全文获取类型
收费全文 | 1520篇 |
免费 | 130篇 |
国内免费 | 79篇 |
专业分类
电工技术 | 105篇 |
综合类 | 95篇 |
化学工业 | 263篇 |
金属工艺 | 123篇 |
机械仪表 | 83篇 |
建筑科学 | 157篇 |
矿业工程 | 54篇 |
能源动力 | 23篇 |
轻工业 | 100篇 |
水利工程 | 26篇 |
石油天然气 | 132篇 |
武器工业 | 18篇 |
无线电 | 116篇 |
一般工业技术 | 140篇 |
冶金工业 | 94篇 |
原子能技术 | 14篇 |
自动化技术 | 186篇 |
出版年
2024年 | 3篇 |
2023年 | 26篇 |
2022年 | 56篇 |
2021年 | 77篇 |
2020年 | 47篇 |
2019年 | 51篇 |
2018年 | 36篇 |
2017年 | 38篇 |
2016年 | 45篇 |
2015年 | 72篇 |
2014年 | 101篇 |
2013年 | 95篇 |
2012年 | 107篇 |
2011年 | 112篇 |
2010年 | 117篇 |
2009年 | 99篇 |
2008年 | 75篇 |
2007年 | 82篇 |
2006年 | 86篇 |
2005年 | 69篇 |
2004年 | 52篇 |
2003年 | 35篇 |
2002年 | 32篇 |
2001年 | 38篇 |
2000年 | 39篇 |
1999年 | 39篇 |
1998年 | 20篇 |
1997年 | 10篇 |
1996年 | 12篇 |
1995年 | 18篇 |
1994年 | 11篇 |
1993年 | 4篇 |
1992年 | 9篇 |
1991年 | 3篇 |
1990年 | 5篇 |
1989年 | 4篇 |
1988年 | 1篇 |
1987年 | 1篇 |
1986年 | 1篇 |
1959年 | 1篇 |
排序方式: 共有1729条查询结果,搜索用时 296 毫秒
1.
2.
停转后泵的阻力特性对自然循环流量影响明显。为研究低流量自然循环工况下离心泵的阻力特性,设计了实验台架,对离心泵的正向压降、反向压降和损失系数进行了测量,实验雷诺数为2.0×104~1.5×105。实验表明:相同雷诺数下,反向压降明显高于正向压降;雷诺数大于8×104时,损失系数基本保持不变,而低雷诺数下损失系数随雷诺数的降低有增大的趋势;基于实验得到了损失系数的经验关系式。采用CFD方法对离心泵的内部流场进行了模拟,计算表明:CFD方法能较好地预测损失系数,RNG k-ε模型与实验值的相对误差不超过10%;离心泵的压力损失主要集中在叶轮、导叶等结构的交界区域;正向与反向流动的流场分布存在显著区别;低雷诺数下局部流动更加不稳定。 相似文献
3.
在石化安全关键设备寿命截尾数据的可靠性评估过程中,为避免传统可靠性评估方法未考虑维修对故障间隔时间的影响,以及中值填充法误差较大的缺点,本文提出了一种逆变换区间截尾数据填充方法。首先,在可修系统基于最小维修的假设下,通过非齐次泊松过程描述系统的故障趋势,利用逆变换填充得到监测区间的缺失数据;随后根据蒙特卡罗期望最大化算法,获得填充数据的参数估计值。通过蜡油加氢装置紧急泄压阀的案例分析,该算法能够很好地融合已有数据,得到的形状参数估计值偏差与中值填充法相比缩小4%以上,从而验证了该算法的有效性;这有助于安全关键设备的定量化完整性管理,保障石化装置平稳运行。 相似文献
4.
本文研究分组交换数据网与ISDN互连的性能分析,文中考虑了分组肉与窄带ISDN和宽带ISDN互连时信关所应完成的功能,分别给出了两种情况下的信关排队模型;在信关存储容量分别为有限和无限的情况下,对两种模型进行了求解,给出了阻塞概率和平均延迟的表达式。对于与B-ISDN互连的情况,提出了用开关确定性过程来描述输出排队的分组到达流,并提出了一种小时隙方法分析SDP/D/1排队。 相似文献
5.
Eu3 ions were incorporated in sol and gel by a sol-gel processing using 3-glycidoxypropyltrimethoxysilane(CH2OCHCH2O(CH2)3Si(OCH3)3, GPTMS) and ethyl silicate (TEOS) as precursors. The basic chemical-physical properties such as DTA curve, FF-IR spectra and specific surface area were recorded. The characteristics of their optical spectra were measured and investigated. The results indicate that the emission intensity of Eu3 ion in ormocer is much higher and the global line width is wider than those in SiO2 gel. The relationship between the composition and structure of gels and the fluorescence intensity and width were discussed. The obtained ormocer shows good mechanical strength, which can be cut and polished in machine without broken. 相似文献
6.
Monolithic Catalysts with Low Noble-Metal Content for Exhaust Purification of Small Gasoline Engines
A series of low noble-metal coment monolithic catalysts for exhaust purification of small gasoline engines was investigated, and it was found that the Pt/Rh-OSM/Al2O3 (where OSM was oxygen storage material) catalyst with Ce0.5Zr0.5-MnOx(3%MnOx) OSM held low light-off temperature for CO, HC, and NO; quite wide three-way window, and outstanding thermal stability. The catalyst could efficiently comrol exhaust emission of small gasoline engines. 相似文献
7.
砾石土料最大粒径为100 mm全级配击实仪的成功研制与应用,提高了全级配击实试验的科学性,保证了试验结果准确可靠。特别在类似的工程中全级配击实仪首次采用锤击点角度为53.5°,实现了锤击点之间无击实盲区,在国内已建类似工程中未见相关文献资料。本文依托双江口水电站工程,研制全级配土料超大型击实仪(土料最大粒径为100 mm),真实反映了土料全级配击实试验结果,为砾石土心墙料采用全料压实度控制碾压质量提供可靠的基础数据,具有较高的推广价值。 相似文献
8.
预转变马氏体对GCr15钢贝氏体转变动力学的影响SCIEI 总被引:2,自引:0,他引:2
本文利用磁性法和膨胀法研究了GCr15钢M_s点以下贝氏体转变动力学以及不同温度预转变马氏体对240℃等温时贝氏体转变动力学的影响。试验结果表明,过冷奥氏体在M_s点以下等温过程中首先形成变温马氏体,继而转变为下贝氏体。随着等温温度的降低和预淬马氏体数量的增加,应力促发作用有助于贝氏体转变的加速,200℃左右其孕育期最短。但是,当温度继续下降、预淬马氏体超过一定数量之后,贝氏体转变却愈趋困难,此外,M_s点以下不同温度的预转变马氏体对随后240℃等温时贝氏体转变动力学影响的研究结果,也具有相同的特性。 相似文献
9.
Effect of preparation conditions on the properties of a coal-derived activated carbon honeycomb monolith 总被引:1,自引:0,他引:1
Activated carbon honeycomb (ACH) monoliths were prepared by extruding of a mixture of bituminous coal and organic additives and subsequent carbonization and steam activation. Preparation parameters that were varied were carbonization temperature and activation time. The carbonization conditions were 500, 650 and 800 °C for 1 h and the steam activation conditions were 850 °C for 2, 4 and 6 h. The monoliths at various states were characterized by SEM, XRD, nitrogen adsorption and compression test. It was found that carbonization temperature has significant effects on pore size distribution and mechanical strength of ACH monoliths. The ACH monoliths prepared from high carbonization temperatures exhibited lower values of the BET surface area and total pore volume and higher value of the mechanical strength than those of the ACH monoliths prepared from low carbonization temperatures. This was attributed to the effect of high temperature carbonization that results in the formation of relatively less defective structures. 相似文献
10.