Two placebo-controlled crossover studies in healthy subjects to evaluate gastric acid neutralization by an alginate–antacid formulation (Gaviscon Double Action)

Objective: To investigate the intragastric acid neutralization activity of a combined alginate-antacid formulation.

Significance: Published studies have investigated the reflux-suppressing alginate component of Gaviscon Double Action (Gaviscon DA; RB, UK) but intragastric acid neutralization activity of the antacid component has not been evaluated in vivo.

Methods: Intragastric pH monitoring, using a custom-made 10-electrode catheter, was evaluated in a two-part exploratory study in healthy subjects; Part I (n?=?6) tested suitability of the catheter using antacid tablets (Rennie; Bayer, Germany); Part II (n?=?12) evaluated gastric acid neutralization activity of Gaviscon DA liquid (20?ml) versus placebo in fasted subjects using a randomized, open-label, crossover design. The primary endpoint was the percentage of time that intragastric pH ≥4 was measured during 30?min post-treatment. A confirmatory study of identical design was subsequently conducted (n?=?20).

Results: Monitoring pH using the multielectrode catheter was a viable approach, directly detecting changes in intragastric pH following a single dose of antacid tablets. In the exploratory study, the percentage of time that pH ≥4 during 30?minutes post-treatment was 46.8% with Gaviscon DA liquid versus 4.7% with placebo (p?=?0.0004). These findings were supported by the confirmatory study, where pH ≥4 was recorded 50.8% of the time with Gaviscon DA versus 3.5% with placebo (p?=?0.0051). In this study, Gaviscon DA was safe and well tolerated.

Conclusions: These studies demonstrate the effective acid neutralizing capacity of Gaviscon DA versus placebo in healthy, fasted subjects. This adds to the evidence base for the combination of alginates and antacids.     

Solids transport models comparison and fine‐tuning for horizontal,low concentration flow in single‐phase carrier fluid

We determined and fine‐tuned the solids transport models appropriate for predicting the single‐phase carrier fluid velocity to transport solid particles in conduits for horizontal, low concentration flow. A database with 538 experimental data points was compiled. A literature review was performed to determine the data ranges, forces, and mechanisms used to develop 44 models, and their velocity predictions were compared against the database using statistics. Using the dimensionless forms of the models and the data, the model parameters were adjusted to improve their accuracy and identify the dominant forces. At low concentrations: for liquid/solid flow from a bed of solids and gas/solid flow from the bottom of pipelines, the particle weight, and inertial and viscous forces dominate; for gas/solid flow from a bed of solids, the particle weight, and inertial, viscous, and adhesive forces play a role; and gaps exist in the data for large‐diameter pipes and high‐density gases. © 2013 American Institute of Chemical Engineers AIChE J, 60: 76–122, 2014     

Theoretical aspects of the design of a passive radon dosemeter

Some mathematical aspects of the development and design of a passive radon dosemeter are considered. In particular, a mathematical model is presented that is concerned with the gaseous diffusion of radon into a confined region bounded by a plastic material of known diffusion coefficient. The relationship between the time-integrated radon concentrations, inside and outside a sealed plastic container are derived. Estimates of the exposure of people to radon can be made using the time integrated radon concentration inside a calibrated container containing a CR-39 etched-track device. As a consequence of the analysis, it is possible to design a passive radon dosemeter that will be accurate, resistant to moisture and whose response will be independent of rapid variations in radon concentration. The possibility of using a container of this type for the measurement of diffusion coefficients is discussed.     

Sustainable reduction in the flux of microbial compliance parameters from urban and arable land use to coastal bathing waters by a wetland ecosystem produced by a marine flood defence structure

'Natural' treatment systems such as wetlands and reed beds have been proposed as sustainable means of reducing fluxes of faecal indicator organisms (FIOs) to recreational and shellfish harvesting waters. This is because FIO fluxes to coastal waters from both point (effluent) and diffuse (catchment) sources can cause non-compliance with microbiological standards for bathing and shellfish harvesting waters. The Water Framework Directive requires competent authorities in the member states to manage both point and diffuse sources of FIOs in an integrated manner to achieve compliance with 'good' water quality as defined in a series of daughter Directives. This study was undertaken to investigate the relative sources of FIOs to the popular bathing waters around Clacton, UK. In this predominantly arable (mainly cereal cropping) farming area, the principal land use predictor, explaining 76% of the variance in geometric mean presumptive Escherichia coli concentration at sub-catchment outlets during the bathing season, was the proportion of built-up (i.e. urbanised) land in each sub-catchment. This new finding contrasts with earlier studies in livestock farming regions where the proportion of improved grassland has proven to be the strongest predictor of microbial concentration. Also novel in this investigation, a flood defence wall has been built creating a wetland area which discharges every tidal cycle. The wetland produces over 97% reduction in the flux and concentrations of FIOs to the marine recreational waters. Also, FIO concentrations in water draining through the wetland to the sea were similar to concentrations measured in six UK sewage treatment plant effluents subject to secondary (biological) treatment followed by UV disinfection.     

Faecal indicator organism concentrations and catchment export coefficients in the UK

Characterisation of faecal indicator organism (FIO) concentrations and export coefficients for catchments with particular combinations of land use and under specific climatic regimes is critical in developing models to predict daily loads and apportion sources of the microbial parameters used to regulate water quality. Accordingly, this paper presents a synthesis of FIO concentration and export coefficient data for the summer bathing season, with some comparative winter data, for 205 river/stream sampling points widely distributed across mainland UK. In terms of both geometric mean (GM) FIO concentrations and export coefficients (expressed as cfu km(-2) h(-1)), the results reveal (1) statistically significant elevations at high flow compared with base flow, with concentrations typically increasing by more than an order of magnitude and export coefficients by about two orders; (2) significantly higher values in summer than in winter under high-flow conditions; and (3) extremely wide variability between the catchments (e.g. four orders of magnitude range for GM faecal coliform concentrations), which closely reflects land use-with urban areas and improved pastures identified as key FIO sources. Generally, these two most polluting land uses are concentrated in lowland areas where runoff (m3 km(-2) h(-1)) is low compared with upland areas, which in the UK are dominated by rough grazing and forestry. Consequently, contrasts in export coefficients between land use types are less than for FIO concentrations. The GMs reported for most land use categories are based on 13 sites and exhibit quite narrow confidence intervals. They may therefore be applied with some confidence to other catchments in the UK and similar geographical regions elsewhere. Examples are presented to illustrate how the results can be used to estimate daily summer base- and high-flow FIO loads for catchments with different land use types, and to assess the likely effectiveness of certain strategies for reducing FIO pollutant loadings in areas with extensive areas of lowland improved pasture.     

Polarized wave electromagnetic shielding of anisotropic carbon nanomodifier‐based LLDPE composites

The polarized wave electromagnetic shielding (EM SE) of nanocomposites containing 10 vol% of carbon nanomodifiers in a semicrystalline matrix is reported. Heat‐treated carbon nanofibers, Pyrograf^® III PR‐19 heat treatment (HT) and multiwalled carbon nanotubes (MWNT) HT were dispersed in a linear low‐density polyethylene matrix to produce flow‐induced orientation of the nanomodifiers in the spun microfilaments. Consequently, the electrical conductivity of the resulting nanocomposites exhibited anisotropic behavior due to the nanomodifier orientation. The in‐plane conductivity in the longitudinal direction (PR‐19 HT comp.: ～0.02 S/m; MWNT HT comp.: ～3 S/m) was at least an order of magnitude higher than that along the transverse direction. As measured with a rectangular waveguide (WR510, 1.45–2.2 GHz), the PR‐19 HT‐ and MWNT HT‐oriented nanocomposites (1‐mm thick) displayed EM SE values of 0.7 dB and 3.0 dB, respectively, when the nanomodifiers were transversely oriented with the polarized electric field. In contrast, when the orientation of the nanomodifiers was parallel with the field, EM SE values of 3.2 and 9.0 dB were obtained, respectively. The higher EM SE values are consistent with high conductivities observed in the direction of preferred orientation of the modifiers. POLYM. ENG. SCI., 55:299–307, 2015. © 2014 Society of Plastics Engineers     

Decision‐making in multi‐agency groups at simulated major incident emergencies: In situ analysis of adherence to UK doctrine

When major incident emergencies occur in the UK (e.g., a terrorist attack), senior representatives convene from local emergency services, civil resource organizations, health agencies, and government. These groups make decisions that minimize the societal and economic impacts of major incidents. Their adherence to UK doctrine was assessed using video footage of 18 groups responding to a major incident in a simulation suite, and six groups responding to a large‐scale exercise. There were marked between‐group differences in the sequencing of decision‐making activities, and limited consideration of alternative courses of action. These results provide an impetus for future policy, guidance, and training to address (a) between‐group inconsistency in decision processes and (b) the lack of consideration of alternative courses of action.     

Continuously extruded micro‐textured polypropylene films

The continuous extrusion of micro‐textured isotactic polypropylene (i‐PP) film and its tribological properties are reported. As analyzed by scanning electron microscopy, a rectangular‐semicircular micro‐patterned die successfully produced extruded cast‐films with hill‐like micro‐texture. Such films displayed static and kinetic coefficients of friction (COF_s and COF_k) values of 0.247 ± 0.028 and 0.245 ± 0.003, respectively, for a steel fixture sliding along the micro‐texture of the film. The equivalent COF_s and COF_k values for non‐textured (NT) films were 0.369 ± 0.036 and 0.340 ± 0.024, respectively, confirming that textured films displayed a reduction in COF of about 30%. For textured and NT films sliding on textured films, the COF_k values were even lower at 0.161 ± 0.013 and 0.113 ± 0.004, which represents about 20–40% reduction as compared with that for the NT‐NT counterparts. Films coated with a silicone lubricant displayed COF_s and COF_k values of 0.334 ± 0.042 and 0.099 ± 0.012, respectively, for NT films sliding over lubricated NT films, and 0.426 ± 0.031 and 0.063 ± 0.006, respectively, for textured films sliding over lubricated textured films. The COF_k values for textured/non‐lubricated films approach those of NT/lubricated films, indicating that micro‐textured polypropylene films may be used in environmentally sensitive applications where lubricants and fluorinated additives may not be used for reducing friction. POLYM. ENG. SCI., 54:2147–2154, 2014. © 2013 Society of Plastics Engineers     

Temporal property verification as a program analysis task

We describe a reduction from temporal property verification to a program analysis problem. First we present a proof system that, unlike the standard formulation, is more amenable to reasoning about infinite-state systems: disjunction is treated by partitioning, rather than enumerating, the state space and temporal operators are characterized with special sets of states called frontiers. We then describe a transformation that, with the use of procedures and nondeterminism, enables off-the-shelf program analysis tools to naturally perform the reasoning necessary for proving temporal properties (e.g. backtracking, eventuality checking, tree counterexamples for branching-time properties, abstraction refinement, etc.). Using examples drawn from the PostgreSQL database server, Apache web server, and Windows OS kernel, we demonstrate the practical viability of our work.