共查询到19条相似文献,搜索用时 359 毫秒
1.
2.
一种新型缓蚀阻垢剂的制备及性能初探 总被引:7,自引:0,他引:7
本文以异丙烯膦酸(IPPA)为原料,以过硫酸铵为引发剂,通过水溶液聚合反应,制备了一种新型缓蚀阻垢剂聚合异丙烯膦酸(PIPPA),探讨了反应温度,反应时间,引发剂用量及PH至聚合反应的影响,研究了PIPPA在不同PH值条件下的缓蚀垢性能。 相似文献
3.
4.
AA/IPPA/AMPS聚合物的合成及性能的研究 总被引:18,自引:2,他引:16
描述了异丙烯膦酸单体的合成及其和丙烯酸、2-丙烯酰胺基-2-甲基丙磺酸共聚以得到AA/IPPA/AMPS聚合物。评定了该聚合物的缓蚀阻性能,并和其它聚合刊物 比较。 相似文献
5.
6.
新型高效水处理剂的合成及性能研究 总被引:19,自引:1,他引:18
以亚磷酸、丙烯酸、2 丙烯酰氨基 2 甲基丙磺酸(AMPS) 为原料,合成了含磺酸基的膦酰基羧酸共调聚物(POCA) ,研究了它的阻垢分散及缓蚀性能,并与HEDP、HPMA、HS- 312 、PBTCA 等水处理剂作了比较。结果表明,在加药质量浓度为2-5 ~20 mg/L 时,POCA 与以上4 种药剂对CaCO3 沉积的最大抑制能力分别为96 % ,77-8 % ,88-4 % ,62-8 % ,97-6 % ;对Ca3(PO4)2 沉积的最大抑制能力分别为90-4 % ,22-4 % ,35-2 % ,89-6 % ,35-4 % ;对锌盐沉积的最大抑制能力分别为88-2 % ,35-2 % ,33 % ,90-4 % ,54 % ;分散氧化铁时上清液的最小透光率分别为39-8 % ,52-1 % ,42-3 % ,30-7 % ,61 % ;在加药质量浓度为5 ~40 mg/L 时,对碳钢的最大缓蚀率分别为70-6 % ,87-7 % ,10-4 % ,8-9 % ,76-9 % 。POCA的综合性能较好。 相似文献
7.
8.
絮凝—缓蚀剂CMT—A2的应用性能研究 总被引:12,自引:1,他引:11
以油田含油污水为处理对象,系统研究了药剂CMT-A2在不同条件下的絮凝,缓蚀效果。絮凝实验结果表明2×10^-6CMT-A2和3×10^-6PAC配伍使用处理模拟含油污水,30分钟静置沉降后处理水残留浊度<1mg/L。动态实验结果证实CMT-A2具有良好的抑制点蚀和均匀腐蚀的能力。因此CMT-A2是一种兼具絮凝,缓蚀双重功效的新型工业水处理药剂,有可喜的应用前景。 相似文献
9.
10.
PS树脂挤出自由低发泡 总被引:4,自引:1,他引:3
研究了发泡剂AC与HIPS-825、HIPS-423VC、HIPS-2712、GPS四种PS树脂挤出自由低发泡制品的密度、泡孔结构的关系,讨论了交联剂、成核剂以及工艺条件对发泡体的影响,并用偏光显微镜分析了泡孔的微观结构。结果表明:(1)四种PS树脂中HIPS-423VC树脂较适合于用AC作发泡剂挤出低发泡制品;(2)交联剂DCP用量以0.1份为最佳,此时密度较低,泡孔均匀细密;(3)在确定的成型温度条件下,螺杆转速以40r/min比较适宜,此时塑化充分,泡孔均匀;(4)综合考虑制品密度、力学性能、泡孔结构和均匀度等因素CaCO3用量以2.5份为佳。 相似文献
11.
Ramadev Herle S. Divakara Shetty U. Achutha Kini 《Chemical Engineering Communications》2013,200(1):120-130
The inhibiting action of N-cyclohexyl-N′-phenyl thiourea (CPTU) on the corrosion behavior of 304 SS in 3 M hydrochloric acid solution has been investigated using potentiodynamic polarization technique at four different temperatures. The results obtained reveal that CPTU acts as an efficient anodic inhibitor for the corrosion of 304 SS. Good inhibition efficiency (>92%) was evident in the acidic solution, and it was found to vary with temperature and concentration of the inhibitor. The adsorption of this compound on the 304 SS surface was found to obey the Temkin adsorption isotherm, and the inhibition was governed by physical adsorption mechanism. The thermodynamic parameters of adsorption deduced revealed a strong interaction and spontaneous adsorption of CPTU on the steel surface. Scanning electron microscopic study (SEM) was done to investigate the surface characterization of inhibited and uninhibited 304 SS specimens. 相似文献
12.
异丙烯膦酸—丙烯酸共聚物的阻垢效果 总被引:14,自引:2,他引:12
本文以异丙烯膦酸和丙烯酸为单体,合成了异丙烯膦酸-丙烯酸共聚物,探讨了共聚物浓度,pH值,钙离子浓度及温度对共聚物阻垢性能的影响,探讨了共聚物对氧化铁分散能力的影响。结果表明,异丙烯膦酸-丙烯酸共聚物不仅具有优异的阻垢性能,而且对氧化铁具有较好的分散能力,是一种良好的水质稳定剂。 相似文献
13.
14.
15.
本文研究比较了萘二甲酸型不饱和聚酯树脂(NUP)和通用型不饱和聚酯树脂(GUP)的耐水性、耐酸、耐碱性能。研究结果表明,NUP树脂具有优良的耐腐蚀性能。 相似文献
16.
一种新型磷酸盐玻璃的抗酸性研究 总被引:2,自引:0,他引:2
通过测试新型磷酸盐玻璃在酸性介质中质量损失随时间的变化情况,讨论并比较了玻璃在酸性介质中的化学侵蚀机理。研究表明:玻璃在酸性介质中经过一段线性溶解过程中,玻璃的溶解速率有所下降。这是由于玻璃表面生成明显覆盖层所致。XRD图谱显示覆盖层的组分和结构与玻璃完全一致。 相似文献
17.
6-氯-3-硝基甲苯-4-磺酸液相加氢制备CLT酸的研究 总被引:2,自引:0,他引:2
介绍了6-氯-3-硝基甲苯-4-磺酸液相加氢制备6-氯-3-氨基甲苯-4-磺酸,即CLT酸的催化剂及抑制脱氯方法,并讨论了相关的工艺条件。 相似文献
18.
本文采用实验室模拟环境因素加速老化的方法,比较了两种界面粘结性能不同的防腐容器用玻璃纤维增强乙烯基酯树脂复合材料(GF/VEA,GF/VEB)在硫酸介质中的吸湿特性以及动态和静态力学性能的变化。结果表明,在55℃、40wt%的硫酸水溶液中,两种树脂的吸湿性能相差不大,但界面粘结情况的不同使两种复合材料的吸湿特性表现出明显差别;两种复合材料的弹性模量(E′)、剪切强度和弯曲性能均随浸泡时间的延长而下降,且GF/VEB材料因具有较好的界面粘结而呈现较高的性能保留率。 相似文献
19.
The effect of acetic acid on the corrosion behavior of X 65 and C 1018 carbon steel in vapor-water two-phase stratified flow (Vsg: 2 m/s; Vsl: 0.1 m/s) at 2 bars total pressure, 1.54 bars CO2 partial pressure, pH 5.5, and 80°C was studied in a low pressure-high temperature multiphase flow horizontal loop using electrochemical and mass loss techniques. The liquid phase is composed of 1% NaCl aqueous solution containing different concentrations of acetic acid (500 to 5000 ppm total acetic acid), and the gas phase is composed of CO2-acetic acid-water vapor mixture. The corrosion rates, on both the top and bottom of the line, increase with increase in acetic acid concentration, which was attributed to the contribution of hydrogen ions by the free acetic acid to the cathodic reaction. Partial coverage of the metal surface by FeCO3 on both the top and bottom of the line is reported to be responsible for the observed localized corrosion. Surface analysis investigated with SEM and XRD is reported.
A vapor-liquid equilibrium model was developed for the system studied. 相似文献
A vapor-liquid equilibrium model was developed for the system studied. 相似文献