首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   96636篇
  免费   10935篇
  国内免费   7191篇
电工技术   8640篇
技术理论   3篇
综合类   10020篇
化学工业   13131篇
金属工艺   6007篇
机械仪表   6844篇
建筑科学   7843篇
矿业工程   2681篇
能源动力   2862篇
轻工业   8750篇
水利工程   2628篇
石油天然气   3721篇
武器工业   1201篇
无线电   11453篇
一般工业技术   9779篇
冶金工业   3278篇
原子能技术   1476篇
自动化技术   14445篇
  2024年   513篇
  2023年   1548篇
  2022年   3393篇
  2021年   4583篇
  2020年   3351篇
  2019年   2506篇
  2018年   2622篇
  2017年   2938篇
  2016年   2717篇
  2015年   4143篇
  2014年   5169篇
  2013年   6204篇
  2012年   7610篇
  2011年   8003篇
  2010年   7315篇
  2009年   7150篇
  2008年   7220篇
  2007年   6874篇
  2006年   6165篇
  2005年   5001篇
  2004年   3671篇
  2003年   2830篇
  2002年   3162篇
  2001年   2921篇
  2000年   2249篇
  1999年   1290篇
  1998年   715篇
  1997年   615篇
  1996年   475篇
  1995年   385篇
  1994年   296篇
  1993年   221篇
  1992年   212篇
  1991年   153篇
  1990年   112篇
  1989年   107篇
  1988年   82篇
  1987年   59篇
  1986年   26篇
  1985年   27篇
  1984年   28篇
  1983年   14篇
  1982年   18篇
  1981年   16篇
  1980年   20篇
  1979年   11篇
  1976年   1篇
  1974年   1篇
  1959年   11篇
  1951年   9篇
排序方式: 共有10000条查询结果,搜索用时 15 毫秒
1.
2.
采用直流磁控溅射和后退火氧化工艺在p型GaAs单晶衬底上成功制备了n-VO_2/pGaAs异质结,研究了不同退火温度和退火时间对VO_2/GaAs异质结性能的影响,并分析其结晶取向、化学组分、膜层质量以及光电特性。结果表明,在退火时间2 h和退火温度693 K下能得到相变性能最佳的VO_2薄膜,相变前后电阻变化约2个数量级。VO_2/GaAs异质结在308 K、318 K和328 K温度下具有较好的整流特性,对应温度下的阈值跳变电压分别为6.9 V、6.6 V和6.2 V,该结果为基于VO_2相变特性的异质结光电器件的设计与应用提供了可行性。  相似文献   
3.
边坡位移的时间序列曲线存在复杂的非线性特性,传统的预测模型精度不足以满足预测要求。为此提出了基于变分模态分解的鸟群优化-核极限学习机的预测模型,并用于河北省某水泥厂的边坡位移预测。该方法首先采用VMD把边坡位移序列分解为一系列的有限带宽的子序列,再对各子序列分别采用相空间重构并用核极限学习机预测,采用鸟群算法优化相空间重构的嵌入维度和KELM中惩罚系数和核参数三个数值,以取得最优预测模型。最后将各个子序列预测值叠加,得到边坡位移的最终预测值。结果表明:和KELM、BSA-KELM、EEMD-BSA-KELM模型相比,基于VMD的BSA-KELM预测精度更高,为边坡位移的预测提供一种有效的方法。  相似文献   
4.
Food Science and Biotechnology - Various hilling materials (rice hulls, pine sawdust, and perlite) were compared to produce sprout vegetables using beach silvertop (Glehnia littoralis Fr. Schm. ex...  相似文献   
5.
瞿中  谢钇 《计算机科学》2021,48(4):187-191
针对现有的混凝土裂缝检测算法在各种复杂环境中检测精度不够、鲁棒性不强的问题,根据深度学习理论和U-net模型,提出一种全U型网络的裂缝检测算法。首先,依照原U-net模型路线构建网络;然后,在每个池化层后都进行一次上采样,恢复其在池化层之前的特征图规格,并将其与池化之前的卷积层进行融合,将融合之后的特征图作为新的融合层与原U-net网络上采样之后的网络层进行融合;最后,为了验证算法的有效性,在测试集中进行实验。结果表明,所提算法的平均精确率可达到83.48%,召回率为85.08%,F1为84.11%,相较于原U-net分别提升了1.48%,4.68%和3.29%,在复杂环境中也能提取完整裂缝,保证了裂缝检测的鲁棒性。  相似文献   
6.
In this article, we present the optical design of a novel diagnostic on the HL-2 A tokamak, i.e. the20-channel edge Lyman-alpha beam emission spectroscopy, which is a promising solution for edge density turbulence research on tokamaks, as it offers the possibility of density fluctuation measurement with a 3.3 mm spatial resolution while maintains a high temporal resolution of1 μs. The optical path, including the reflective collection optics, the high-dispersion spectrometer, and the linear detector array, is carefully optimized to obtain a good image quality and a high throughput. The maximum root mean square radius of the collection optics is 64 μm.The detected photon flux is estimated to be about 10~(11) photons/s/channel.  相似文献   
7.
为研究金针菇多糖(polysaccharide from Flammulina velutipes,FVP)对微冻大黄鱼及鱼片在贮藏期间肌原纤维蛋白性质的变化及水分分布的影响,实验分别选用0.03、0.06、0.09 g/L FVP浸渍处理大黄鱼和鱼片,以无菌水处理为对照组,分析微冻贮藏期间样品的感官指标得分、总挥发性盐基氮含量、总巯基含量、Ca2+-ATPase活性、蛋白流变学性质以及水分迁移变化规律。结果表明:FVP可有效抑制整鱼总挥发性盐基氮含量上升和感官得分的下降;减缓整鱼及鱼片在微冻过程中总巯基含量、Ca2+-ATPase活性下降和水分流失;此外FVP还能够延缓大黄鱼因腐败而出现的蛋白凝胶能力减弱。在本实验选取的多糖浓度范围内,0.09 g/L FVP处理组保鲜效果较强。该研究结果可为FVP用于水产品贮运保鲜提供理论参考。  相似文献   
8.
The in situ axial X-ray diffraction patterns of four ceramic powder samples (MgO, Al2O3, AlN, and cBN) that were compressed in a diamond anvil cell under uniaxial non-hydrostatic conditions were recorded. The microscopic deviatoric stress as a function of the pressure was determined from the X-ray diffraction peak broadening analysis: the curves increased approximately linearly with the pressure at the initial compression stage and then levelled off under further compression. Pressure-induced transparency was observed in all of the samples under compression, and the pressure at the turning point on the curves of the microscopic deviatoric stress versus pressure corresponded to the pressure at which the samples became transparent. Analysis of the microstructural features of the pressure-induced transparent samples indicated that the compression caused the grains to fracture, and the broken grains bonded with each other. We demonstrated that the ceramics’ pressure-induced transparency was a process during which the grains were squeezed and broken, the pores were close between the grains, and the broken grains were re-bonded under compression.  相似文献   
9.
10.

LiFe2/3Mn1/3PO4/C composite was prepared by the rheological phase reaction using LiH2PO4, Li2CO3, FePO4, Mn(Ac)2·4H2O and ascorbic acid as starting materials. The crystal structure and morphology of as-synthesized sample were characterized by X-ray diffraction (XRD) and scanning electron microscopy (SEM). The analysis of XRD results showed that the obtained sample was single-phase with orthorhombic olivine-type structure (Pnma space group). SEM micrographs revealed that the sample was aggregates, with an irregular morphology. The initial discharge capacity was 166.9, 149.1, 139.6, 112.8, 82.93 mAh g??1 at the rate of 0.1, 0.5, 1, 2, and 10 C, respectively. And when the rate was 0.1, 0.5, 1, 2, and 10 C, the capacity retention was 92.2%, 90%, 92.9%, 97.6%, 91.5% after 50, 100, 200, 200, 500 cycles, respectively.

  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号