Experimental study on mitigating wind erosion of calcareous desert sand using spray method for microbially induced calcium carbonate precipitation

Wind erosion is one of the significant natural calamities worldwide, which degrades around one-third of global land. The eroded and suspended soil particles in the environment may cause health hazards, i.e. allergies and respiratory diseases, due to the presence of harmful contaminants, bacteria, and pollens. The present study evaluates the feasibility of microbially induced calcium carbonate precipitation (MICP) technique to mitigate wind-induced erosion of calcareous desert sand (Thar desert of Rajasthan province in India). The temperature during biotreatment was kept at 36 °C to stimulate the average temperature of the Thar desert. The spray method was used for bioaugmentation of Sporosarcina (S.) pasteurii and further treatment using chemical solutions. The chemical solution of 0.25 pore volume was sprayed continuously up to 5 d, 10 d, 15 d, and 20 d, using two different concentration ratios of urea and calcium chloride dihydrate viz 2:1 and 1:1. The biotreated samples were subjected to erosion testing (in the wind tunnel) at different wind speeds of 10 m/s, 20 m/s, and 30 m/s. The unconfined compressive strength of the biocemented crust was measured using a pocket penetrometer. The variation in calcite precipitation and microstructure (including the presence of crystalline minerals) of untreated as well as biotreated sand samples were determined through calcimeter, scanning electron microscope (SEM), and energy-dispersive X-ray spectroscope (EDX). The results demonstrated that the erosion of untreated sand increases with an increase in wind speeds. When compared to untreated sand, a lower erosion was observed in all biocemented sand samples, irrespective of treatment condition and wind speed. It was observed that the sample treated with 1:1 cementation solution for up to 5 d, was found to effectively resist erosion at a wind speed of 10 m/s. Moreover, a significant erosion resistance was ascertained in 15 d and 20 d treated samples at higher wind speeds. The calcite content percentage, thickness of crust, bulk density, and surface strength of biocemented sand were enhanced with the increase in treatment duration. The 1:1 concentration ratio of cementation solution was found effective in improving crust thickness and surface strength as compared to 2:1 concentration ratio of cementation solution. The calcite crystals formation was observed in SEM analysis and calcium peaks were observed in EDX analysis for biotreated sand.     

Modeling unaccounted-for gas among residential natural gas consumers using a comprehensive fuzzy cognitive map

Residential natural gas consumption depends on several factors. Available tools and methods to identify, categorize, and validate effective factors have some limitations, making consumption modeling more complex. Once a comprehensive model of effective consumption factors is developed for residential gas consumers, it can predict consumption. In addition, such a model could be used to verify the accuracy of measuring devices in order to reduce unaccounted for gas (UFG). The key factors affecting residential gas consumption were identified based on previous studies and their mutual effects were analyzed using a fuzzy cognitive mapping (FCM) method. The most significant factors and their effects on natural gas consumption in the residential sector were determined. In this study, for the first time, the expected consumption for each consumer was estimated using a consumption index. Generally, if the estimated consumption is significantly different from the amount recorded by the meter, it could suggest a potential source of UFG. The proposed method was applied to the data collected from the residential gas consumers of a small region in Iran (Dasht-e Arjan region, Fars province), and the results demonstrate the effectiveness of the proposed method.     

综放面本煤层预抽瓦斯的治理技术

为了极大限度地提高本煤层预抽效果，以马兰煤矿为研究对象，针对目前马兰煤矿的瓦斯赋存情况和现阶段所采取的抽放措施，从抽放钻孔的孔径、孔深、布置方式、封孔质量和增加煤层透气性等方面进行探索。实践表明，以上方法的运用，能够有效地提高本煤层预抽抽放效果，保证工作面安全生产。     

磁悬浮控制力矩陀螺高速转子的高精度位置控制

在受到陀螺效应、动框架效应等影响后产生的磁力非线性问题是磁悬浮控制力矩陀螺(MSCMG)高速转子位置精度下降的主要因素。为解决以上问题,提高转子位置精度,本文分析了转子所受磁力的特性,建立了转子系统非线性动力学模型,提出了神经网络滑模控制方法。设计滑模控制律,采用径向基函数神经网络逼近控制律中的非线性模型,自适应算法根据误差在线调整神经网络的权值,同时可以保证整个系统的稳定性。仿真和实验结果表明,所提出方法的转子位置精度达到99%,稳态误差为0.000 2 mm。神经网络滑模控制可以实现MSCMG转子系统的高精度位置控制。     

基于DSP的智能电源控制单元设计与实现

本文利用TI公司TMS320F28335芯片高效的浮点运算能力,结合片上丰富的外设,设计并实现了一种具有高可靠性的智能电源控制单元。该控制单元周期性地对各片上外设进行自检维护,完成多路负载通道控制、电压、电流的实时监控,并对故障进行指示、处理和上报,同时提供人机交互界面更新状态信息。经过验证,该控制单元工作稳定,具备良好的工程应用价值。     

Optimized PI+ load–frequency controller using BWNN approach for an interconnected reheat power system with RFB and hydrogen electrolyser units

This paper investigates a renewable energy resource’s application to the Load–Frequency Control of interconnected power system. The Proportional-Integral (PI) controllers are replaced with Proportional-Integral Plus (PI+) controllers in a two area interconnected thermal power system without/with the fast acting energy storage devices and are designed based on Control Performance Standards (CPS) using conventional/Beta Wavelet Neural Network (BWNN) approaches. The energy storing devices Hydrogen generative Aqua Electroliser (HAE) with Fuel cell and Redox Flow Battery (RFB) are incorporated to the two area interconnected thermal power system to efficiently damp out the electromechanical oscillations in the power system because of their inherent efficient storage capacity in addition to the kinetic energy of the generator rotor, which can share the sudden changes in power requirements. The system was simulated and the frequency deviations in area 1 and area 2 and tie-line power deviations for 5% step- load disturbance in area 1 are obtained. The comparison of frequency deviations and tie-line power deviations of the two area interconnected thermal power system with HAE and RFB designed with BWNN controller reveals that the PI+ controller designed using BWNN approach is found to be superior than that of output response obtained using PI+ controller. Moreover the BWNN based PI+ controller exhibits a better transient and steady state response for the interconnected power system with Hydrogen generative Aqua Electroliser (AE) unit than that of the system with Redox Flow Battery (RFB) unit.     

铜浮选专家控制系统设计与应用

针对国内某选矿厂铜浮选工艺泡沫速率不稳定,精矿品位波动大,回收率不理想等特点,设计了一套浮选专家控制系统,该系统结合泡沫影像分析技术,在线品位分析技术,PID控制与模糊逻辑控制技术。系统架构简明合理,逻辑层次清晰有效,投入运行一段时间后,在不同原矿品位前提下,都能实现稳定泡沫速率,减少精矿品位波动,提高回收率等指标优化,同时药剂添加量也有明显减少。这表明该系统运行效果良好,值得应用推广。     

A novel quasi-oppositional harmony search algorithm and fuzzy logic controller for frequency stabilization of an isolated hybrid power system

The intermittent wind power in isolated hybrid distributed generation (IHDG) may cause serious problems associated with frequency (f) and power (P) fluctuation. Energy storage devices such as battery, super capacitor, and superconducting magnetic energy storage (SMES) may be used to reduce these fluctuations associated with f and P. This paper presents a study of IHDG power system for improving both f and P deviation profiles with the help of SMES. The studied IHDG power system is consisted of wind turbine generator and diesel engine generator. Both f and P control problems of the studied power system model are addressed in presence or absence of SMES. Fuzzy logic based proportional–integral–derivative (PID) controller with SMES is used for the purpose of minimization of f and P deviations. The different tunable parameters of the PID controller and those of the SMES are tuned by a novel quasi-oppositional harmony search algorithm. Performance study of the IHDG power system model is carried out under different perturbation conditions. The results demonstrate minimum f and P deviations may be achieved by using the proposed fuzzy logic based PID controller along with SMES.     

Genetic algorithm and self organizing map based fuzzy hybrid intelligent method for color image segmentation

The grouping of pixels based on some similarity criteria is called image segmentation. In this paper the problem of color image segmentation is considered as a clustering problem and a fixed length genetic algorithm (GA) is used to handle it. The effectiveness of GA depends on the objective function (fitness function) and the initialization of the population. A new objective function is proposed to evaluate the quality of the segmentation and the fitness of a chromosome. In fixed length genetic algorithm the chromosomes have same length, which is normally set by the user. Here, a self organizing map (SOM) is used to determine the number of segments in order to set the length of a chromosome automatically. An opposition based strategy is adopted for the initialization of the population in order to diversify the search process. In some cases the proposed method makes the small regions of an image as separate segments, which leads to noisy segmentation. A simple ad hoc mechanism is devised to refine the noisy segmentation. The qualitative and quantitative results show that the proposed method performs better than the state-of-the-art methods.     

A公司C产品研发项目范围管理研究

通过分析A公司在研发项目范围管理中所存在问题,提出研发项目范围管理的方法及其在C产品的应用实例,通过运用研发项目范围管理的工具和方法,改善产品开发流程,从而缩短新产品开发周期,提高响应市场的速度,并提高企业研发项目的管理能力。