Comparative analysis of formaldehyde and toluene sorption on indoor floorings and consequence on Indoor Air Quality

Indoor surfaces may be adsorptive sinks with the potential to change Indoor Air Quality. To estimate this effect, the sorption parameters of formaldehyde and toluene were assessed on five floorings by an experimental method using solid-phase microextraction in an airtight emission cell. Adsorption rate constants ranged from 0.003 to 0.075 m·h⁻¹, desorption rate constants from 0.019 to 0.51 h⁻¹, and the partition coefficient from 0.005 to 3.9 m, and these parameters vary greatly from one volatile organic compound/material couple to another indicating contrasted sorption behaviors. A rubber was identified as a sink of formaldehyde characterized by a very low desorption constant close to 0. For these sorbent floorings identified, the adsorption rates of formaldehyde are from 2 to 4 times higher than those of toluene. Two models were used to evaluate the sink effects of floorings on indoor pollutant concentrations in one room from different realistic conditions. The scenarios tested came to the conclusion that the formaldehyde sorption on one rubber (identified as a sink) has a maximum contribution from 15% to 21% for the conditions of low air exchange rate. For other floorings, the sorption has a minor contribution less than or equal to 5%, regardless of the air exchange rate.     

Inverse identification of constitutive parameters from heat source fields: A local approach applied to hyperelasticity

In this paper, a new inverse identification method of constitutive parameters is developed from full kinematic and thermal field measurements. It consists in reconstructing the heat source field from two different approaches by using the heat diffusion equation. The first one requires the temperature field measurement and the value of the thermophysical parameters. The second one is based on the kinematic field measurement and the choice of a thermo-hyperelastic model that contains the parameters to be identified. The identification is carried out at the local scale, ie, at any point of the heat source field, without using the boundary conditions. In the present work, the method is applied to the challenging case of hyperelasticity from a heterogeneous test. Due to large deformations undergone by the rubber specimen tested, a motion compensation technique is developed to plot the kinematic and the thermal fields at the same points before reconstructing the heterogeneous heat source field. In the present case, the constitutive parameter of the Neo-Hookean model has been identified, and its distribution has been characterized with respect to the strain state at the surface of a cross-shaped specimen.     

Sinusoidal disturbance rejection in chaotic planar oscillators

The main goal of this paper is to design a compensator able to restore the nominal behavior of a planar system, which is rendered chaotic by an unmeasurable sinusoidal disturbance input. To reach such a goal, some instruments, taken from algebraic geometry, are used to estimate the unmeasurable disturbance from the time derivatives of the output of the system and of the control input. Copyright © 2015 John Wiley & Sons, Ltd.     

Bootstrap procedures for detecting multiple persistence shifts in heteroskedastic time series

This article proposes new bootstrap procedures for detecting multiple persistence shifts in a time series driven by non-stationary volatility. The assumed volatility process can accommodate discrete breaks, smooth transition variation as well as trending volatility. We develop wild bootstrap sup-Wald tests of the null hypothesis that the process is either stationary [I(0)] or has a unit root [I(1)] throughout the sample. We also propose a sequential procedure to estimate the number of persistence breaks based on ordering the regime-specific bootstrap p-values. The asymptotic validity of the advocated procedures is established both under the null of stability and a variety of persistence change alternatives. A comparison with existing tests that assume homoskedasticity illustrates the finite sample improvements offered by our methods. An application to OECD inflation rates highlights the empirical relevance of the proposed approach and weakens the case for persistence change relative to existing procedures.     

Synthesis of Long-Chain β-Lactones and Their Antibacterial Activities against Pathogenic Mycobacteria

In the quest for new antibacterial agents, a series of novel long- and medium-chain mono- and disubstituted β-lactones was developed. Their activity against three pathogenic mycobacteria—M. abscessus, M. marinum, and M. tuberculosis—was assessed by the resazurin microtiter assay (REMA). Among the 16 β-lactones synthesized, only 3-hexadecyloxetan-2-one (VM005) exhibited promising activity against M. abscessus, whereas most of the β-lactones showed interesting activities against M. marinum, similar to that of the classical antibiotic, isoniazid. Regarding M. tuberculosis, six compounds were found to be active against this mycobacterium, with β-lactone VM008 [trans-(Z)-3-(hexadec-7-en-1-yl)-4-propyloxetan-2-one] being the best growth inhibitor. The promising antibacterial activities of the best compounds in this series suggest that these molecules may serve as leads for the development of much more efficient antimycobacterial agents.     

Impact of the anode operating conditions on the liquid water distribution in the cathode gas diffusion layer

Previous experimental results indicate that the humidification conditions at the anode have an impact on the liquid water distribution in the cathode gas diffusion layer. Numerical simulations are developed to reproduce and analyze this effect. Results consistent with the experimental results are first obtained by playing with the partition coefficients of an advanced pore network model computing the liquid water formation and transfer in the cathode gas diffusion layer (GDL) for a large range of operating conditions. Then, a model for the full anode – cathode assembly is developed by combining the pore network model of the cathode GDL and a 1D model describing the heat and water transfer in the various components of the anode-cathode assembly. This enables one to generalize the dry – wet regime diagram introduced in a previous work by incorporating the effect of the humidity condition at the anode.     

Spatio-temporal evolution of the deformation around the Rio-Patras fault (Greece) observed by synthetic aperture radar interferometry from 1993 to 2017

We analysed the ground deformation across two blocks defined by the Rio-Patras fault from 1993 to 2017 using multi-temporal Synthetic Aperture Radar Interferometry (InSAR) techniques. Our main objective was to contribute to the assessment of seismic hazard near the large city of Patras. Multiple data-sets were used, each one covering different temporal periods. Descending and ascending acquisitions, providing different viewing geometries contribute to fully determine the ground displacement in 3D. The data-sets used are from the European Space Agency’s (ESA) European Remote Sensing (ERS), Environmental Satellite (ENVISAT) and SENTINEL-1 as well as German Aerospace Center (DLR) ’s TERRASAR-X missions. Considering ESA’s missions covering both acquisition geometries and long periods, the southern block, showing lack of a sufficient number of scatterers does not allow the displacement characterization. In contrary, the northern block is characterized by a high number of scatterers having values of maximum likehood ranging from ?3.5 to ?4.3 mm year^?1 for ascending geometry and from ?1.6 to ?2.7 mm year^?1 for the descending one. The fact that both geometries show negative values of displacements are consistent with downlift movement and at the same time the quantitative differentiation probably indicates an horizontal component as well.     

Carbon supported bimetallic Ru‐Co catalysts for H2 production through NaBH4 and NH3BH3 hydrolysis

This work investigates the effect of the addition of small amounts of Ru (0.5‐1 wt%) to carbon supported Co (10 wt%) catalysts towards both NaBH₄ and NH₃BH₃ hydrolysis for H₂ production. In the sodium borohydride hydrolysis, the activity of Ru‐Co/carbon catalysts was sensibly higher than the sum of the activities of corresponding monometallic samples, whereas for the ammonia borane hydrolysis, the positive effect of Ru‐Co systems with regard to catalytic activity was less evident. The performances of Ru‐Co bimetallic catalysts correlated with the occurrence of an interaction between Ru and Co species resulting in the formation of smaller ruthenium and cobalt oxide particles with a more homogeneous dispersion on the carbon support. It was proposed that Ru^°, formed during the reduction step of the Ru‐Co catalysts, favors the H₂ activation, thus enhancing the reduction degree of the cobalt precursor and the number of Co nucleation centers. A subsequent reduction of cobalt and ruthenium species also occurs in the hydride reaction medium, and therefore the state of the catalyst before the catalytic experiment determines the state of the active phase formed in situ. The different relative reactivity of the Ru and Co active species towards the two investigated reactions accounted for the different behavior towards NaBH₄ and NH₃BH₃ hydrolysis.     

Automatic fog detection and estimation of visibility distance through use of an onboard camera

In this paper, we will present a technique for measuring visibility distances under foggy weather conditions using a camera mounted onboard a moving vehicle. Our research has focused in particular on the problem of detecting daytime fog and estimating visibility distances; thanks to these efforts, an original method has been developed, tested and patented. The approach consists of dynamically implementing Koschmieder's law. Our method enables computing the meteorological visibility distance, a measure defined by the International Commission on Illumination (CIE) as the distance beyond which a black object of an appropriate dimension is perceived with a contrast of less than 5%. Our proposed solution is an original one, featuring the advantage of utilizing a single camera and necessitating the presence of just the road and sky in the scene. As opposed to other methods that require the explicit extraction of the road, this method offers fewer constraints by virtue of being applicable with no more than the extraction of a homogeneous surface containing a portion of the road and sky within the image. This image preprocessing also serves to identify the level of compatibility of the processed image with the set of Koschmieder's model hypotheses. Nicolas Hautiére graduated from the École Nationale des Travaux Publics de l'État, France (2002). He received his M.S. and Ph.D. degree in computer vision, respectively, in 2002 and 2005 from Saint-Étienne University (France). From 2002, he is a researcher in the Laboratoire Central des Ponts et Chaussées (LCPC), Paris, France. His research interests include trafic engineering, computer vision, and pattern recognition. Jean-Philippe Tarel graduated from the École Nationale des Ponts et Chaussées, Paris, France (1991). He received his Ph.D. degree in Applied Mathematics from Paris IX-Dauphine University in 1996 and he was with the Institut National de Recherche en Informatique et Automatique (INRIA) from 1991 to 1996. From 1997 to 1998, he was a research associate at Brown University, USA. From 1999, he is a researcher in the Laboratoire Central des Ponts et Chaussées (LCPC), Paris, France, and from 2001 to 2003 in the INRIA. His research interests include computer vision, pattern recognition, and shape modeling. Jean Lavenant graduated from the École Nationale des Travaux Publics de l'État, Lyon, France (2001). He received the M.S. degree in Computer Vision from Jean Monnet university of Saint-Étienne in 2001. In 2001, he was a researcher in the Laboratoire Central des Ponts et Chaussées (LCPC). In 2002, he was a system engineer in Chicago (USA). He is currently an engineer for the french ministry of transports. Didier Aubert received the M.S. and Ph.D. degree, respectively, in 1985 and 1989 from the National Polytechnical Institut of Grenoble (INPG). From 1989--1990, he worked as a research scientist on the development of an automatic road following system for the NAVLAB at Carnegie Mellon University. From 1990–1994, he worked in the research department of a private company (ITMI). During this period he was the project leader of several projects dealing with computer vision. He is currently a researcher at INRETS since 1995 and works on Road traffic measurements, crowd monitoring, automated highway systems, and driving assistance systems for vehicles. He is an image processing expert for several companies, teaches at Universities (Paris VI, Paris XI, ENPC, ENST) and is at the editorial board of RTS (Research - Transport - Safety).