3–6 hours treatment. The crystallization of AMO₄ was characterized by three-dimensional nucleation. This work demonstrates the possibility of fabrication of functional ceramic films directly from the aqueous solution in a single step by solution reactions.     

Inhibitory effect of lead on the proliferation of cultured vascular endothelial cells

We investigated the effect of lead nitrate (0.5, 1.0, 2.0 or 5.0 microM) on the proliferation of cultured bovine aortic endothelial cells. After exposure to lead, the number of cells and the incorporation of [3H]thymidine into the acid-insoluble fraction of the cells were reduced in parallel in a concentration-dependent manner. Histologically, lead treatment resulted in a decrease in the cell number accompanied by a change in the cell shape from polygonal to spindle; however, no degenerative change was observed except in 5.0 microM lead-treated cells. Furthermore, stimulation of [3H]thymidine incorporation by either basic or acidic fibroblast growth factor was significantly reduced by lead. However, the leakage of lactate dehydrogenase into the medium from the cells, a marker of nonspecific cell damage, was not changed by lead. From these results, it was revealed that lead inhibits the proliferation of cultured vascular endothelial cells without nonspecific cell damage. Although lead does not destroy the monolayer of endothelial cells, the metal may exhibit its noxious effect in the repair process of the vascular endothelium.