Soil salinity of urban turf areas irrigated with saline water: I. Spatial variability

With increasing use of saline water for irrigating urban landscapes, soil salinization is becoming a concern. This study examined spatial variation in soil salinity over the length of selected fairways at five golf courses, and of large turf areas at two public parks located in west Texas and southern New Mexico. Salinity of water used for irrigation ranged from 680 to 2700 mg L⁻¹, and the sites consisted mostly of Aridisols (upland soils) or Entisols (alluvial soils). Soil salinity distribution at sites consisting of deep Aridisols was spatially independent with the coefficient of variability (CV) ranging from 24 to 42%. The sites consisting of shallow Aridisols over a calcic horizon had erratic and random soil salinity distributions with an average CV of 37%. Since soil salinity distributions in Aridisols and Alfisols appeared to be spatially independent within the distance of fairways, soil sampling adequacy can be determined by the conventional probability statistics. However, salinity distributions at Entisols sites were spatially dependant to a length of 100 m or more. In addition, the clayey Entisols used for public parks had high levels of salt accumulation (>10 dS m⁻¹ in the saturation extract) with the CV exceeding 60%. When salinity readings were stratified by soil type distribution, the CV was reduced to 28% on the average. The number of samples required to obtain the mean salinity over a typical length of fairways (250–300 m) within a deviate range of 20% averaged 6 in deep sandy Aridisols and Alfisols, and 13 each in other cases, provided that sampling of Entisols is made based on soil type distributions. These sampling requirements are greater than those for field soil moisture or saturation water contents. The spacing to collect the required number of samples over the prevailing length of fairways was between 23 and 38 m. Soil sampling for salinity appraisal is most problematic in Entisols, but can be made simple if a detailed soil map is available. In Aridisols containing a calcic horizon, it is probable to have saline spots over poorly permeable caliche.     

Surface Analysis of Cr2O3‐, CoO‐, and Al2O3‐Doped Iron–Phosphate Glasses at High Temperature

Surface structures of iron–phosphate glasses were examined using X‐ray photoelectron spectroscopy (XPS). Cr₂O₃, CoO, and Al₂O₃ were introduced to the glass by the replacement of a part of Fe₂O₃, and the simulated fission products are also added. The obtained glasses showed high chemical durabilities by MCC‐1 test. In situ high‐temperature and room‐temperature XPS measurements were conducted on the polished sample surfaces and also those after 1‐week chemical durability test. Unique trends were observed in XPS spectra on heating and after the chemical durability test, respectively. Nature of the glass surface of iron–phosphate glasses was explained from the point of view of surface energy, and the origin of high chemical durability and the effect of chromium ions were discussed based on the changes on surface composition and valence states of transition‐metal ions.     

Grain Refinement by Cyclic Displacive Forward/Reverse Transformation in Fe-High-Ni Alloys

A novel method for grain refinement of martensite structures was proposed, in which transformation strain is accumulated by cyclic displacive forward and reverse transformations. This method can refine martensite structures in an Fe-18Ni alloy because a high density of austenite dislocations is introduced by a displacive reverse transformation in addition to an inheritance of dislocations in body-centered cubic martensite into austenite during cyclic transformation. The addition of a small amount of carbon accelerates structure refinement significantly, which results in the formation of ultra-fine-grained structures after ten cycles.

     

Can food factors provide Us with the similar beneficial effects of physical exercise?

Metabolic diseases have got global health issues. Physical exercise as well as diet therapy is a potent strategy for fighting against the diseases. However, it is often difficult to continue to keep exercise regularly enough to take sufficient effect. Thus, good substitutes for the therapeutic exercise would be greatly beneficial. Recent studies have suggested that 5′AMP-activated protein kinase (AMPK) play important roles in the metabolic alterations by muscle contraction. The notion that AMPK mediates broad effects of physical exercise has been widely accepted, though it has been challenged by observations in some genetically AMPK-disrupted animals. We have demonstrated metabolome-wide significance of AMPK activation in contracting muscles. Thus, pharmacological activation of AMPK can be a promising way to obtain similar effects of the exercise. The relevance of AMPK will be introduced, and possible strategies for obtaining similar effects to the exercise from food factors will be discussed in the current review.     

Wind Force Coefficients for Designing Porous Canopy Roofs

Wind force coefficients for designing porous canopy roofs have been investigated based on a series of wind tunnel experiments. Gable, troughed and mono-sloped roofs were tested. The roof models were made of 0.5 mm thick perforated duralumin plates, the porosity of which was changed from 0 to about 0.4. Overall aerodynamic forces and moments acting on the roof model were measured in a turbulent boundary layer with a six-component force balance for various wind directions. The results indicate that the wind loads on canopy roofs generally decrease with an increase in porosity of the roof. Assuming that the roof is rigid and supported by the four corner columns with no walls, the axial forces induced in the columns are regarded as the most important load effect for discussing the design wind loads. Two loading patterns causing the maximum tension and compression in the columns are considered. Based on a combination of the lift and moment coefficients, the design wind force coefficients on the windward and leeward halves of the roof are presented for the two loading patterns as a function of the roof pitch and porosity. The effect of porosity is taken into account as a reduction factor of the wind loads.     

Rotary scanning wireless temperature measurement method for hyperthermia using ferromagnetic implants

Recently, the use of a ferromagnetic material in a soft‐heating method has garnered much attention as a novel method for cancer treatment. By concurrently using this material as a thermal probe, we are currently developing a minimally invasive heating and wireless temperature measurement system. To make the approach feasible in a clinical setting, it is vital to overcome the key challenge of heating the local tumor at a constant temperature. In previous conventional approaches, it was necessary to switch the induction‐heating power supply on/off after the target tumor temperature was reached. However, it cannot determine the temperature of the material during the power‐off period. Therefore, we changed this approach and found that by adjusting the distance between the heating coil and the material while maintaining a constant current flow in heating coil, the drift problem, which happened just after power is supplied during the on/off operation, did not occur any longer. Accordingly, it was not required to use multiple sensors to reduce the drift, thereby minimizing the cost. This study verifies the validity of our wireless thermometry approach while performing rotary scanning and proposes a technique for determining achievement of the target temperature. This knowledge complements other approaches for cancer treatment utilizing hyperthermia. © 2015 Institute of Electrical Engineers of Japan. Published by John Wiley & Sons, Inc.     

STD‐NMR‐Based Protein Engineering of the Unique Arylpropionate‐Racemase AMDase G74C

Structure‐guided protein engineering achieved a variant of the unique racemase AMDase G74C, with 40‐fold increased activity in the racemisation of several arylaliphatic carboxylic acids. Substrate binding during catalysis was investigated by saturation‐transfer‐difference NMR (STD‐NMR) spectroscopy. All atoms of the substrate showed interactions with the enzyme. STD‐NMR measurements revealed distinct nuclear Overhauser effects in experiments with and without molecular conversion. The spectroscopic analysis led to the identification of several amino acid residues whose substitutions increased the activity of G74C. Single amino acid exchanges increased the activity moderately; structure‐guided saturation mutagenesis yielded a quadruple mutant with a 40 times higher reaction rate. This study presents STD‐NMR as versatile tool for the analysis of enzyme–substrate interactions in catalytically competent systems and for the guidance of protein engineering.     

Cytokine-induced production of macrophage inflammatory protein-1alpha (MIP-1alpha) in cultured human astrocytes

The human cytotoxic T cell line TALL-104 displays potent anti-tumor effects in animals with spontaneous and induced malignancies. We investigated the biodistribution of TALL-104 cells in tumor bearing and healthy mice. 111In-labeled TALL-104 cells, injected intravenously, localized primarily in the lungs for the first 2 h, and redistributed to liver, spleen, and kidneys in the following 24 h both in immunodeficient and immunocompetent mice. TALL-104 cells consistently accumulated in the tumor and at sites of metastases. In animals injected with free 111In-oxine, most of the radioactivity remained in the blood pool with no significant organ accumulation. These data support the tumor homing properties of TALL-104 cells, information which is crucial to their therapeutic efficacy in forthcoming clinical trials.