磁絮凝强化技术处理厌氧消化污泥脱水液

为满足后续生物处理单元对固体悬浮物（SS）和铁浓度的进水要求，采用磁絮凝强化技术对厌氧消化污泥脱水液进行预处理。通过正交试验和单因素试验，本文考察了混凝水力条件、聚合氯化铝（PAC）投加量、聚丙烯酰胺（PAM）投加量、磁粉投加量及药剂投加顺序对磁絮凝效果的影响。试验结果表明：磁絮凝强化技术在快搅300r/min（2min）、慢搅100r/min（15min）、静置10min时，依次投加磁粉（40mg/L）、PAC（30mg/L）、PAM（4mg/L）时处理效果最好。在此运行条件下，SS和Fe³⁺去除率分别为97.61%、98.24%、絮凝指数（FI值）取得最大值、zeta电位绝对值最小，絮凝效果最佳。与对照相比，磁絮凝强化技术对SS和Fe³⁺去除率分别可提高3.70%和10.82%，同时絮体最大沉降速度可提高33%。磁絮凝技术处理后的出水不仅可以满足后续生物处理单元对SS和铁浓度的要求，还可以有效提高磁絮凝体的沉降速度，减小沉淀时间，具有较好的实用价值。     

The effects of electrical comminution on the mineral liberation and surface chemistry of a porphyry copper ore

The surface chemistry and mineral liberation changes of a porphyry copper ore after high voltage pulse (HVP) electrical comminution have been investigated using X-ray photoelectron spectroscopy (XPS) and mineral liberation analysis (MLA). Previous studies suggest that electrical comminution has the potential to improve downstream flotation recoveries, due to increased mineral liberation. However, until now the effects on the surface chemistry have not been investigated in detail.The mineral liberation results showed that chalcopyrite was more liberated in the electrical comminution product than in mechanical comminution, noticeably in the coarser size fractions. The surface chemistry of pure chalcopyrite was investigated, using XPS, and high resolution scans of iron and sulphur showed that both comminution methods led to iron oxidising preferentially leaving behind a passivating film of copper sulphides. However, the HVP product oxidisation was more severe with more iron oxide being produced and further oxidation of the remaining copper sulphides into copper sulphate. An attrition grinding stage may be useful in removing the oxidised layer from the surface of the particles prior to flotation separation. This paper presents a new application of the HVP technology in hybrid procedures using electrical comminution and mechanical grinding to prepare the flotation feed, rather than using excessive pulse energy to fully disintegrate ore to the flotation size. Better liberation and flotation performance were achieved through the hybrid procedures than the comparative mechanical comminution.     

工程水压爆破在煤层爆破中的应用

通过黑岱沟露天煤矿的工程试验总结了工程水压爆破技术(水土复合填塞炮孔)的原理及在露天煤矿爆破施工中的应用效果。在露天煤矿爆破施工中采用工程水压爆破技术,可以提高煤层爆破的大块率,降低单位立方岩石耗药量,降低爆破气体的温度,同时可以降低煤层爆破失火率、粉尘排放量,有效地控制爆破飞石。     

Nickel foam-supported Fe,Ni-Polyporphyrin microparticles: Efficient bifunctional catalysts for overall water splitting in alkaline media

Developing highly active, stable and sustainable electrocatalysts for overall water splitting is of great importance to generate renewable H₂ for fuel cells. Herein, we report the synthesis of electrocatalytically active, nickel foam-supported, spherical core-shell Fe-poly(tetraphenylporphyrin)/Ni-poly(tetraphenylporphyrin) microparticles (FeTPP@NiTPP/NF). We also show that FeTPP@NiTPP/NF exhibits efficient bifunctional electrocatalytic properties toward both the oxygen evolution reaction (OER) and the hydrogen evolution reaction (HER). Electrochemical tests in KOH solution (1 M) reveal that FeTPP@NiTPP/NF electrocatalyzes the OER with 100 mA cm⁻² at an overpotential of 302 mV and the HER with 10 mA cm⁻² at an overpotential of 170 mV. Notably also, its catalytic performance for OER is better than that of RuO₂, the benchmark OER catalyst. Although its catalytic activity for HER is slightly lower than that of Pt/C (the benchmark HER electrocatalyst), it shows greater stability than the latter during the reaction. The material also exhibits electrocatalytic activity for overall water splitting reaction at a current density of 10 mA cm⁻² with a cell voltage of 1.58 V, along with a good recovery property. Additionally, the work demonstrates a new synthetic strategy to an efficient, noble metal-free-coordinated covalent organic framework (COF)-based, bifunctional electrocatalyst for water splitting.     

综放工作面防治水技术应用实践

为解决21000工作面采空区及顶板涌水问题,根据工作面出水点的不同情况,采取了集水器导水、老塘设挡水堰截水、挖排水沟疏水等多项治水措施,经统计排水量达33~42m3/h,有效控制了水情,确保了工作面正常生产。     

运输机皮带撕裂原因分析及特征实验研究

带式运输机是重要的连续性运输设备，皮带撕裂是造成带式运输机运输失效的重要因素。详细分析了引起皮带撕裂的常见原因，并给出了合理的预防措施。针对皮带撕裂现象构建皮带撕裂实验平台，并通过皮带受力应变实验分析掌握了皮带撕裂的特征，为预防皮带撕裂的发生提供了一定的理论依据。     

Efficiency and effectiveness enhancement of an intercooler of two‐stage air compressor by low‐cost Al2O3/water nanofluids

The present study was aimed to utilize low‐cost alumina (Al₂O₃) nanoparticles for improving the heat transfer behavior in an intercooler of two‐stage air compressor. Experimental investigation was carried out with three different volume concentrations of 0.5%, 0.75%, and 1.0% Al₂O₃/water nanofluids to assess the performance of the intercooler, that is, counterflow heat exchanger at different loads. Thermal properties such as thermal conductivity and overall heat transfer coefficient of nanofluid increased substantially with increasing concentration of Al₂O₃ nanoparticles. Specific heat capacity of nanofluids were lower than base water. The intercooler performance parameters such as effectiveness and efficiency improved appreciably with the employment of nanofluid. The efficiency increased by about 6.1% with maximum concentration of nanofluid, that is, 1% at 3‐bar compressor load. It is concluded from the study that high concentration of Al₂O₃ nanoparticles dispersion in water would offer better heat transfer performance of the intercooler.     

餐厨污水就地处理与中水回用工艺的探索与实践

以无锡某厂食堂污水处理及中水回用为例,探讨采用"隔油+混凝沉淀+A^2/O+MBR"工艺就地处理餐厨污水,并将出水回用于厂区冲厕可行性。经过78 d的调试,该工艺实现了餐厨污水中污染物的去除,COD小于50mg/L,NH4^+-N质量浓度小于5 mg/L,总氮小于10 mg/L,总磷小于0.5 mg/L,大肠杆菌数小于2个/L,基本满足中水回用要求。经计算吨水处理成本9.83元,含电费、药剂费、人工费、污泥处理费及膜更换费用。结合中水回用节省自来水后计算吨水处理综合成本为5.23元,大幅降低公司对市政供水的依赖,降低公司用水成本。     

上榆泉煤矿煤泥水多参数在线检测系统应用研究

针对上榆泉煤矿煤泥水性质参数人工检测周期长、误差大、滞后性严重的问题,采用多参数传感器和PLC,开发了煤泥水多参数在线检测系统。经过8 h稳定运行,平均结果显示该厂煤泥水参数为pH值为7.71、浓度9.45%、中值直径(D50)39.56μm、流量2 440 m3/h、水质硬度428.94 mg/L,与人工检测结果相一致。应用结果表明,该检测系统能够实现煤泥水多参数在线监测和数据分析功能,使煤泥水的处理更高效。     

饱和尾粉砂动孔隙水压力发展特性试验研究

采用动三轴仪对内蒙古某尾矿库尾粉砂进行了动强度试验,研究了围压、相对密实度及固结比对动荷载作用下尾粉砂中孔隙水压力发展特性的影响。研究结果表明,随着固结比、相对密实度、围压的增大,动荷载作用下饱和尾粉砂孔压增长曲线形状由陡峭转变为平缓。随着围压及固结比增大,试样动力破坏形式从以孔压值为主要表征指标的液化破坏,转化为以动剪应变为主要破坏形式的软化破坏。动荷载作用下发生液化破坏的饱和尾粉砂孔压增长过程分可为初始增长阶段、稳定增长阶段和快速增长至破坏阶段,孔压增长曲线表现为明显的反S型,本文采用双对数函数对该试验孔压增长曲线进行拟合,结果表明该模型可以较好地模拟尾粉砂在动荷载作用下的孔压发展规律。