Controlling thickness to tune performance of high-mobility transparent conducting films deposited from Ga-doped ZnO ceramic target

Structure modification has been found to tune significantly the transparent-conducting performance, especially mobility and conductivity of hydrogenated Ga-doped ZnO (HGZO) films. The strong correlation between film thickness and mobility of the films is revealed. The mobility increases quickly with increasing the thickness from 350 to 900 nm, and then tends to be saturated at further thicknesses. A higher mobility than 50 cm²/Vs can be achieved, which is an extra-high value for polycrystalline ZnO films deposited by using the sputtering technique. The thickness-dependent mobility originates from scatterings on grain boundaries and dislocation-induced defects controlled by thin-film growth. Based on the Volmer-Weber model, an expansion model is built up to describe the thickness-dependent crystal growth of the HGZO films, especially at the thick films. As a result, the 800 nm-thick HGZO film obtains the highest performance with high mobility of 51.5 cm²/Vs, low resistivity of 5.3 × 10^?4 Ωcm, and good transmittance of 83.3 %.     

Photocatalytic degradation and heat reflectance recovery of waterborne acrylic polymer/ZnO nanocomposite coating

This work aims to clarify the photocatalytic degradation mechanism and heat reflectance recovery performance of waterborne acrylic polymer/ZnO nanocomposite coating. To fabricate the nanocomposite coating, ZnO nanoparticles (nano-ZnO) were dispersed into acrylic polymer matrix at the various concentrations from 1 to 6% (by total weight of resin solids). The photocatalytic degradation of nanocomposite coating under ultraviolet (UV) light irradiation has been investigated by monitoring its weight loss and chemical/microstructural/morphological changes. As the topcoat layer, its heat reflectance recovery has been evaluated under UV/condensation exposure by using an artificial dirty mixture of 85 wt% nanoclay, 10 wt% silica particles (1–5 μm), 1 wt% carbon black, and 2 wt% engine oil. After 108-cycle UV/condensation exposure, infrared spectra and weight loss analysis indicated that the maximal degradation for nanocomposite coating is observed at 1 wt% nano-ZnO. On the other hand, after 96 hr of UV light exposure, the nanocomposite coating with1 wt% nano-ZnO could restore effectively the reflective index of solar-heat reflectance coating (from 58.45 to 80.78%). Finally, the photodegradation mechanism of this waterborne acrylic polymer coating has been proposed as the UV-induced formation of CC CO conjugated double bonds. As a result, its self-cleaning phenomenon can be achieved as the recovery of heat reflectance.     

Carbonaceous microsphere-based superabsorbent polymer as filler for coating of NPK fertilizer: Fabrication,properties, swelling,and nitrogen release characteristics

Recently, the use of controlled release fertilizers in agriculture has resulted in huge benefits in plant growth and cultivation. Superabsorbent polymer (SAP)-coated fertilizers have the added advantage in retaining water in soil after irrigation and also reduce the nutrient release rate from soil in a controlled manner. This study aimed to produce a nitrogen–phosphorus–potassium (NPK) fertilizer coated with superabsorbent carbonaceous microspheres polymer (SPC) by inverse suspension polymerization method with water-retention and controlled release properties. Two sets of experiments were conducted: (1) three different weight percentages and (2) different materials. NPK coated with SPC showed increasing water-retention ability with respect to carbon microsphere percentages and retains >80% water at the 30th day of experiment compared with pure NPK and NPK coated with SAP. The slow release behavior of all samples was investigated by induced coupled plasma mass spectrometry spectrometry and results showed that NPK coated with SAP and SPC has a low release rate with <50% nutrient release compared with uncoated NPK at the 30th day. The release mechanism kinetics of NPK coated with SAP and SPC were studied based on the Kosmeyer–Peppas model. The mechanisms approached Fickian diffusion-controlled release as the n value for both samples was less than 0.5. © 2019 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2020 , 137, 48396.     

Synthesis and Application of Novel Nano Fe-BTC/GO Composites as Highly Efficient Photocatalysts in the Dye Degradation

Topics in Catalysis - Nano Fe-BTC/graphene oxide (GO) composites were successfully synthesized by hydrothermal treatment with a microwave-assisted method. Samples were characterized by X-ray...     

Multi-functional biochip for medical diagnostics and pathogen detection

We describe a multi-functional biochip (MFB), which uses two different types of bioreceptors, including nucleic acid and antibody probes, on a single platform. The multi-functional capability of the MFB device for biomedical diagnostics is illustrated by measurements of DNA probes specific to gene fragments of Bacillus anthracis and antibody probes targeted to Escherichia coli. Calibration curves for monitoring pathogenic species using antibody probes against E. coli and DNA probes for B. anthracis illustrate the capability of the device for medical diagnostics and for quantitative detection of pathogenic agents.     

A Comprehensive Performance Analysis of Random Early Detection Mechanism

One of the most promising active queue management schemes being proposed for deployment in the Internet is the Random Early Detection (RED) scheme. However, research results on RED performance are highly mixed, especially in the field of tuning its parameters. In this paper, a comprehensive performance analysis of RED is presented. We revisit some features in RED and study them in greater detail. We point out that RED, in general, does not possess proportional loss between flows as claimed and widely adopted in previous research. We suggest the generalization of the PASTA property and give a proof for TCP flows. We also evaluate the performance of the Exponential Weighted Moving Average (EWMA) algorithm in RED. We find that EWMA in RED is an unbiased estimator of the average queue-length, regardless of the weighting value w _q . We also point out the theoretical and practical limits of EWMA in RED. Finally, we propose the use of fuzzy EWMA to RED (fuzzy RED) to alleviate the inflexibility of RED tuning. We use simulations to evaluate the performance of fuzzy RED and compare it with other versions of RED. Our simulations show that, in the case of a high workload and a high level of variation, fuzzy RED, by tracking system variation in an on-line manner, improves RED performance in a number of important router-based metrics like packet loss rate, average queueing delay, link utilization, and global power.     

Integrating local action elements for action analysis

In this paper, we propose a framework for human action analysis from video footage. A video action sequence in our perspective is a dynamic structure of sparse local spatial–temporal patches termed action elements, so the problems of action analysis in video are carried out here based on the set of local characteristics as well as global shape of a prescribed action. We first detect a set of action elements that are the most compact entities of an action, then we extend the idea of Implicit Shape Model to space time, in order to properly integrate the spatial and temporal properties of these action elements. In particular, we consider two different recipes to construct action elements: one is to use a Sparse Bayesian Feature Classifier to choose action elements from all detected Spatial Temporal Interest Points, and is termed discriminative action elements. The other one detects affine invariant local features from the holistic Motion History Images, and picks up action elements according to their compactness scores, and is called generative action elements. Action elements detected from either way are then used to construct a voting space based on their local feature representations as well as their global configuration constraints. Our approach is evaluated in the two main contexts of current human action analysis challenges, action retrieval and action classification. Comprehensive experimental results show that our proposed framework marginally outperforms all existing state-of-the-arts techniques on a range of different datasets.     

Personalized identification of abdominal wall hernia meshes on computed tomography

An abdominal wall hernia is a protrusion of the intestine through an opening or area of weakness in the abdominal wall. Correct pre-operative identification of abdominal wall hernia meshes could help surgeons adjust the surgical plan to meet the expected difficulty and morbidity of operating through or removing the previous mesh. First, we present herein for the first time the application of image analysis for automated identification of hernia meshes. Second, we discuss the novel development of a new entropy-based image texture feature using geostatistics and indicator kriging. Third, we seek to enhance the hernia mesh identification by combining the new texture feature with the gray-level co-occurrence matrix feature of the image. The two features can characterize complementary information of anatomic details of the abdominal hernia wall and its mesh on computed tomography. Experimental results have demonstrated the effectiveness of the proposed study. The new computational tool has potential for personalized mesh identification which can assist surgeons in the diagnosis and repair of complex abdominal wall hernias.