A hybrid homogeneously weighted moving average control chart for process monitoring: Discussion

The sensitivity of a monitoring scheme depends on many factors including the variance of the charting statistic which is very important in the computation of the control limits. This paper discusses the computation of the variance of the recently proposed hybrid homogeneously weighted moving average (HHWMA) $\overline{X}$ scheme which was based on an incorrect assumption. The correct variance is used to evaluate the run-length characteristics of the HHWMA $\overline{X}$ scheme. It is observed that the incorrect variance has a significant impact on the sensitivity (or performance) of the HHWMA $\overline{X}$ scheme.     

Influence of Se and Te substitutions at Tl-site of Tl(Ba,Sr)CaCu2O7 superconductor on the AC susceptibility and electrical properties

The Sr and Ba bearing Tl-1212 phase, Tl(Ba,Sr)CaCu₂O₇ is an interesting superconductor. The Sr only bearing TlSr₂CaCu₂O₇ is not easily prepared in the superconducting form. The Ba only bearing TlBa₂CaCu₂O₇ on the other hand does not show improvement in the transition temperature with elemental substitution. In this work the influence of multivalent Se (non-metal) and Te (metalloid) substitutions at the Tl-site of Tl_1-xM_x(Ba,Sr)CaCu₂O₇ (M = Se or Te) superconductors for x = 0–0.6 was studied. The samples were prepared via the conventional solid-state reaction method. XRD patterns showed a single Tl-1212 phase for x = 0 and 0.1 Se substituted samples. The critical current density at the peak temperature, T_p of the imaginary (χ”) part of the AC susceptibility (χ = χ’ +χ”), J_c-inter(T_p) for all samples was between 15 and 21 A cm⁻². The highest superconducting transition temperature was shown by the x = 0.3 Se-substituted sample (T_c-onset = 104 K, T_c-zero = 89 K, T_cχ’ = 104 K and T_p = 80 K). Te suppressed the superconductivity of Tl-1212 phase. The order of highest transition temperatures are as follows: Tl_1-xTe_x(Ba,Sr)CaCu₂O₇<Tl(Ba,Sr)CaCu₂O₇<Tl_1-xSe_x(Ba,Sr)CaCu₂O₇. This work showed that Se was better than Te in improving the transition temperature and flux pinning of the Tl-1212 phase. The roles of ionic radius of Se and Te on the superconductivity of Tl(Ba,Sr)CaCu₂O₇ are discussed in this paper.     

A hybrid homogeneously weighted moving average control chart for process monitoring

Several modifications and enhancements to control charts in increasing the performance of small and moderate process shifts have been introduced in the quality control charting techniques. In this paper, a new hybrid control chart for monitoring process location is proposed by combining two homogeneously weighted moving average (HWMA) control charts. The hybrid homogeneously weighted moving average (HHWMA) statistic is derived using two smoothing constants λ₁ and λ₂ . The average run length (ARL) and the standard deviation of the run length (SDRL) values of the HHWMA control chart are obtained and compared with some existing control charts for monitoring small and moderate shifts in the process location. The results of study show that the HHWMA control chart outperforms the existing control charts in many situations. The application of the HHWMA chart is demonstrated using a simulated data.     

储层泥浆侵入深度预测方法研究

泥浆侵入半径的确定尚缺乏严格的验证标准.以油水两相渗流理论和离子扩散方程为基础,结合储集层特点,研究了不同储层参数下泥浆滤液对地层的侵入特性.数值模拟侵入时间选取10 d和20 d.数值模拟结果表明,侵入半径在渗透率不变的情况下随孔隙度的增大而减小,在孔隙度不变的情况下随渗透率的增大而增大;当渗透率和孔隙度都发生变化时,泥浆侵入半径一般随孔隙度的增加呈幂函数增加.依据这种关系对测井资料约束处理,得到的泥浆侵入半径较客观地反映了地层的真实情况.     

稠油蒸汽吞吐过程中加热半径与井网关系的新理论

综合评价了稠油蒸汽吞吐过程中加热半径计算的3种经典模型,并推导出了稠油蒸汽吞吐过程中最大加热半径计算公式,首次采用Buckley-Leverret方程计算了热水带的加热半径,其结果与油田开发实际符合较好.同时,首次提出了稠油蒸汽吞吐在多轮次加热过程中的一种新理论：在1～4周期蒸汽起到了扩大加热半径的作用,随着周期增多而加热前缘向外扩展作用减小,蒸汽主要起重复加热油层的作用.本文导出的新模型公式及提出的新理论,对于不同类型稠油油藏蒸汽吞吐的井距设计具有一定的借鉴意义.     

基于矢量平均的信道估计算法

提出一种适用于DS-CDMA无线通信系统的低计算量而性能良好的信道估计算法。在DS-CDMA系统中，当接收信号经过解扩或多用户检测等时域预处理后，可以认为干扰大大减弱、期望信号在处理后的信号中占主要地位。这样，用预处理后信号相关阵的最大特征值对应的特征矢量可以很好地近似期望信号的信道矢量。但是，直接特征分解需要很大的计算量，特征跟踪计算量较低，但瞬态性能较差。本文提出一种基于相关矩阵列矢量平均的信道估计算法，该算法不需要特征分解或跟踪。仿真结果表明：新算法在降低计算量的情况下可以获得同直接特征分解方法几乎相同的性能。     

对象族可镇定半径的计算

本文采用优化方法把计算对象族的可镇定半径问题转化成优化问题。2范数定义下的可镇定半径采用了Lagrange乘子法求解；无穷范数意义下的可镇定半径采用了最小范数解方法求解。本文方法对可镇定半径的定义形式和不确定参数结构没有要求，因此更具有一般性。     

普通稠油油藏启动压力梯度求解方法与应用

利用微观尺度管流模型,结合普通稠油流变特征,提出了在考虑稠油流变性条件下微观启动压力梯度计算方法.对渤海渤中18块不同渗透率岩心进行室内驱替实验,通过对实验数据的回归分析,得到不同粘度普通稠油油藏启动压力梯度与地层平均渗透率关系,并绘制了启动压力梯度的图版.将研究结果应用于普通稠油油藏,给出了利用启动压力梯度确定极限泄油半径及合理井距的理论计算方法.     

一个基于相邻像素兼容度的模糊加权平均滤波器

在文献[1]的基础上，提出几个改进的模糊加权平均滤波器。本文的方案不仅同时考虑了相邻像素对中心像素的兼容性以及中心像素对相邻像素的兼容性，而且还考虑到了权系数对局部环境的适应性。实验结果表明，该方法相比文献[1]中的模糊加权平均滤波器以及标准的均值滤波器、中值滤波器在噪声消除与边缘保留方面具有更好的性能。     

高阶统计量地震子波估计建模

本文在反射系数序列为非高斯、平稳和统计独立的随机过程,地震子波为非因果、混合相位的假设条件下,分别应用滑动平均(MA)和自回归滑动平均(ARMA)模型对地震记录进行建模,并采用运算代价较小的基于高阶累积量的线性化求解方法——累积量矩阵方程法进行了子波提取和模型适应性的研究。数值模拟结果和实际地震数据处理结果表明:自回归滑动平均(ARMA)模型比滑动平均(MA)模型具有参数节省、模型更为高效的特点;累积量矩阵方程法可以有效地压制加性高斯噪声,但对累积量样本估计的准确性要求较高;如果累积量样本估计的误差和方差适度,结合自回归滑动平均(ARMA)模型描述的累积量矩阵方程法可以高效、准确地估计出地震子波。