SiO2-Al2O3-P2O5系透明微晶玻璃的制备及表征

采用熔融及分部晶化法制备出掺钕SiO2-A12O3-P2O5系微晶玻璃．采用差热分析、X射线衍射及荧光光谱仪对材料进行表征。结果表明，在490-590℃保温2-4h，而后在600-700℃保温5-7h，可制得主晶相为AlPO4的透明微晶玻璃，由于Nd^3＋在热处理后富集在晶相中，使荧光光谱线在1054nm处峰值比原始玻璃强度大。     

FeO-Fe2O3-CaO-SiO2体系铁磁微晶玻璃的磁性及生物活性

具有生物活性和磁性的微晶玻璃材料被认为是温热疗法治疗癌症的有效热种子材料.本文制备了添加少量B2O3和P2O5后的FeO-Fe2O3-CaO-SiO2体系铁磁微晶玻璃,并进行了微观结构分析、XRD分析、磁性检测以及生理模拟液的浸泡实验.实验结果表明,制备的微晶玻璃材料同时具备磁性和生物活性这两种重要性能.不经过核化处理在1000℃晶化2h能够获得较理想的磁铁矿主晶相和硅灰石次晶相均匀致密分布的微观组织,所得微晶玻璃具有最佳的磁性能.铁含量提高能够增加微晶玻璃的磁性,然而会抑制微晶玻璃表面羟基磷灰石的形成,从而降低其生物活性.     

治癌用Fe2O3-CaO-SiO2基铁磁性微晶玻璃的研究现状

Fe2O3-CaO-SiO2基铁磁性微晶玻璃因具有磁滞生热性能和良好的生物活性而成为理想的温热疗法治疗癌症的热种子材料.主要介绍了Fe2O3-CaO-SiO2基铁磁性微晶玻璃的组成结构、制备、主要性能及其应用.     

SiO2-Al2O3-MgO-F系微晶玻璃的形变析晶

采用高温熔融法制备了SiO2 -Al2O3 -MgO-F系玻璃样品,应用X射线衍射(XRD)、扫描电子显微镜(SEM)研究了该微晶玻璃在自由形变时的析晶特征,得到了微晶玻璃自由形变析晶的规律.结果表明:在热处理过程中随着温度的升高,基础玻璃的黏度逐渐降低,可以在析晶前施加压力使之发生变形.在自由形变的前提下,微晶玻璃析出的晶体在垂直压力和平行压力方向上没有出现定向析晶.显微硬度测试结果也表明在微晶玻璃中没有明显的各向异性特征,不会带来材料性能在不同方向上的差异,为形状复杂、均质同性微晶陶瓷的制备提供了一个有效途径.     

B2O3-Al2O3-SiO2透明玻璃陶瓷研究

玻璃陶瓷属于一类多晶陶瓷材料.通过调整玻璃基质和晶相组成可以制备出具有良好的力学、热学、电学和光学性能的玻璃陶瓷材料.采用传统的熔融和退火技术制备出含B2O3-Al2O3-SiO2-Li2O-K2O组分的硼铝硅玻璃,并通过成核和长晶工艺最终制备出透明玻璃陶瓷.配合料在铂金坩埚中于1450℃下熔融2h,然后经两步热处理制度控制晶核的生成和晶粒的长大.采用差热分析技术确定成核和长晶温度.采用X射线衍射技术对不同热处理制度下的玻璃陶瓷样品进行分析,以确定最佳成核和长晶条件.采用扫描电子显微镜分析玻璃陶瓷形态,晶粒尺寸及其在残余玻璃相中的分布.采用UV-Vis-Nir分光光度计测定玻璃陶瓷样品的透过率.     

Sm3+:ZnO-B2O3-Al2O3-SiO2系透明玻璃陶瓷的制备和表征

采用熔融和晶化技术合成出含ZnAl2O4微晶的Sm3+:ZnO-B2O3-Al2O3-SiO2(ZBAS)玻璃陶瓷材料,并通过DSC、XRD、SEM和UV-Vis-Nir分光光度计和傅里叶变换荧光光谱仪等对样品进行了表征.结果表明,玻璃陶瓷主晶相为ZnAl2O4,晶相粒径为30nm;可见光透过率为最高可达70％,近红外透过率为70％～85％.该玻璃陶瓷能够受激发射出红光,且发光强度高于同组分的玻璃.     

核化温度对CaO—Al2O3-SiO2-Fe2O3系微晶玻璃微观结构及性能的影响

本文以钢渣和赤泥为主料,采用熔融法制备了CaO对微晶玻璃物相、微观结构及性能的影响。分析测试结果表明,化温度的升高,主晶相衍射峰先增高后降低,晶相析出量增加,晶玻璃的抗弯强度和耐腐蚀性最好。CaO-Al2O3-SiO2-Fe2O3系微晶玻璃,探讨了不同核化温度微晶玻璃的结晶物相不随核化温度的变化而改变。随着核且析出的晶粒尺寸逐渐增大。当核化温度为770℃时,微     

喷射-共沉淀法合成纳米晶CoFe2O4及磁性能

用喷射-共沉淀法成功地制备了纳米晶CoFe2O4铁氧体粉料.研究了不同合成温度对产物晶体结构、微观形貌和磁性能影响.结果表明:喷射-共沉淀法制备的粉料颗粒细小均匀、形状完整.600℃下煅烧1.5h,样品晶粒尺寸为29nm左右,平均颗粒尺寸小于100nm.室温下,样品比饱和磁化强度随煅烧温度增加而增大.850℃煅烧1.5 h时,其比饱和磁化强度Ms为88.6A·m2·kg-1.当晶粒大小为29nm时,纳米晶CoFe2O4铁氧体矫顽力达到最大值64.5kA·m-1,随后又随晶粒尺寸增大而减小.这可能归因于纳米磁性材料存在强烈的晶粒尺寸效应.     

掺P2O5氟化镓铟基玻璃微晶化可控性机理的探讨

用熔融法制备掺少量P2O5氟化镓铟基玻璃(20GaF3-15InF3-17CdF2-15ZnF2-10SnF2-20PbF2-3P2O5),玻璃的析晶动力学分析结果表明:掺入P2O5能使氟化镓铟基玻璃的析晶双峰间温度差△Tp(△Tp=Tp1-Tp2)增大,使可控微晶化变为可能。同时利用X射线衍射分析方法(XRD)和扫描电镜讨论了该微晶化玻璃的晶相和析晶形貌,并在593 K下保温1 h能得到透明度较好、含四方晶相ZnF2的微晶玻璃。     

含F-锂镁铝硅微晶玻璃的制备及晶化行为的研究

采用熔融烧结法,引入一定量的MgF2,制备出LMASF系微晶玻璃,采用DTA、XRD对该微晶玻璃的析晶温度和物相组成进行了分析,并采用SEM观察了微晶玻璃的断面形貌.讨论了热处理对微晶玻璃析晶的影响,并对其晶化行为和微观形貌进行了研究.实验结果表明,该微晶玻璃首先析出LixAlx Si1-xO2晶体,后随着温度的升高析出β-锂辉石晶体;最佳晶化温度为786℃,在该温度下保温2h,析出棒状β-锂辉石晶体,晶体长度为2～5μm,长径比较大.     

Some physical properties of V2O5-Fe2O3 and V2O5-Fe2O3-Li2O systems

Various methods have been used to study the physical properties of the V₂O₅-Fe₂O₃ and V₂O₅-Fe₂O₃-Li₂O systems, including X-ray, electron microscope, Mössbauer effect, NMR and thermogravimetric measurements. The iron ions are approximately equally distributed in substitutional and interstitial sites in the V₂O₅ lattice. The maximum number of iron ions dissolved in the V₂O₅ matrix corresponds to 4 mol % Fe₂O₃. In all the samples a quantity of Fe₂O₃ which has not been included in lattice is observed. The V₂O₅-Fe₂O₃ and V₂O₅-Fe₂O₃-Li₂O systems are formed from solid solutions mixed with very small Fe₂O₃ particles. The analysis of the charge compensation of iron ions suggests that V₂O₅ is a quasi-amorphous semiconductor. Irradiation of V₂O₅-based samples with an electron beam induces the V₂O₅ platelets to convert to the VO _x phase.     

Structural studies of some V2O5-P2O5-B2O3-Fe2O3 glass systems

X-ray diffraction and infrared measurements were performed on vanadium borophosphate glass containing different amounts of iron ranging from 0–7.5 mol % and heat treated at 300 °C for various times. The structure and phase separation could be determined for each glass composition. V₂O₅ was the main precipitated phase in all heat-treated samples, and its amount was dependent on the heat-treatment time and Fe₂O₃ content. Also FeP was detected in samples heat treated for 24 h. The infrared measurements showed the presence of both V⁴⁺ and V⁵⁺. The symmetry of V₂O ₇ ⁴⁻ and VO ₄ ³⁻ groups was found to increase with increasing Fe₂O₃ content. It was also found that some PO₄ changed to BO₃, forming a non-bridging oxygen.     

Plasma spraying of Al2O3 and Al2O3Y2O3

A microstructural study has been carried out of plasma-sprayed Al₂O₃ and mixed and sintered Al₂O₃Y₂O₃. In order to ascertain the degree of metastability achieved by plasma spraying, these results are compared with a similar experiment utilizing a CO₂ laser for melting and the hammer-and-anvil technique for quenching of the same materials. X-ray diffraction methods were used to determine the obtained phases and crystal structures. In addition, transmission electron microscopy was used to confirm the phases present and to study their morpology. The porosity was studied with both mercury intrusion porosimetry and small angle neutron scattering. The addition of Y₂O₃ is shown to decrease the porosity from 15% to 7.5%. Adhesion is likewise related to the addition of Y₂O₃ and it is seen that adhesion of the mixture is measurably improved over that of pure Al₂O₃. The implication of these results is discussed.