锰锌铁氧体纳米粉体的液相制备及磁性能

以δ-FeOOH为前驱体,用氨水调节溶液的pH值,分别采用(1)90℃水浴加热动态转化、(2)沸腾回流动态转化,(3)90℃静态转化及(4)200℃水热法四种方法合成了锰锌铁氧体纳米粉体.采用X射线衍射仪(XRD),透射电子显微镜(TEM)、振动样品磁强计(VSM)和X射线荧光光谱仪(XRF)等方法对粉体进行了表征,对四种液相法制备的锰锌铁氧体纳米粉体的结构和性能等进行了对比和分析.结果表明,四种方法中沸腾回流相转化法得到的产物具有磁性能较好、形状较规则、粒径可控等优点.     

Prediction of the effects on dynamic response due to distributed structural modification with additional degrees of freedom

The aim of this study is to investigate means of efficiently assessing the effects of distributed structural modification on the dynamic properties of a complex structure. The dynamic properties of the modified structure can be determined by experimental testing or numerical simulation, both of which are complex, expensive and time-consuming. Assuming that the original dynamic characteristics are already established and that the modification is a relatively simple attachment, the modified dynamic properties may be determined numerically without solving the equations of motion of the full-modified structure. The frequency response functions (FRFs) of the modified structure can be computed by coupling the original FRFs and a delta dynamic stiffness matrix for the modification introduced. The validity of this approach is investigated by applying it to a cantilever beam to which a smaller beam is attached as modification. The original FRFs were obtained experimentally as well as numerically. The delta dynamic stiffness matrix was determined numerically by modeling the attachment and part of the original structure including the attachment points. The FRFs of the modified beam were then computed. Good agreement is obtained by comparing the results to the FRFs of the modified beam determined experimentally as well as by numerical modeling of the complete modified structure.     

马钢B高炉提高利用系数生产实践

以2020年下半年马钢B高炉实际生产为依据,分析高炉生产实践数据,总结出B高炉通过加强原燃料质量管理,探索合理的高炉上下部制度,强化操作管理等方式逐步提高了高炉利用系数。2020年四季度开始,高炉利用系数逐步上升,至2021年1季度,高炉产量(去除休风影响)稳定9000 t/d以上,利用系数达到2.25以上。     

Preparation and properties of nanosize MnZn ferrite from δ-FeOOH

Ferrous ion was transformed into feroxyhyte (δ-FeOOH) by oxidation. Then, manganese sulfate and zinc sulfate in some ratio were added to the feroxyhyte solution. The co-precipitation was boiling reflux conditions sometime under constant stirring. The nanosize MnZn ferrite powder was formed. The mechanism of preparation of the nanosize MnZn ferrite was discussed, and the formation of feroxyhyte which was playing a key role during the process was mentioned. The properties of powder was tested by means of X-ray diffraction, transmission electron microscopy and vibrating sample magnetometer. The results show that the samples of spherical particles about 20 nm, which have characteristics of ferrimagnetism, has larger saturation magnetization, but the remanent magnetization and coercivity are comparatively smaller. The spinel MnZn ferrite nanosize powder was successfully prepared from δ-FeOOH at low temperature, with low-carbon steel and peroxide as main material.     

硫酸工业中常见气体有效能计算

介绍理想气体、理想气体混合物、真实气体、真实气体混合物的有效能计算方法，并以硫酸工业中常见气体为例加以说明。通过编写计算机程序进行计算，可实现有效能的快速分析，便于实际应用。     

仓式静态连续好氧堆肥发酵工艺的水气研究

采用仓式静态连续好氧堆肥发酵工艺,通过建立水平衡体系,系统地研究了水分对整个发酵工艺的影响,得出了仓式静态连续好氧堆肥发酵具有工艺简便,热交换快,水气蒸发量大等特点;好氧堆肥发酵过程中发酵温度保持在65℃左右,含水量控制在45%～55%有利于有机物降解,垃圾堆肥可在40～50d腐熟;静态连续好氧一次堆肥发酵物料的含水量需控制在35%以下,机械自动分选(类)筛分效率高,筛分率在90%～95%,垃圾减容在50%～60%.二次堆肥发酵物料的含水量需控制在25%～30%,机械除杂(碎石、碎玻璃等)效果好,有机肥中杂质含量低于0.8%.静态好氧二次堆肥发酵可以用垃圾渗沥水补充水分,达到资源循环再利用,可实现污水零排放.     

基于多特征融合的运动物体识别方法研究

为了实现运动目标的实时检测,本文基于多特征融合,提出了一种运动物体分级识别方法.首先通过对运动目标的分割,分析得到各个物体的形状矩特征、面积大小及运动速度.对上述特征,采用支持向量机方法对其矩特征进行快速的一级分类,然后对一级分类结果及各物体的面积、速度等信源根据其对分类的重要程度,采用模糊积分技术进行多特征融合分类.实验表明,本方法具有较强的学习能力及较高的识别精度,可有效地应用于道路监控等系统.     

彩钢岩棉夹芯屋面板、墙面板节点性能研究

为了掌握彩钢岩棉夹芯屋面板、墙面板与檩条的螺钉连接节点抗拉破坏机理,采用理论分析、试验验证及有限元模拟相结合的方法研究了不同钢板厚度及芯材厚度时节点破坏情况.分析结果表明:屋面板节点连接破坏是由于钢板局部屈曲引起的,墙面板则是钢板被冲剪破坏造成的,同时,结合对有限元模拟结果的回归,提出了节点承载力设计公式,可为以后节点设计提供参考.增加岩棉刚度及其与侧向钢板的粘结,或增加钢板厚度对提高屋面板节点极限承载力起着重要作用.     

PCNN模型在彩色图像分割中的应用

针对脉冲耦合神经网络(PCNN)模型主要应用于灰度图像处理的局限性,利用脉冲发生器将颜色信息引入模型作为输入,与灰度信息共同控制神经元的内部行为,控制等灰度值的不同颜色区域分期点火,实现彩色图像的精确分割.双输入PCNN模型实现了彩色图像的分割,同时保持了PCNN模型对噪声的鲁棒性,从简单的仿真图像和实际图像两方面验证了此分割方法的有效性.