Measurements of thermal-neutron capture cross-section of Cesium-135 by applying mass spectrometry

ABSTRACT

The thermal-neutron capture cross-section (σ₀) and resonance integral (I₀) were measured for the ¹³⁵Cs(n,γ)¹³⁶Cs reaction by an activation method and mass spectrometry. Because of difficulty in the preparation of pure ¹³⁵Cs samples, we used ¹³⁵Cs contained as an impurity in a normally available ¹³⁷Cs standard solution. An isotope ratio of ¹³⁵Cs and ¹³⁷Cs in a standard ¹³⁷Cs solution was measured by mass spectrometry to quantify ¹³⁵Cs. Cesium-135 impurity along with the ¹³⁷Cs standard solution was irradiated at the hydraulic conveyer of the research reactor in the Institute for Integral Radiation and Nuclear Science, Kyoto University. Wires of Co/Al and Au/Al alloys were used as neutron monitors to measure thermal-neutron fluxes and epi-thermal Westcott’s indices at an irradiation position. A gadolinium filter was used to measure the σ₀, and a value of 0.133 eV was taken as the cut-off energy. Gamma-ray spectroscopy was used to measure induced activities of ¹³⁷Cs, ¹³⁶Cs and monitor wires. On the basis of Westcott’s convention, the σ₀ and I₀ values were derived as 8.57 ± 0.25 barn, and 45.3 ± 3.2 barn, respectively. The value of σ₀ obtained in the present study agreed within the limits of uncertainties with the past-reported value of 8.3 ± 0.3 barn.     

Fabrication of 0.24Pb(In1/2Nb1/2)O3-0.42Pb(Mg1/3Nb2/3)O3-0.34PbTiO3 transparent ceramics by conventional sintering technique

0.24Pb(In_1/2Nb_1/2)O₃-0.42Pb(Mg_1/3Nb_2/3)O₃-0.34PbTiO₃ transparent ceramics were fabricated by a conventional sintering technique. Through optimization of sintering conditions of calcination and sintering temperatures and time, the obtained ceramics showed high optical transmittance of 53% and 71% at light wavelengths of 1300 and 2000 nm, respectively. The ceramics showed a rhombohedral to tetragonal phase transition at ~120°C and a tetragonal to cubic phase transition at 222°C. These transition temperatures were higher than those of 0.67Pb(Mg_1/3Nb_2/3)-0.33PbTiO₃ ceramics. In addition, the ceramics had a ferroelectric hysteresis loop, a large piezoelectric constant d₃₃ of 407 pC/N, and a planar electromechanical coupling factor k_p of 52%. These results suggest that the transparent ceramics may be used as a temperature-stable, linear electro-optic material.     

Frequency of Upward Lightning Hits to Wind Turbines in Winter

In recent years, frequent damage to wind turbines by winter lightning has been reported in the region along the Sea of Japan. It is a serious finding that lightning hits concentrate on wind turbines in this region. The authors investigated the increase rate of the frequency of lightning hits on wind turbines due to wind turbine construction by using LLS (lightning location system) data. As a result, an experimental formula to estimate the increase rate of the frequency of lightning hits on wind turbines as a function of parameters related to the construction conditions, namely the height of wind turbines, the height above sea level, and the latitude, is proposed.     

Adsorption of amino acids by fullerenes and fullerene nanowhiskers

We have investigated the adsorption of some amino acids and an oligopeptide by fullerene (C₆₀) and fullerene nanowhiskers (FNWs). C₆₀ and FNWs hardly adsorbed amino acids. Most of the amino acids used have a hydrophobic side chain. Ala and Val, with an alkyl chain, were not adsorbed by the C₆₀ or FNWs. Trp, Phe and Pro, with a cyclic structure, were not adsorbed by them either. The aromatic group of C₆₀ did not interact with the side chain. The carboxyl or amino group, with the frame structure of an amino acid, has a positive or negative charge in solution. It is likely that the C₆₀ and FNWs would not prefer the charged carboxyl or amino group. Tri-Ala was adsorbed slightly by the C₆₀ and FNWs. The carboxyl or amino group is not close to the center of the methyl group of Tri-Ala. One of the methyl groups in Tri-Ala would interact with the aromatic structure of the C₆₀ and FNWs. We compared our results with the theoretical interaction of 20 bio-amino acids with C₆₀. The theoretical simulations showed the bonding distance between C₆₀ and an amino acid and the dissociation energy. The dissociation energy was shown to increase in the order, Val < Phe < Pro < Asp < Ala < Trp < Tyr < Arg < Leu. However, the simulation was not consistent with our experimental results. The adsorption of albumin (a protein) by C₆₀ showed the effect on the side chains of Try and Trp. The structure of albumin was changed a little by C₆₀. In our study Try and Tyr were hardly adsorbed by C₆₀ and FNWs. These amino acids did not show a different adsorption behavior compared with other amino acids. The adsorptive behavior of mono-amino acids might be different from that of polypeptides.     

Fabrication and piezoelectric properties of BaTiO3/BaTiO3-Bi(Mg1/2Ti1/2)O3-BiFeO3 composites

We fabricated xBaTiO₃ (BT)/(1-x)[BaTiO₃-Bi(Mg_1/2Ti_1/2)O₃-BiFeO₃] (BT-BMT-BF)?+?0.1?wt%MnCO₃ composites by spark plasma sintering and investigated the effect of BT content x, BT powder size, and BT-BMT-BF composition on piezoelectric properties. For xBT/(1-x)(0.3BT-0.1BMT-0.6BF) +?0.1?wt%MnCO₃ (x?=?0–0.75) composites with a 0.5-µm BT powder, the dielectric constant was increased with x, and the relative density was decreased at x?=?0.67 and 0.75, creating optimum BT content of x?=?0.50 with a piezoelectric constant d₃₃ of 107?pC/N. When a larger 1.5-µm BT powder was utilized for the composite with x?=?0.50, the d₃₃ value increased to 150?pC/N due to the grain size effect of the BT grains. To compensate for a compositional change from the optimum 0.3BT-0.1BMT-0.6BF due to partial diffusion between the BT and 0.3BT-0.1BMT-0.6BF grains, a 0.5BT/0.5(0.275BT-0.1BMT-0.625BF)?+?0.1?wt%MnCO₃ composite with the 1.5-µm BT powder was fabricated. We obtained an increased d₃₃ value of 166?pC/N. These results provided a useful composite design to enhance the piezoelectric properties.     

吴也凡的唯美天驹艺术

<正>吴也凡原创陶瓷艺术作品新加坡展选登——天驹系列No.5、No.6(55×112cm)景德镇陶瓷学院教授、景德镇中外陶瓷艺术协会艺术总监吴也凡博士(改革开放后厦门大学最早培养的几批博士之一)系晚清两房进士之后,1953年出身于名门艺术世家,自幼在当地名师指导下勤习书法与绘画,还受过良好的音乐教育。1966年开始的文化大革命摧残了一代人的梦想。1968年吴也凡通过亲友介绍在衡阳界牌的瓷厂学习画瓷,此后就一直与陶瓷美术有了不解之缘。文革动乱结束后,举国上下科技兴国,从1980     

Rapid Reconstitution of Biosynthetic Machinery for Fungal Metabolites in Aspergillus oryzae: Total Biosynthesis of Aflatrem

Reconstitution of the biosynthetic machinery for fungal secondary metabolites in Aspergillus oryzae provides an opportunity both for stepwise determination of the biosynthetic pathways and the total biosynthesis of fungal natural products. However, to maximize the utility of the reconstitution system, a simple and rapid strategy for the introduction of heterologous genes into A. oryzae is required. In this study, we demonstrated an effective method for introducing multiple genes involved in the biosynthesis of fungal metabolites by using the expression vectors pUARA2 and pUSA2, each of which contains two cloning sites. The successful introduction of all the aflatrem biosynthetic genes (seven genes in total) after two rounds of transformation enabled the total biosynthesis of aflatrem. This rapid reconstitution strategy will facilitate the functional analysis of the biosynthetic machinery of fungal metabolites.     

Colorless polyimides derived from 1S,2S,4R,5R-cyclohexanetetracarboxylic dianhydride,self-orientation behavior during solution casting,and their optoelectronic applications

A novel cycloaliphatic monomer for polyimides (PI), 1S,2S,4R,5R-cyclohexanetetracarboxylic dianhydride (H′-PMDA) is proposed in this work. H′-PMDA shows high polymerizability with various diamines in contrast to its isomer, i.e., conventional hydrogenated pyromellitic dianhydride (H-PMDA) and leads to highly flexible and colorless PI films with very high T_g's. In particular, the combinations with rigid structures of diamines give rise to PIs with significantly decreased coefficients of thermal expansion (CTE) owing to high extents of in-plane chain orientation induced by thermal imidization, whereas the H-PMDA-based counterparts do not. The decreased CTE reflects structural rigidity/linearity of the H′-PMDA-based diimide units as supported by liquid crystallinity observed in the corresponding model compound. Solution casting of a chemically imidized PI derived from H′-PMDA and 2,2′-bis(trifluoromethyl)benzidine (TFMB) results in a lower CTE than that of the thermally imidized counterpart, suggesting the presence of a self-orientation phenomenon during solvent evaporation. The mechanism is proposed in this work. H′-PMDA/TFMB and its copolymer systems can be useful as plastic substrates in image display devices and/or novel coating-type optical compensation films.     

Preparation of ultrafine polyurethane fiber web by laser‐electrospinning combined with air blowing

Thermoplastic polyurethane fiber webs were prepared using a laser‐heated electrospinning process combined with air blowing. The effect of spinning conditions such as air flow rate and air temperature on fiber diameter and molecular weight was investigated. Although the average fiber diameter decreased with increased air flow rate at each air temperature, the diameter increased when the air flow rate was >15 NL min^?1. In addition, the fiber was comparatively thicker with an increase in the air temperature. The variation in the fiber diameter tends to increase with the air flow rate, and a reduction in the molecular weight of the fiber by thermal degradation was suppressed. The thinnest and most uniform fiber with a diameter of 0.9 µm and a diameter coefficient variation of 15% was obtained at an air temperature of 25°C under an air flow rate of 15 NL min^?1. This fiber also had a minimum of decreased molecular weight. POLYM. ENG. SCI., 54:2605–2609, 2014. © 2013 Society of Plastics Engineers     

Impact of Dynamic Interlayer Interactions on Thermal Conductivity of Ca3Co4O9

The phonon thermal conductivity of misfit-layered Ca₃Co₄O₉ has been calculated by perturbed molecular dynamics using a classical force field. Detailed numerical analyses reveal that, in spite of its smaller cross-sectional area, the CoO₂ layer transports more heat than the thicker rock salt (RS) layer, although its local thermal conduction is more suppressed than in another layered cobaltite, Na _x CoO₂. The origins of these differences have been elucidated through careful examination of the atomic arrangements in each layer. Since thermal conduction in the RS layer can be reduced without deteriorating electronic properties for which the CoO₂ layer is responsible, it is suggested that the RS layer should be modified to further suppress the overall in-plane thermal conductivity. Computational experiments with increasing number of Ca–O planes in the RS layer showed the opposite trend to what can be predicted based on the misfit between two dissimilar layers. Further analyses to reveal the origin of these unexpected results provide yet another strategy to further decrease the thermal conductivity, namely to control the dynamic interference between atoms across the interface between two layers.