Synthesis,characterization and charge transport properties of Pr–Ni Co-doped SrFe2O4 spinel for high frequency devices applications

Ferrites are materials of interest due to their broad applications in high technological devices and a lot of research has been focused to synthesize new ferrites. In this regard, an effort has been devoted to synthesize spinel Pr–Ni co-substituted strontium ferrites with a nominal formula of Sr_1-xPr_xFe_2-yNi_yO₄ (0.0 ≤ x ≤ 0.1, 0.0 ≤ y ≤ 1.0). The cubic structure of pure and Pr–Ni co-substituted strontium ferrite samples calcinated at 1073 K for 3 h has been confirmed through X-ray diffraction (XRD). Average sizes of crystallites (18–25 nm) have been estimated from XRD analysis and nanometer particle sizes of synthesized ferrites have been further verified by scanning electron microscopy (SEM). SEM results have also shown that particles are mostly agglomerated and all the samples possess porosity. It has been observed that at 298 K, the values of resistivity (ρ) increase, while that of AC conductivity, dielectric loss, and dielectric constants decrease with increasing amounts of Pr³⁺ and Ni²⁺ ions. The values of dielectric parameters initially decrease with frequency and later become constant and can be explained on the basis of dielectric polarization. Electrochemical impedance spectroscopy (EIS) studies show that the charge transport phenomenon in ferrite materials is mainly controlled via grain boundaries. Overall, synthesized ferrite materials own enhanced resistivity values in the range of 1.38 × 10⁹–1.94 × 10⁹ Ω cm and minimum dielectric losses, which makes them suitable candidates for high frequency devices applications.     

Elliptical slot based polarization insensitive compact and flexible chipless RFID tag

A miniaturized, polarization insensitive, and fully passive chipless radio frequency identification tag is proposed in this research article. The realized tag is based on slotted elliptical structures in a nested loop fashion with identical lengths and widths of slot resonators. Alteration of data sequence is accomplished by addition and elimination of nested resonators in the geometric structure. The tag is capable to encode 10 bits of data and covers spectral range from 3.6 to 15.6 GHz. The formulated structure demonstrates polarization insensitive characteristic. The data encoding structure is analyzed and optimized for different substrates that are, Rogers RT/duroid/5880, Rogers RT/duroid/5870, and Taconic TLX‐0 over the miniaturized footprint of 22.8 × 16 mm². The presented tag is robust, novel, compact, and flexible exhibiting a stable response to impinging electromagnetic waves at various angles of incidence.     

Pollen morphological investigations of family Cactaceae and its taxonomic implication by light microscopy and scanning electron microscopy

The family Cactaceae is the diversified group of angiosperm plants whose pollen statistics has been used for taxonomic identification. In this article, we present the pollen morphology of eight species belong to seven taxonomically complex genera of Cactaceae including Astrophytum, Cylindropuntia, Echinocereus, Echinopsis, Mammillaria, Opuntia, and Thelocactus using light and scanning electron microscopy. The pollen grains were acetolyzed, measured, described, and electron photomicrographs were taken. Cactaceae can be characterized by presenting different palynomorphological features including pollen type, sculpturing, polar and equatorial diameter, aperture orientation, exine thickness, P/E ratio, and echini features. Four types of pollen shapes, that is, prolate spheroidal (three species), subprolate (two species), prolate (two species), and oblate spheroidal in Echinocereus reichenbachii were observed. The polar and equatorial diameter observed maximum in O. ficus indica 116.95 and 112.27 μm while minimum in M. compressa 38.42 and 21.05 μm. Pollen of two types, tricolpate in members of subfamily Cactioideae and pantoporate in the Opuntioideae were examined. The fertility percentage has been observed maximum in Opuntia macrocentra (83.84%) and minimum in Opuntia ficus‐indica (57.89%). Exine sculpturing showing great variations such as granulate, reticulate, granulate perforate and micro‐echinate foveolate ornamentation was examined only in Echinopsis eyriesii. A key to species, based on pollen micromorphological attributes, has been constructed for correct identification of complex cactus species.     

A Review on Polymeric Nanocomposites of Nanodiamond,Carbon Nanotube,and Nanobifiller: Structure,Preparation and Properties

In this review, an overview of various types of nanofillers is presented with special emphasis on structure, synthesis and properties of carbon nanotube, nanodiamond, and nanobifiller of carbon nanotube/nanodiamond, carbon nanotube/graphene oxide and carbon nanotube/graphene. In addition, polymer/carbon nanotube, polymer/nanodiamond, and polymer/nanobifiller composites have been discussed. The efficacy of different fabrication techniques for nanocomposites (solution casting, in-situ, and melt blending method) and their properties were also discussed in detail. Finally, we have summarized the challenges and future prospects of polymer nanocomposites reinforced with carbon nanofillers hoping to facilitate progress in the emerging area of nanobifiller technology.     

Synthesis of Ion Imprinted Polymers by Copolymerization of Zn(II) and Al(III)8-hydroxy Quinolone Complexes with Divinylbenzene and Methacryclic Acid

In this research work, Zinc(II) and Aluminum(III)-IIP's were synthesized by optimizing the amount of methacrylic acid as monomer, divinylbenzene as cross-linker. The IIP's were functionalized with 8-hydroxy quinolone complexes of the two metal ions under thermal conditions by copolymerization with monomer and cross-linker. The IIP's and Non-IIP's were characterized using FT-IR, TGA, and SEM analysis. A quite remarkable difference in the size was observed of the polymers (Zn(II) 1.0 µm and Al(III) 0.1 µm). A stronger affinity was observed with IIP in comparison with Non-IIP at pH 3.1 and 4.5 for Zn(II) and Al(III) ions on their respective polymers.     

Sequency Domain Signal Processing Using Complex Hadamard Transform

Signal processing can be performed in time domain as well as intransform domain. Frequency domain is perhaps the most widely used domain for transform domain signal processing. In this paper we analyze sequency domain (SD) signal processing as an alternate to the conventional frequency domain signal processing. We perform signal processing in sequency domain using conjugate-symmetric sequency-ordered complex Hadamard transform and compare the results with those of discrete Fourier transform. We observe that in comparison with frequency spectrum, spectral energy of sequency spectrum is spread over the entire spectrum. We performed signal and image denoising in SD and found that our designed SD filters effectively denoise the signals.     

Self-esteem stability and depressive symptoms in acute stroke rehabilitation: Methodological and conceptual expansion.

Objectives: Explore the relationship of self-esteem level, self-esteem stability, and other moderating variables with depressive symptoms in acute stroke rehabilitation. Measures: One hundred twenty participants completed measures of state self-esteem, perceived recovery, hospitalization-based hassles, impairment-related distress, and tendency to overgeneralize negative self-connotations of bad events. Self-report of depressive symptoms was collected at admission and on discharge. Four regression analyses explored the relationship of self-esteem level and stability and each of 4 moderating variables (perceived recovery, hassles, impairment-related distress, and overgeneralization) with depressive symptoms at discharge. Results: Analyses indicated significant 3-way interactions in the 4 regression models. In general, individuals with unstable high self-esteem endorsed greater depressive symptoms under conditions of vulnerability (e.g., lower perceived recovery) than did individuals with stable high self-esteem. Under conditions of vulnerability, participants with stable low self-esteem indicated the highest levels of depressive symptoms. Implications: Self-esteem level and stability interact with psychological, environmental, and stroke-specific variables to predict depressive symptoms at discharge from stroke rehabilitation. This suggests the viability of self-esteem stability in exploring depressive symptoms in this setting and the complexity of emotional adjustment early after stroke. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

In-vitro antioxidant and antibacterial activities of pumpkin,quince, muskmelon and bottle gourd seeds

Ethanol and chloroform extracts of pumpkin, quince, muskmelon, and bottle gourd seeds were studied for in-vitro antioxidant and antibacterial activities. Crude protein and fat contents of all the seeds compared favorably with high protein legumes and high oil containing oilseeds. Ethanol and chloroform extracts of bottle gourd seeds had highest phenolic content. A direct positive relationship between antioxidant activities and extract concentration was observed with the relationship being more pronounced in chloroform extract of quince seeds (R²?=?0.9685 and 0.9829) followed by ethanol extract of pumpkin seeds (R²?=?0.9666 and 0.9685) as per 1,1-diphenyl-2-picrylhydrazyl and hydrogen peroxide (H₂O₂) method, respectively. Seed extracts were also studied for in-vitro antibacterial activity against Salmonella typhii, Enterococcus sp., Escherichia coli, Bacillus subtilis and Staphylococcus aureus. Ethanol extract of pumpkin seeds inhibited the growth of all bacteria; however, both the extracts of quince seeds did not show any activity against S. typhii, E. coli and S. aureus.     

Progress on Epoxy/Polyamide and Inorganic Nanofiller-Based Hybrids: Introduction,Application, and Future Potential

An efficient method to obtain better properties of epoxy-based nanocomposites is to introduce thermoplastic polymer such as polyamide into thermosetting resin. Combined effect of both polymers provides extra-bonding sites for nanofiller dispersion. This review mainly covers inorganic nanofiller dispersed epoxy/polyamide nanocomposite and their applications. To understand interaction between thermoset epoxy and thermoplastic polyamide, knowledge of structure, synthesis, and categorization is worth important. Addition of inorganic nanofiller such as layered silicate and metal oxide results in enhanced thermomechanical, physiochemical, and anticorrosive properties of resultant nanocomposite. These nanocomposites have applications as protective coatings, adhesives, insulators in electrical devices, and in aerospace industries.