川北某黑色页岩型铼矿工艺矿物学研究

通过矿相显微镜、扫描电镜、电子探针、X射线能谱元素面分析等多种手段综合研究了川北某黑色页岩型铼矿中铼的赋存状态。样品为黑色页岩,有机碳含量较高。粘土矿物总量为14.6%,黄铁矿含量16.2%,石英含量37.7%。样品具典型的粘土结构,矿物粒度微细。铼有两种赋存状态,一种呈类质同象形式赋存于黄铁矿内,另一种则以分散形式存在。典型黄铁矿测点Re平均含量为0.024%。黄铁矿是Re的重要载体矿物。建议通过浮选分离黄铁矿,从而实现Re的富集。      

含铼钼精矿焙烧尾气收尘与铼回收一体化装置的研制与应用

研制了一种含铼钼精矿焙烧尾气收尘和铼回收装置,该装置将自激式除尘器技术与球面筛板塔技术相结合:采用自激式除尘器进行收尘和铼回收;采用球面筛板淋洗塔进行进一步收尘和铼回收,并将其应用到工程实际中。这是国内首次成功地将此类装置应用于钼精矿焙烧尾气收尘和铼回收生产实践中。经过生产实践,证明该装置切实可行,淋洗效率高,并具有结构简单、操作方便、成本低和能耗小等特点。此外,此除尘系统还可应用于冶金矿山、化工和建材等领域中的湿法除尘。     

SMF-425树脂吸附和解吸铼的研究

研究了SMF-425型阴离子交换树脂在弱酸体系中吸附、解吸铼的性能和机理，结果表明，[H^ ]在0.1～1.0mol/L范围内，对铼的吸附有利，吸附平衡服从Freundish吸附等温式，吸附反应吸热，温度越高越有利于吸附。每g干树脂对铼的静态和动态饱和吸附容量分别为169.31mg、175.43mg。用2mol/L硫氰酸铵作淋洗剂，流速为2mL/min时，淋洗效果较好，结果令人满意。     

Thermophysical Properties of W–Re Alloys Above the Melting Region

In earlier experiments we have studied pure elements with a fast pulse heating technique to obtain thermophysical properties of the liquid state. We report here results for thermophysical properties such as specific heat and dependences among enthalpy, electrical resistivity, and temperature, for four W–Re alloys (3.95, 21.03, 23.84, and 30.82 at % of Re) in a wide temperature range covering solid and liquid states. Thermal conductivity is calculated using the Wiedemann–Franz law for the liquid alloy, as.well as data for thermal diffusivity for the beginning of the liquid phase. Additionally, data for the entire temperature range studied have been analyzed in comparison with those of the constituent elements, tungsten and rhenium, since both metals have been studied previously with the same experimental technique. Such information is of interest in the field of metallurgy since W–Re alloys of low Re content in the region of mutual component solubility in the solid state are widely used as thermocouple materials for the purposes of high-temperature thermometry.     

Dehydrogenation of Light Alkanes Over Rhenium Catalysts on Conventional and Mesoporous MFI Supports

Recently, Re/HZSM-5 (Si/Al = 15) was shown to be an efficient catalyst for ethane dehydrogenation and aromatization at 823 K and atmospheric pressure. In this reaction, the major initial products were benzene, toluene and xylene (BTX), but increasing amounts of ethene were produced with time on stream due to deactivation of the catalyst. We show that by use of rhenium impregnated MFI supports with very few or no acidic sites (Si/Al > 500), highly selective ethane dehydrogenation catalysts are obtained with ethene selectivities of 98%. By use of mesoporous MFI supports (Si/Al >500) the lifetime of the catalyst appears to be slightly improved compared to conventional MFI crystals. The beneficial effect of a mesoporous MFI support is convincingly demonstrated in propane dehydrogenation, where both conversion and selectivities on the mesoporous MFI (Si/Al > 500) impregnated with Re are significantly higher than on Re supported on a comparable conventional MFI support.     

Guanine and plasmid DNA binding of mono- and trinuclear fac-[Re(CO)3]+ complexes with amino acid ligands

We have synthesized and fully characterized four new complexes comprising the fac-[Re(CO)3]+ moiety and the ligands NH3, L-proline (Pro), or N,N-dimethylglycine (dmGly). The reaction of [Re(H2O)3(CO)3]+ with the two amino acids gives trinuclear complexes of general formula [Re(L)(CO)3]3 (where L = amino acid). We have studied the in vitro behavior of these compounds with guanine and DNA in order to understand whether the cytotoxicity exhibited by certain rhenium complexes based on the fac-[Re(CO)3]+ core is due to the formation of nucleobase complexes and inter- or intrastrand links between DNA bases. We have performed model studies with guanine and studied the structural effects induced by different rhenium(I) tricarbonyl complexes on PhiX174 plasmid DNA by electrophoretic methods. Our results show that rhenium complexes with two available coordination sites interact with plasmid DNA to form a stable adduct that is likely to involve two bases.     

微量Re对93W-4.9Ni-2.1Fe合金性能及微观组织的影响

采用经高能球磨的超细93W-4.9Ni-2.1Fe预合金粉末，并添加少量的Re，经压制，烧结制取试样。研究Re对93W-4.9Ni-2.1Fe合金性能和微观组织的影响。用机械式拉力试验机测量试样拉伸强度，用扫描电镜观察试样拉伸断1：3的形貌，用金相显微镜对试样显微组织进行测试分析。结果表明：当添加0％-0．8％Re（质量分数，下同）时，随着Re添加量的增加，合金的相对密度稳定在99．43％～99．49％，烧结样品延伸率从不加Re时的26．47％降至0．8％Re时的14．71％，合金的抗拉强度由不加Re时的1025MPa增加到0．8％Re时的1142MPa，合金拉伸断口收缩率由不加Re时的20．45％降至0．8％Re时的10．91％；随着Re含量的增加，合金中W晶粒的穿晶解理断裂的比例增加，而粘结相延性断裂的比例减少；随着Re含量的增加，合金中W晶粒尺寸明显减小，由不加Re时的40μm-45μm减小到添加0．8％Re时的20μm-25μm。     

Ir／Mo互扩散研究

研究了Ir/Re喷管制备过程中的Ir/Mo互扩散问题。在电子探针测量的基础上,根据扩散理论和Ir-Mo相图数据,建立并推导Ir/Mo扩散模型和解。计算得到Ir3Mo相中的互扩散系数为:D=9.0×10-9exp(-1.46eV/kT)(cm2/s),Ir基固溶体中的互扩散系数为:D=5.0×10-10exp(-1.1eV/kT)(cm2/s)。确定喷管中Ir/Mo互扩散的特点,给出估算Ir3Mo相层厚的方法。确定Re在Ir3Mo相中的扩散主要是受Ir控制。     

Epitaxial growth of large-area and highly crystalline anisotropic ReSe<Subscript>2</Subscript> atomic layer

The anisotropic two-dimensional (2D) layered material rhenium disulfide (ReSe2) has attracted considerable attention because of its unusual properties and promising applications in electronic and optoelectronic devices.However,because of its low lattice symmetry and interlayer decoupling,anisotropic growth and out-of-plane growth occur easily,yielding thick flakes,dendritic structure,or flower-like structure.In this study,we demonstrated a bottom-up method for the controlled and scalable synthesis of ReSe2 by van der Waals epitaxy.To achieve controllable growth,a micro-reactor with a confined reaction space was constructed by stacking two mica substrates in the chemical vapor deposition system.Within the confined reaction space,the nucleation density and growth rate of ReSe2 were significantly reduced,favoring the large-area synthesis of ReSe2 with a uniform monolayer thickness.The morphological evolution of ReSe2 with growth temperature indicated that the anisotropic growth was suppressed at a low growth temperature (＜600 ℃).Field-effect transistors employing the grown ReSe2 exhibited p-type conduction with a current ON/OFF ratio up to 10s and a hole carrier mobility of 0.98 cm2/(V.s).Furthermore,the ReSe2 device exhibited an outstanding photoresponse to near-infrared light,with responsivity up to 8.4 and 5.1 A/W for 850-and 940-nm light,respectively.This work not only promotes the large-scale application of ReSe2 in high-performance electronic devices but also clarifies the growth mechanism of low-lattice symmetry 2D materials.     

Direct identification of monolayer rhenium diselenide by an individual diffraction pattern

In the current extensive studies of layered two-dimensional (2D) materials,compared to hexagonal structures such as graphene,hBN,and MoS2,lowsymmetry 2D materials have shown great potential for applications in anisotropic devices.Rhenium diselenide (ReSe2) possesses the bulk space group P(1) and belongs to the triclinic crystal system with a deformed cadmium-iodide-type structure.Here,we propose an electron diffraction-based method to distinguish the monolayer ReSe2 membrane from multilayer ReSe2 and its two different vertical orientations.Our method is also applicable to other low-symmetry crystal systems,including both triclinic and monoclinic lattices,as long as their third unit-cell basis vectors are not perpendicular to the basal plane.Our experimental results are well explained by kinematical electron diffraction theory and the corresponding simulations.Generalization of our method to other 2D materials,such as graphene,is also discussed.