Effect of Density and Processing Conditions on Oxide Transformations and Mechanical Properties in Cr–Mo-Alloyed PM steels

To improve the mechanical properties and performances of water-atomized powder metallurgy steels, it is necessary to enhance the density. Consolidating water-atomized steel powders via conventional pressing and sintering to a relative density level > 95 pct involves processing challenges. Consolidation of gas-atomized powders to full density by hot isostatic pressing (HIP) is an established process route but utilizing water-atomized powders in HIP involves challenges that result in the formation of prior particle boundaries due to higher oxygen content. In this study, the effect of density and processing conditions on the oxide transformations and mechanical properties from conventional press and sintering, and HIP are evaluated. Hence, water-atomized Cr–Mo-alloyed powder is used and consolidated into different density levels between 6.8 and 7.3 g cm⁻³ by conventional die pressing and sintering. Fully dense material produced through HIP is evaluated not only of mechanical properties but also for microstructural and fractographic analysis. An empirical model based on power law is fitted to the sintered material properties to estimate and predict the properties up to full density at different sintering conditions. A model describing the mechanism of oxide transformation during sintering and HIP is proposed. The challenges when it comes to the HIP of water-atomized powder are addressed and the requirements for successful HIP processing are discussed.

     

Effect of process parameters on surface oxides on chromium-alloyed steel powder during sintering

The use of chromium in the PM steel industry today puts high demands on the choice and control of the atmosphere during the sintering process due to its high affinity to oxygen. Particular attention is required in order to control the surface chemistry of the powder which in turn is the key factor for the successful sintering and production of PM parts. Different atmosphere compositions, heating rates and green densities were employed while performing sintering trials on water atomized steel powder pre-alloyed with 3 wt.% Cr in order to evaluate the effect on surface chemical reactions. Fracture surfaces of sintered samples were examined using high resolution scanning electron microscopy combined with X-ray microanalysis. The investigation was complemented with thermogravimetric (TG) studies. Reaction products in particulate form containing strong-oxide forming elements such as Cr, Si and Mn were formed during sintering for all conditions. Processing in vacuum results in intensive inter-particle neck development during the heating stage and consequently in the excessive enclosure of surface oxide which is reflected in less good final mechanical properties. Enhanced oxide reduction was observed in samples processed in hydrogen-containing atmospheres independent of the actual content in the range of 3–10 vol.%. An optimum heating rate was required for balancing reduction/oxidation processes. A simple model for the enclosure and growth of oxide inclusions during the sinter-neck development is proposed. The obtained results show that significant reduction of the oxygen content can be achieved by adjusting the atmosphere purity/composition.