Fast RSVP: Efficient RSVP Mobility Support for Mobile IPv6

In recent years, with the development of mobile communication technologies and the increase of available wireless transmission bandwidth, deploying multimedia services in next generation mobile IPv6 networks has become an inevitable trend. RSVP (resource reservation protocol) proposed by the IETF is designed for hardwired and fixed networks and can not be used in mobile environments. This paper proposes a protocol, called Fast RSVP, to reserve resources for mobile IPv6. The protocol adopts a cross-layer design approach where two modules (RSVP module and Mobile IPv6 module) at different layers cooperate with each other. Fast RSVP divides a handover process with QoS guarantees into two stages: (1) setup of the resource reservation neighbor tunnel and (2) resource reservation on the optimized route. It can help a mobile node realize fast handover with QoS guarantees as well as avoid resource wasting by triangular routes, advanced reservations and duplicate reservations. In addition, fast RSVP reserves “guard channels” for handover sessions, thus greatly reducing the handover session forced termination rate while maintaining high performance of the network. Based on extensive performance analysis and simulations, Fast RSVP, compared with existing methods of resource reservation in mobile environments, performs better in terms of packet delay and throughput during handover, QoS recovery time after handover, resource reservation cost, handover session forced termination rate and overall session completion rate.     

QoS provisioning wireless multimedia transmission over cognitive radio networks

The rapid growing of wireless multimedia applications increases the needs of spectrum resources, but today’s spectrum resources have become more and more scarce and large part of the assigned spectrum is in an inefficiency usage. Cognitive Radio (CR) technologies are proposed to solve current spectrum inefficiency problems and offer users a ubiquitous wireless accessing environment, relying on dynamic spectrum allocation. However, there are two unsolved problems in previous work: 1) based on the simplified Quality of Service (QoS) uniform assumption, specific requirements of different wireless multimedia applications cannot be satisfied; 2) aiming at single-objective optimization of spectrum utilization or handoff rate, the co-optimization of these two necessary objectives in CR networks has not been achieved. In this paper, we propose a Two-tier Cooperative Spectrum Allocation method (TCSA) to solve these two problems. TCSA consists of two functional parts: one is a Spectrum Adjacency Ranking algorithm implemented at the secondary users’ terminals to satisfy the QoS requirements for different wireless multimedia applications; and the other is a Max Hyper-weight Matching algorithm implemented at the cognitive engines of CR networks to co-optimize spectrum utilization and secondary users’ spectrum handoff rate. Simulation results show that, compared with the other Random matching algorithm and Cost minimized algorithm, TCSA can significantly improve the performance of CR networks in terms of secondary users’ throughput and spectrum handoff rate.     

TEM and HREM study of Al3Zr precipitates in an Al-Mg-Si-Zr alloy

The structure of Al₃Zr precipitates in Al‐1.0Mg‐0.6Si‐0.5Zr (in wt.%) alloy was investigated using conventional transmission electron microscopy (TEM) and high‐resolution TEM (HREM). After annealing of the alloy in the temperature range 450–540 °C, spherical precipitates of metastable L1₂‐Al₃Zr phase appeared nearly homogeneously within the matrix, and elongated particles were found at grain boundaries. L1₂‐structured Al₃Zr were about 20–30 nm in diameter and coherent with the matrix. Inside some of them, planar faults parallel to {100} planes were revealed by use of HREM. Most probably, these faults are an indication of the transition stage of transformation to the stable D0₂₃‐type Al₃Zr phase. The elongated precipitates (about 100 nm) were identified as D0₂₂‐type Al₃Zr. Energy‐dispersive X‐ray analysis showed that they contain, apart from Al, mainly Zr with small amounts of Si. The substitution of Al by Si increased the stability of the D0₂₂‐Al₃Zr as compared with D0₂₃‐Al₃Zr.     

An Improved Markov Model for IEEE 802.15.4 Slotted CSMA/CA Mechanism

IEEE 802.15.4 protocol is proposed to meet the low latency and energy consumption needs in low-rate wireless applications,however,few analytical models are tractable enough for comprehensive evaluation of the protocol.To evaluate the IEEE 802.15.4 slotted CSMA/CA channel access mechanism in this paper,we propose a practical and accurate discrete Markov chain model,which can dynamically represent different network loads.By computing the steady-state distribution probability of the Markov chain,we obtain a...     

RSVP协议在移动IPv6网络中的扩展性研究

针对无线移动通信的特点,提出了一种在移动IPv6网络中保障用户通信服务质量的资源预留新方案Fast RSVP.该方案采用跨层设计的思想,将两个不同层次的模块:移动IPv6模块和RSVP模块结合起来,通过在两个模块之间增加一些原语使得二者配合工作以保证移动用户的通信业务质量.Fast RSVP方案引入了邻居隧道提前资源预留、优化路径资源预留、切换预留、路径融合等一系列新机制.仿真实验结果表明,与其他移动环境中的RSVP扩展方案相比,该Fast RSVP方案在支持无线移动通信方面具有如下优势:(1)能够实现移动节点带有服务质量保证的快速切换;(2)能够避免移动IP切换过程中三角路由和重复预留造成的资源浪费;(3)能够区分不同类型的切换预留请求,在保证网络整体性能的前提下显著降低因为切换而导致的服务中断率.     

HRTEM studies of NiNbZr + Ag amorphous-nanocrystalline composites

Amorphous powder of composition corresponding to Ni60Ti20Zr20 (in at%) was obtained by ball milling in a high-energy mills starting from pure elements. Formation of the amorphous structure was observed already after 20 h of milling, although complete amorphization occurred after 40 h. The microhardness of powders increased from about 30 HV for pure elements to above 400 HV (1290 MPa) after 40 h of milling. Transmission electron microscopy (TEM) allowed to identify nanocrystalline inclusions of intermetallic phases of size 2–10 nm. Uniaxial hot pressing was performed in vacuum at temperature below the crystallization T_x it is 510°C and pressure of 600 MPa, Mixed amorphous powders and nanocrystalline silver powders were used to form a composite, in which microhardness was near 970 MPa HV and 400 HV for the amorphous phase and nanocrystalline silver, respectively. The compression strength of the composite containing 20 wt% of nanocrystalline Ag powder was equal to 600 MPa and plastic strain was 2%. Microstructure studies showed low porosity of composites of less than 1%, uniform distribution of the silver phase and a transition zone between both components, about 150 nm thick, where diffusion of nickel, niobium and zirconium into silver was observed. High-resolution TEM allowed identifying the structure of nanocrystalline inclusions in the amorphous matrix after hot pressing as either Ni₃Zr or Ni₁₇Nb₃. The identification was performed basing on measurements of angles and interatomic distances using inverse Fourier transformed images with enhanced contrast using Digital Micrograph computer program.     

Malignant Ascites Promote Adhesion of Ovarian Cancer Cells to Peritoneal Mesothelium and Fibroblasts

Although malignant ascites (MAs) are known to contribute to various aspects of ovarian cancer progression, knowledge regarding their role in the adhesion of cancer cells to normal peritoneal cells is incomplete. Here, we compared the effect of MAs and benign ascites (BAs) on the adhesion of A2780 and OVCAR-3 cancer cells to omentum-derived peritoneal mesothelial cells (PMCs) and peritoneal fibroblasts (PFBs). The results showed that MAs stimulated the adhesion of A2780 and OVCAR-3 cells to PMCs and PFBs more efficiently than did BAs, and the strongest binding occurred when both cancer and normal cells were exposed to the fluid. Intervention studies showed that MAs-driven adhesion of A2780 cells to PMCs/PFBs depends on the presence of TGF-β1 and HGF, whereas binding of OVCAR-3 cells was mediated by TGF-β1, GRO-1, and IGF-1. Moreover, MAs upregulated α5β1 integrin expression on PFBs but not on PMCs or cancer cells, vimentin expression in all cells tested, and ICAM-1 only in cancer cells. When integrin-linked kinase was neutralized in PMCs or PFBs, cancer cell adhesion to PMCs and PFBs decreased. Collectively, our report shows that MAs may contribute to the early stages of ovarian cancer metastasis by modulating the proadhesive interplay between normal and cancer cells.     

Microstructure of ball milled and compacted Co–Ni–Al alloys from the β range

Two powder alloys from the β phase region of compositions Co_28.5Ni_36.5Al₃₅ and Co₃₅Ni₃₀Al₃₅ were ball milled for 80 h in a high energy ball mill. The formation of amorphous structure was observed after 40 h of milling and further milling did not change their structure. The analytical and high-resolution transmission electron microscopy (TEM, HREM) examination of powder structure showed that nanoparticles of  L1₀ phase of size of about 5 nm were present within the amorphous matrix. The vacuum hot pressing of the milled powders under pressure of 400 MPa at 700°C for 12 min resulted in the formation of compacts with density of about 70% of the theoretical one. The additional heat treatment at 1300°C for 6 h followed by water quenching, led to significant improvement of density and induced the martensitic transformation manifested by a broad heat effect. The characteristic temperatures of the transformation were determined using DSC measurements, which revealed only small differences within the examined alloys compositions. TEM structure studies of heat-treated alloys allowed to identify the structure of an ordered β (B2) phase and L1₀ martrensite.     

Byte-code scheduling of Java programs with branches for desktop grid

A method for an introductory optimization of multithreaded Java programs for execution on clusters of Java Virtual Machines (JVMs) inside desktop grids is presented. It is composed of two stages. In the first stage, a clustering algorithm is applied to extended macro data flow graphs generated on the basis of the byte-code compiled for multithreaded Java programs. These graphs account for data and control dependencies in programs including conditional branch instructions annotated by branch statistics driven from execution traces for representative sets of data. In the second stage, a list scheduling is performed based on the Earliest Task First (ETF) heuristics in which node mapping on JVMs accounts for mutually exclusive paths outgoing from conditional branch nodes. The presented object placement optimization algorithm is a part of the DG-ADAJ environment.