Influence of the Impaction Angle on the Triboelectric Charging of Aerosol Nanoparticles

A low pressure impactor is used to measure triboelectric charging behavior of metallic nanoparticles. Ag nanoparticles, produced by spark discharge, were impacted onto Pt sputtered targets. The influence of the impaction angle and impaction velocity on the triboelectric charging was investigated. While for perpendicular impaction the charge transfer behavior of previous work was confirmed, the oblique impaction revealed new phenomena. Additional charge transfer was observable, which increases with obliqueness. The possibility of mass transfer between particle and target due to the high-energy collisions was also investigated. SEM characterization and Auger spectroscopy indicate mass transfer from the particle to the target surface.     

A new approach to evaluating the toxicity and genotoxicity of disinfected drinking water

The aim of this study was to evaluate the formation of toxic and genotoxic compounds in surface drinking waters treated with two widely used disinfectants, sodium hypochlorite (NaClO) and chlorine dioxide (ClO(2)), and a new disinfectant, peracetic acid (PAA). For this purpose a pilot plant was set up to add these biocides continuously to pre-filtered lake water flowing into three different basins. During three seasonal experiments, short-term in vivo tests (with plant, fish and molluscs) and in vitro tests (with bacteria, yeast and human cells) were carried out to evaluate the formation of genotoxic disinfection by-products (DBPs). Gas chromatography/mass spectrometry (GC/MS) was used to identify DBPs produced during the different treatments, microbiological analyses were performed to test the biocidal activity of the disinfectants, and chemical analyses were carried out to evaluate the quality of the water. The pilot drinking water plant under study was useful in studying the toxicity and genotoxicity of disinfected drinking water with this combined chemical/biotoxicological approach. This paper describes the setting up of the pilot plant and sets out/reports the results of the microbiological and chemical analyses.     

Sub-micrometer particulate air pollution and cardiovascular mortality in Beijing, China

Background

While the link between particulate matter and cardiovascular mortality is well established, it is not fully investigated and understood which properties of the aerosol might be responsible for the health effects, especially in polluted mega-city areas.

Objectives

Our goal was to explore the association between daily cardiovascular mortality and different particle metrics in the sub-micrometer range in Beijing, China.

Methods

We obtained daily counts of cause-specific cardiovascular deaths in the Beijing urban area for the period March 2004 to August 2005. Concurrently, continuous measurements of particle number size distributions were performed. Particle number concentrations (NC) between 0.003 μm and 0.8 μm were converted to particle mass and surface area concentrations assuming spherical particles. Semi-parametric Poisson regression models adjusting for trend, seasonality, day of the week, and meteorology were used to estimate immediate, delayed and cumulative particle effects. Additionally, effect modification by air mass origin was investigated.

Results

We observed associations between daily cardiovascular mortality and particle NC for a 2-days delay. Moreover, nearly all particle metrics showed 2-days delayed associations with ischemic heart disease mortality. The strongest association was found for particle NC in the size range 0.03-0.1 μm (7.1% increase in daily mortality with a 95%-confidence interval of 2.9%-11.5%, per an increase of 6250 particles/cm³). Results for surface and mass concentrations with a lag of two days indicated effect modification by air mass origin, whereas effects of particle NC were not modified.

Conclusions

Results show an elevated risk of cardiovascular mortality in Beijing from short-term exposure to particulate air pollution in the sub-micrometer range. Results also indicate that locally produced smaller particles and regionally transported particles may exhibit different effects in Beijing.     

Identification of Components of the Aggregation Pheromone of the Guam Strain of Coconut Rhinoceros Beetle,Oryctes rhinoceros,and Determination of Stereochemistry

The coconut rhinoceros beetle, Oryctes rhinoceros (Linnaeus 1758) (Coleoptera: Scarabaeidae: Dynastinae) (CRB), is endemic to tropical Asia where it damages both coconut and oil palm. A new invasion by CRB occurred on Guam in 2007 and eradication attempts failed using commonly applied Oryctes rhinoceros nudivirus (OrNV) isolates. This and subsequent invasive outbreaks were found to have been caused by a previously unrecognized haplotype, CRB-G, which appeared to be tolerant to OrNV. The male-produced aggregation pheromone of the endemic, susceptible strain of O. rhinoceros (CRB-S) was previously identified as ethyl 4-methyloctanoate. Following reports from growers that commercial lures containing this compound were not attractive to CRB-G, the aim of this work was to identify the pheromone of CRB-G. Initial collections of volatiles from virgin male and female CRB-G adults from the Solomon Islands failed to show any male- or female-specific compounds as candidate pheromone components. Only after five months were significant quantities of ethyl 4-methyloctanoate and 4-methyloctanoic acid produced by males but not by females. No other male-specific compounds could be detected, in particular methyl 4-methyloctanoate, 4-methyl-1-octanol, or 4-methyl-1-octyl acetate, compounds identified in volatiles from some other species of Oryctes. Ethyl 4-methyloctanoate elicited a strong electroantennogram response from both male and female CRB-G, but these other compounds, including 4-methyloctanoic acid, did not. The enantiomers of ethyl 4-methyloctanoate and 4-methyloctanoic acid were conveniently prepared by enzymatic resolution of the commercially-available acid, and the enantiomers of the acid, but not the ester, could be separated by gas chromatography on an enantioselective cyclodextrin phase. Using this approach, both ethyl 4-methyloctanoate and 4-methyloctanoic acid produced by male CRB-G were shown to be exclusively the (R)-enantiomers whereas previous reports had suggested male O. rhinoceros produced the (S)-enantiomers. However, re-examination of the ester and acid produced by male CRB-S from Papua New Guinea showed that these were also the (R)-enantiomers. In field trapping experiments carried out in the Solomon Islands, both racemic and ethyl (R)-4-methyloctanoate were highly attractive to both male and female CRB-G beetles. The (S)-enantiomer and the corresponding acids were only weakly attractive. The addition of racemic 4-methyloctanoic acid to ethyl 4-methyloctanoate did significantly increase attractiveness, but the addition of (R)- or (S)-4-methyloctanoic acid to the corresponding ethyl esters did not. Possible reasons for the difference in assignment of configuration of the components of the CRB pheromone are discussed along with the practical implications of these results.

     

Removal of emerging contaminants of concern by alternative adsorbents

The effective removal of emerging contaminants of concern (ECCs) such as endocrine-disrupting chemicals, pharmaceutically active compounds, personal care products, and flame retardants is a desirable water treatment goal. In this study, one activated carbon, one carbonaceous resin, and two high-silica zeolites were studied to evaluate their effectiveness for the removal of an ECC mixture from lake water. Adsorption isotherm experiments were performed with a mixture of 28 ECCs at environmentally relevant concentrations (200–900 ng/L). Among the tested adsorbents, activated carbon was the most effective, and activated carbon doses typically used for taste and odor control in drinking water (<10 mg/L) were sufficient to achieve a 2-log removal for most of the tested ECCs. The carbonaceous resin was less effective than the activated carbon because this adsorbent had a smaller volume of pores in the size range required for the adsorption of many ECCs (6–9 Å). For the removal of ECC mixture constituents, zeolites were less effective than the carbonaceous adsorbents. Because zeolites contain pores of uniform size and shape, a few of the tested ECCs with matching pore size/shape requirements were well removed, but the adsorptive removal of others was negligible, even at zeolite doses of 100 mg/L. The results of this study demonstrate that effective adsorbents for the removal of a broad spectrum of ECCs from water should exhibit heterogeneity in pore size and shape and a large pore volume in the 6–9 Å size range.     

Visualisierung der Partikelbewegung in einem Abweiseradsichter

In spite of its great importance for the dry classification of fine powders, the processes in deflector wheel classifiers are to a large extent unknown. Therefore, in the present work a commercial available classifier was modified to gain an optical access to the deflector wheel. For the first time, the obtained photographs enable an observation of the gas flow and the particle motion between the blades of the deflector wheel. Especially the importance of particle‐particle‐ and particle‐blade‐collisions could be shown.     

Analysis‐preserving video microscopy compression via correlation and mathematical morphology

The large amount video data produced by multi‐channel, high‐resolution microscopy system drives the need for a new high‐performance domain‐specific video compression technique. We describe a novel compression method for video microscopy data. The method is based on Pearson's correlation and mathematical morphology. The method makes use of the point‐spread function (PSF) in the microscopy video acquisition phase. We compare our method to other lossless compression methods and to lossy JPEG, JPEG2000, and H.264 compression for various kinds of video microscopy data including fluorescence video and brightfield video. We find that for certain data sets, the new method compresses much better than lossless compression with no impact on analysis results. It achieved a best compressed size of 0.77% of the original size, 25× smaller than the best lossless technique (which yields 20% for the same video). The compressed size scales with the video's scientific data content. Further testing showed that existing lossy algorithms greatly impacted data analysis at similar compression sizes. Microsc. Res. Tech. 78:1055–1061, 2015. © 2015 Wiley Periodicals, Inc.     

Trans-Splicing Improvement by the Combined Application of Antisense Strategies

Spliceosome-mediated RNA trans-splicing has become an emergent tool for the repair of mutated pre-mRNAs in the treatment of genetic diseases. RNA trans-splicing molecules (RTMs) are designed to induce a specific trans-splicing reaction via a binding domain for a respective target pre-mRNA region. A previously established reporter-based screening system allows us to analyze the impact of various factors on the RTM trans-splicing efficiency in vitro. Using this system, we are further able to investigate the potential of antisense RNAs (AS RNAs), presuming to improve the trans-splicing efficiency of a selected RTM, specific for intron 102 of COL7A1. Mutations in the COL7A1 gene underlie the dystrophic subtype of the skin blistering disease epidermolysis bullosa (DEB). We have shown that co-transfections of the RTM and a selected AS RNA, interfering with competitive splicing elements on a COL7A1-minigene (COL7A1-MG), lead to a significant increase of the RNA trans-splicing efficiency. Thereby, accurate trans-splicing between the RTM and the COL7A1-MG is represented by the restoration of full-length green fluorescent protein GFP on mRNA and protein level. This mechanism can be crucial for the improvement of an RTM-mediated correction, especially in cases where a high trans-splicing efficiency is required.