Zero-Sequence Voltage-based Method for Determination and Classification of Unloaded Overhead Line Operating Conditions at the Moment of Energization

Overhead line energization can be performed under normal or faulty conditions. The latter indicates an occurrence of a fault along the line that exists at the moment of energization. This can lead to significant over-voltages that could endanger proper line operation. The issue gets more complex to protective devices when it comes to high-resistance faults, which impair the ability of relays to react promptly and accurately. Consequently, installation of additional detection devices becomes necessary. This paper proposes a novel method that properly detects and classifies line operating conditions at the moment of energization. The method is designed to be useful for utilities and it can be considered as a low-cost, fast, and accurate detection and classification approach, suitable for dealing with both low-resistance and high-resistance faults. Through comprehensive mathematical modeling it was found that both normal and faulty conditions during line energization are accompanied by the zero-sequence voltages of specific characteristics. The differences between zero voltage sequences are reflected in harmonic content, magnitudes of dominant frequencies, and their phase angles in regard to supply voltage. These findings are taken as the method's detection and classification criteria. The validity of the proposed model is verified by simulations and by field measurements.     

Automated quantized inference for probabilistic programs with AQUA

Innovations in Systems and Software Engineering - We present AQUA, a new probabilistic inference algorithm that operates on probabilistic programs with continuous posterior distributions. AQUA...     

半桥级联型三相多电平逆变器及其控制

把传统级联型三相多电平逆变器的H全桥单元,改为半桥单元,可减少一半的功率器件数和两个主电源。分别分析了倍压、等压电源供电情况下的SPWM调制控制方法,以及调制结果。利用等能量和等电量方法,解出电源功率分配比和倒灌功率比。倍压电源供电逆变的倒灌功率,可通过增大电源电容量和PWM软件算法,使倒灌功率的影响减至很小。等压电源供电逆变,利用循环脉冲控制,可使除公用电源外的级联电源功率达到均衡。     

地面塌陷因素重要度分析

通过收集大量文献,总结已有的研究工作,将地面塌陷因素概括为水、采矿、工程活动、地质四个方面,简述各因素的作用机理,建立相应的评价体系,在此基础上通过收集已有塌陷事故,运用数理统计方法及极差与方差分析,相互验证得出塌陷因素的重要性排序,对塌陷面积影响显著的因素为工程活动,水与地质的交互影响。     

一种改进的深亚微米MOSFET噪声模型

提出一种基于小信号的噪声模型,在精确提取0.13 μm MOSFET的小信号参数后,结合Pospieszalsik和pucel模型,运用噪声相关矩阵转换技术提取出所有噪声参数。利用ADS建立噪声模型,在2～20 GHz频率范围内,仿真结果与测量结果吻合良好,验证了模型的准确性。     

Synthesis and characterization of monetite and hydroxyapatite whiskers obtained by a hydrothermal method

High temperature hydrothermal syntheses, using calcium nitrate tetrahydrate, sodium dihydrogen phosphate and urea as precursors, and characterization of hydroxyapatite (HAp) whiskers are reported herein. The morphology and chemical composition of the crystals from a monetite to a hydroxyapatite phase were controlled by varying the starting concentrations of the precursors and the solution pH through the amount of urea that is decomposed during heating. X-ray diffraction (XRD) analysis, infrared spectroscopy (IR), scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDX), transmission electron microscopy (TEM) and high-resolution TEM (HRTEM) were used to investigate the products of the syntheses in order to find the optimum reaction conditions for obtaining the desired morphology and phase composition. Different morphologies ranging from single crystals of monetite through rods and plates of hydroxyapatite with different size distribution to whisker-like single hydroxyapatite crystal were achieved by simply varying the starting concentration of urea. Structural refinement of the hydroxyapatite whiskers confirmed a strong preferential orientation along the c-axis direction of the hexagonal crystal structure, which was significantly different from the usually observed random crystal orientation. TEM and SEM analysis of the apatite whiskers confirmed single crystal structure with the a c-axis orientation parallel to the long axis of the whiskers, with sizes up to 150 μm in length, 10 μm in width and with a thickness of about 300 nm, that grew from the same centre of nucleation, forming flaky-like particles.     

Status and research programs of the multinuclide accelerator mass spectrometry system at the University of Tsukuba

We present the current status and research programs of a multinuclide accelerator mass spectrometry (AMS) system on the 12UD Pelletron tandem accelerator at the University of Tsukuba (Tsukuba AMS system), Japan. A maximum terminal voltage of 12 MV is available for the AMS system. The Tsukuba AMS system can measure environmental levels of long-lived radioisotopes of ¹⁴C, ²⁶Al, ³⁶Cl and ¹²⁹I by employing a molecular pilot beam. Recently, enhancements in AMS techniques and equipment, including sample preparation, the ion source and the data acquisition system, have improved the performance of ³⁶Cl-AMS. The standard deviation of fluctuations is typically ±2%, and the machine background level for the ³⁶Cl/Cl ratio is lower than 1 × 10^?15 with a halite sample. We have measured over 500 samples in 1 year, including samples for earth and environmental sciences and nuclear safety research.     

Nanoparticle formation in H2O/N2 and H2O/Ar mixtures under irradiation by 20 MeV protons and positive corona discharge

To investigate the contribution of ions to gas nucleation, we have performed experiments on the formation of water droplets in H₂O/N₂ and H₂O/Ar gas mixtures by irradiation with a 20 MeV proton beam and by positive corona discharge. The size of the formed nanoparticles was measured using a differential mobility analyzer equipped with a Faraday cup electrometer. Using the proton beam, droplets around 10 nm in diameter were observed for both positively and negatively charged particles, but none were found when the corona discharge was used. This implies the importance of the presence of both positive and negative ions for the formation of nanosize droplets, which attract each other by Coulomb interactions, enhancing the collision frequency and leading to the formation of the 10 nm droplets.     

增强现实辅助维修技术研究进展

增强现实技术应用于复杂装备维修,可增加维修保障工作信息量与对复杂维修任 务及维修过程的理解能力,提高维修保障效率。在分析当前典型增强现实原型系统基础上,研 究了增强现实技术在复杂装备维修保障中应用的可行性,提出了增强现实装备维修中关键技术 的解决途径,并对增强现实技术的发展趋势进行了展望。     

酶法动态动力学拆分制备R-(-)-乙酰基邻氯扁桃酸

采用假单胞菌脂肪酶Pseudomonas sp. ECU1011催化乙酰基邻氯扁桃酸进行不对称水解,利用突变后的扁桃酸消旋酶(V29I)对拆分后的产物S-(-)-邻氯扁桃酸进行消旋,消旋后的邻氯扁桃酸经过酰化重新被利用到水解反应中,实现了酶法动态动力学拆分制备R-(-)-乙酰基邻氯扁桃酸。通过对拆分反应、拆分混合物的分离回收以及消旋反应的工艺优化,最终获得光学纯度ee>99.9%的R-(-)-乙酰基邻氯扁桃酸,其收率达80%。本研究建立的R-(-)-乙酰基邻氯扁桃酸的动态动力学拆分工艺,对其工业化应用具有重要的指导意义。