In-fibre LP11–LP21 mode conversion using force-induced long-period fibre gratings with polarization controllers

ABSTRACT

Mode conversion between higher-order modes is attained in a step-index four mode fibre using an in-line polarization controller followed by a force-induced long period fibre grating. By adjusting the field orientation of the LP₁₁ mode to the antisymmetric fibre grating, the LP₁₁ mode is converted to the LP₂₁ mode with a spatially periodic force of 50 N along the fibre length of 50?mm. The mode conversion is evaluated by observing the far-field and near-field patterns of the fibre output and by comparing the transmitted optical power with and without the additional two-mode fibre. The phase-matching grating period is required of the accuracy of roughly ±5?μm and the radiation loss during the mode conversion is as low as 0.01?dB.     

Ionization efficiency of evolved gas molecules from aerosol particles in a thermal desorption aerosol mass spectrometer: Laboratory experiments

Thermal desorption aerosol mass spectrometers (TDAMSs) with electron ionization are widely used for quantitative analysis of aerosol chemical composition, and the ionization efficiency of evolved gas molecules from aerosol particles is an important parameter for such analysis. We performed laboratory experiments using a custom-made TDAMS to investigate the key factors affecting ionization efficiency. Ammonium chloride (NH₄Cl) and ammonium iodide (NH₄I) were used as test compounds because their thermal decomposition products are expected to be simple (dominated by ammonia (NH₃) and hydrogen halide (HX)). The ion signals originating from NH₃ and HX were measured by altering the position of the ionizer relative to the vaporization point. The ratio of ion signal from NH₃ to that from HX increased with increasing divergence angle of evolved gas plumes, which suggests that the angular distribution of gas molecules could be an important factor affecting the ionization efficiency.

Copyright © 2018 American Association for Aerosol Research     

Diffusion Magnetic Resonance Imaging-Based Biomarkers for Neurodegenerative Diseases

There has been an increasing prevalence of neurodegenerative diseases with the rapid increase in aging societies worldwide. Biomarkers that can be used to detect pathological changes before the development of severe neuronal loss and consequently facilitate early intervention with disease-modifying therapeutic modalities are therefore urgently needed. Diffusion magnetic resonance imaging (MRI) is a promising tool that can be used to infer microstructural characteristics of the brain, such as microstructural integrity and complexity, as well as axonal density, order, and myelination, through the utilization of water molecules that are diffused within the tissue, with displacement at the micron scale. Diffusion tensor imaging is the most commonly used diffusion MRI technique to assess the pathophysiology of neurodegenerative diseases. However, diffusion tensor imaging has several limitations, and new technologies, including neurite orientation dispersion and density imaging, diffusion kurtosis imaging, and free-water imaging, have been recently developed as approaches to overcome these constraints. This review provides an overview of these technologies and their potential as biomarkers for the early diagnosis and disease progression of major neurodegenerative diseases.     

Dimeric C34 Derivatives Linked through Disulfide Bridges as New HIV-1 Fusion Inhibitors

C34, a 34-mer fragment peptide, is contained in the HIV-1 envelope protein gp41. A dimeric derivative of C34 linked through a disulfide bridge at its C terminus was synthesized and found to display potent anti-HIV activity, comparable with that of a previously reported PEGylated dimer of C34REG. The reduction in the size of the linker moiety for dimerization was thus successful, and this result might shed some light on the mechanism of the suppression of six-helix bundle formation by these C34 dimeric derivatives. Addition of a Gly-Cys(CH₂CONH₂)-Gly-Gly motif at the N-terminal position of a C34 monomeric derivative significantly increased the anti-HIV-1 activity. This moiety functions as a new pharmacophore, and this might provide a useful insight into the design of potent HIV-1 fusion inhibitors.     

Design of the shield tunnel for the trans-Tokyo bay highway

The Trans-Tokyo Bay Highway project is the first phase of an ambitious plan to connect Kawasaki and Chiba by a 15-km crossing of Tokyo Bay. The crossing involves a 5-km bridge, a 10-km undersea tunnel, and a manmade island in the middle of the bay. The construction method for the undersea tunnel must take into account the large external diameter of the primary lining (approx. 14 m); the extremely soft ground under the sea; the extremely high water pressure to which the tunnel will be subjected; and active seismic conditions in the Tokyo Bay area. This paper discusses the slurry shield tunnelling method adopted for the undersea tunnel portion of the project.     

Nonsalt 1‐(arylmethyloxy)pyrene photoinitiators capable of initiating cationic polymerization

Analysis of photoproducts derived from 1‐(methoxynaphthalen‐1‐ylmethyloxy)pyrene initiators and polymer end groups demonstrated that methoxynaphthalen‐1‐ylmethyl carbocation is involved in the initiation steps for both styrene (St) and cyclohexene oxide (CHO) polymerization. Charge transfer from the pyrenyloxy oxygen atom to the methoxynaphthalen‐1‐ylmethyl chromophore in the singlet excited state is assumed to be responsible for the efficient generation of the carbocation species, which also initiates the copolymerization of St and CHO. © 2014 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2014 , 131, 40510.     

Morphology and crystallization behavior of nylon 6‐clay/neat nylon 6 bicomponent nanocomposite fibers

Nylon 6‐clay hybrid/neat nylon 6, sheath/core bicomponent nanocomposite fibers containing 4 wt % of clay in sheath section, were melt spun at different take‐up speeds. Their molecular orientation and crystalline structure were compared to those of neat nylon 6 fibers. Moreover, the morphology of the bicomponent fibers and dispersion of clay within the fibers were analyzed using scanning electron microscopy and transmission electron microscopy (TEM), respectively. Birefringence measurements showed that the orientation development in sheath part was reasonably high while core part showed negligibly low birefringence. Results of differential scanning calorimetry showed that crystallinity of bicomponent fibers was lower than that of neat nylon 6 fibers. The peaks of γ‐crystalline form were observed in the wide‐angle X‐ray diffraction of bicomponent and neat nylon 6 fibers in the whole take‐up speed, while α‐crystalline form started to appear at high speeds in bicomponent fibers. TEM micrographs revealed that the clay platelets were individually and evenly dispersed in the nylon 6 matrix. The neat nylon 6 fibers had a smooth surface while striped pattern was observed on the surface of bicomponent fibers containing clay. This was speculated to be due to thermal shrinkage of the core part after solidification of the sheath part in the spin‐line. © 2013 Wiley Periodicals, Inc. J. Appl. Polym. Sci., 2014 , 131, 39996.     

Multi-class grasping classifiers using EEG data and a common spatial pattern filter

This paper describes the classification of various human actions from brain activity. In particular, we focus on grasping movements and estimate grasping patterns from electroencephalogram (EEG) data. EEG data is converted to grasping features by using a common spatial pattern filter (CSP filter), and the features are subsequently classified into grasping categories by using the k-nearest neighbor method. We tested the pipeline of feature extraction and classification on the EEG dataset. The EEG data were acquired while participants grasped an object according to the Cutkosky’s grasping taxonomy, in which grasping movements are categorized into nine power-type grasping patterns and seven precision-type grasping patterns. The best classification rate for 9-class power-type grasping patterns was 48% and for 7-class precision-type grasping patterns was 40%.