泳池式轻水反应堆内电磁线圈可控温辐照装置设计

本文设计了在泳池式轻水反应堆（简称泳池堆）内在线测量电磁线圈电性能的可控温辐照装置。采用MCNP程序进行中子物理计算，对泳池堆、线圈骨架的结构尺寸与物质组分进行了精细全尺寸模拟，得出辐照装置的发热功率和中子注量率。通过初步估算，使用ANSYS CFX进行了数值模拟，得出辐照装置内线圈在堆运行时的温度，并提出温度控制的方法。辐照装置采用铝材加工制造，并进行了垂直度测试、气压测试、检漏测试。增加了绝缘设计，将辐照装置与泳池堆之间进行绝缘。在线圈处预埋铠装热电偶，对线圈温度进行实时监测。在泳池堆内对电磁线圈进行辐照试验，结果表明，本文设计的辐照装置能满足电磁线圈在泳池堆孔道内进行辐照试验的要求，并可对电磁线圈进行实时温度控制。     

Rogowski coil current transducer compensation method for harmonic active power error

In the harmonic active power measurement, the highest uncertainties are generally introduced by the current and voltage transducers. In a previous paper, the authors showed that the current transformer (CT) can introduce significant errors in such measurement, especially if the phase shift between voltage and current is close to ±90°. In such condition the errors on harmonic power measurement are mainly due to the CT phase displacement. This paper shows that better results can be achieved with more linear transducers, such as the Rogowski coil current transducers (RCCTs), whose metrological performance in distorted condition can be improved, by means of a proper compensation method. The proposed method for RCCTs compensation is based on the frequency response and it allows to reduce the errors on harmonic power measurement, also for phase shift close to ±90°. The study is supported by several experimental tests.     

轨腰仿生自分层防腐梯度涂料合成及影响因素和结构探究

目的仿荷藕结构及功能,制备一种自分层防腐涂料。方法合成聚氨酯改性环氧树脂(PU/EP)及氟硅改性丙烯酸树脂(氟硅改性PAA),将两种树脂共混形成自分层涂料。通过铅笔硬度测试、机械性能测试、接触角测试、耐老化测试、划格法附着力测试、电化学阻抗测试等,分别评价两种树脂比例、混合溶剂比例对涂膜自分层行为及性能的影响,并通过SEM-EDS、红外光谱等表征技术分析涂膜分层后的结构。结果当PU/EP∶氟硅改性PAA=1∶1时,接触角达到96.0°,柔韧性为0.5 mm,耐冲击为50 cm,附着力等级为1,失光率降至19%;乙酸丁酯(NBAC)∶正丁醇(NBA)=4∶6时,涂膜分层情况良好,接触角达到107.7°,浸泡水中48 h耐水性无变化,失光率降至17%。SEM-EDS、红外光谱分析表明,自分层涂膜上层为氟硅改性PAA、底层为PU/EP,中间存在过渡涂层,过渡层两种树脂中的─COOH、─OH、环氧基发生反应,使整个涂层更具稳定性。经由EIS分析,在3.5%NaCl溶液中浸泡40天后,腐蚀介质没有渗透涂膜到达基底金属界面。结论制备的轨腰仿生自分层涂膜的机械性能、附着力、疏水性、耐老化、防腐蚀性能优异,涂膜结构稳定。     

稀土在激光熔覆镍基自熔合金中的作用

采用CO2激光器在低碳钢表面进行激光熔覆处理,研究了稀土氧化物在激光熔覆Ni45自熔合金层中的作用.结果表明,加入适量稀土的熔覆合金层组织得到细化,其在还原酸中的耐蚀性和抗高温氧化能力较不加稀土镍基合金熔覆层都有较大提高,更远高于低碳钢.可见,稀土变质的激光熔覆处理对提高低碳钢性能具有重要指导意义.     

国产风机盘管空调系统常见问题分析

分析了国产风机盘管使用中常见的问题,指出机组因风量不足、冷量风量匹配不合理以及风机盘管某些设备故障,导致了风机盘管精度低、舒适性差、能耗高等一系列问题。指出应引起空调设计和运行维护人员的注意。     

动圈式扬声器温度失效仿真

常态下测量了典型小功率动圈式扬声器的静态参数,根据Small小信号参数建立了扬声器温度失效模型;结合VisualC 和Matlab计算机语言的优势,编制了相应的仿真软件;对给定动圈式扬声器中可能出现的音圈短路、功率过载和意外结构性故障进行了计算机仿真,结果表明,封闭工作区间内温度急剧升高是导致扬声器失效的主要原因,与有限元模型计算结果相比较,最大误差分别为2.63%(16W,纸骨架)和3.36%(16W,铝骨架)。     

防腐蚀涂料的性能与选择

介绍并比较几种常用的防腐蚀涂料的品种、组成和性能特点，提出防腐蚀涂料的选择原则。     

盐浓度对交联聚合物线团形态的影响

用核孔膜过滤法 (过滤体积对过滤时间作图 )、动态光散射法 (DLS)和扫描电镜法 (SEM )研究了交联反应前后盐 (NaCl)浓度变化对低浓度HPAM与AlCit形成的交联聚合物溶液 (LPS)中交联聚合物线团 (LPC)形态的影响。所用HPAM相对分子质量 1.1× 10 7～ 1.4× 10 7,LPS中HPAM与Al的质量比 2 0∶1,HPAM浓度 0 .1或 0 .2 g/L ,交联反应温度 40℃ ,时间 7天。实验结果表明 :①LPC的平均水力半径Rh(DLS测定值 )随交联反应时盐浓度的增大先减小后增大 ,盐浓度由 0 .5 g/L增加到 2 g/L时Rh 由 45 0nm迅速减小到 2 5 0nm ,盐浓度增加到 2 0 g/L时Rh达到最小值 16 0nm ,此后随盐浓度的继续增加Rh 有所增大 ;盐浓度 0 .5和 2 .0 g/L时Rh 的SEM测定值分别为45 0和 2 5 0nm ,与DLS结果一致。②交联反应完成后改变LPS的盐浓度 ,也可改变LPC的Rh 值 ,但改变幅度较小 ;盐浓度 0 .5 g/L时形成的LPS ,当盐浓度增加至 2 g/L时 ,Rh 值由 45 0nm减小至 35 9nm ,大于盐浓度 2 g/L时形成的LPS的Rh 值 (2 46nm) ;盐浓度 2 g/L时形成的LPS ,当盐浓度减少至 0 .5 g/L时 ,Rh 值由 2 46nm增大至32 6nm ,小于盐浓度 0 .5g/L时形成的LPS的Rh 值 (4 5 0nm)。用盐浓度改变引起LPC水化层厚度改变 ,线团收缩或舒张解释盐浓度改变时Rh 测定值的     

HT-7U纵场磁体的真空压力浸渍

主要通过模拟匝间流动试验、短样试验和长样试验等 ,探求低温超导托卡马克HT 7U中纵场磁体线圈的绝缘层真空压力浸渍的工艺参数 ,确定工艺流程 ,并以模型线圈试验的电性能和液氦温度下的力学性能来验证工艺参数及工艺流程的可靠性。     

Effect of Synergistic Anticorrosion Treatments on Cycling Stability of Mg-Based Hydrogen Storage Electrode

In this paper, any two of the three anticorrosion agents, that is emulsifier (OP-10), soluble glass (Na2O·nSiO2) and glycerin (C3H8O3), were treated simultaneously on the surface of amorphous (a-) MgNi+5% Ml2Mg17 (Ml denotes the lanthanum-rich mish metal) electrode and the electrolyte. Effect of the synergistic anticorrosion treatment on charging/discharging cycle stability of the electrode was investigated. Contrasted with single treatment method, the cycling stability of the electrodes was further improved. The desirable synergistic anticorrosion method was that the electrode was treated by the soluble glass, and that OP-10 was added into the electrolyte. The cyclic voltammogram (CV) results of the electrode show clearly that the anticorrosion agent can change the electrochemical activity and mechanism of the electrode. The concentration of the anticorrosion agent in the electrolyte treated by the synergistic anticorrosion method was also investigated. The appropriate concentration of the anticorrosion agents in the electrolyte is 0.143%.