共查询到20条相似文献,搜索用时 31 毫秒
1.
根据旋压件等壁厚的要求,通过旋轮位置控制进行非圆截面零件旋压成形.运用MSC.ADAMS建立三面圆弧型等距截面零件运动模型,获得旋轮位移仿真数据,同时结合零件的几何结构,分析得到工作台两轴(x、z)的运动函数,拟合直线电机轴(S)运动仿真数据得到拟合函数,三轴联动共同合成旋压加工所需的旋轮运动轨迹.分析S轴拟合函数的误差分布情况,并加以补偿,通过matlab寻找拟合函数最优系数解,得到精度较高的运动轨迹函数.通过验证表明,拟合函数平均绝对误差随着偏距(2e)的减少而递减.当2e<7mm时,即发生圆直径2p<52.25mm时,平均绝对误差小于0.05. 相似文献
2.
本文按近似函数图解法的处理步骤,介绍了每步的数据处理方法和公式;提供了分析中常用的整套曲线图。其中,几何宽化校正曲线全套应是九种,目前仅有前五种,本工作完成了后四种几何宽化校正曲线的制作,并介绍了制作原理和方法;同时根据钢铁研究中的需要,对马氏体基、奥氏体基以及镍基合金材料的各种可能被采用的X射线衍射线对,并考虑到实验室中常用的五种辐射,绘制了35种单波法m,n分离曲线。 相似文献
3.
E. Gomaa N. Mostafa M. Mohsen A. S. Taha 《Journal of Materials Engineering and Performance》2003,12(2):190-195
Positron annihilation lifetime (PAL), Doppler broadening (DB), and Vickers microhardness measurements (Hv) were performed
to study the isochronal annealing of commercial pure Al (1050) in the temperature range from room temperature (RT) to 823
K after cold rolling at RT with various deformations of 16%, 37%, and 54%. PAL measurements show a decrease in the average
lifetime of positron (τ
av) followed by saturation at 190 ps as a function of annealing temperature. The results of Doppler broadening of annihilation
radiation (S and W parameters) are found to be consistent with PAL measurements. The correlation between the characteristics of positron annihilation
and Hv shows three annealing stages of microstructure in commercial Al, which are attributed to recovery, partial recrystallization,
and complete recrystallization. 相似文献
4.
本文讨论了物理宽化β分离嵌镶块尺寸D和点阵畸变ε引起宽化m和n时传统方法的困难;引入不变参数K~*后,发现作为K~*的函数,M和N具有参数r和s的不变性,提出测算D和ε的不变参数法。此法不仅简化了传统的法的计算,也解决了复杂的Cauchy-Gauss等几种还未解决过的算法。所给出的以K~*作为参数的M_1和N_1的图解曲线和直接计算公式,使得β分离为m和n变得十分容易。这些图表和公式不论是用于手工离线计算还是用于X射线衍射仪和计算机在线计算均十分有效。 相似文献
5.
6.
7.
8.
9.
10.
利用X射线衍射峰形分析方法,研究冷加工变形Pb-Ca-Sn合金的位错类型、密度和晶粒尺寸分布。结果表明:该合金的位错密度在1010cm-2数量级。衍射谱峰形的应变宽化可用位错对比因子来解释。利用新开发的PM2K软件包计算了晶粒尺寸。通过假设晶粒尺寸呈对数正态分布,利用X射线峰形分析得到的晶粒尺寸参数可得到晶粒分布函数。 相似文献
11.
系统地研究了La0.65Mg0.35Nix(x=3.0~3.5)储氢合金电极的自放电性能。结果表明,随着Ni含量的增加,合金电极最大放电容量从350.6mAh·g-1(x=3.0)增加到351.2mAh·g-1(x=3.1),然后减小到244.1mAh·g-1(x=3.5)。72h自放电的容量保持率从77.7%(x=3.0)增加到79.5%(x=3.1),然后又降低到63.5%(x=3.5)。说明适中的Ni含量有利于降低合金电极的自放电率。通过测量合金电极的P-C-T曲线和合金的腐蚀曲线分析了合金电极自放电性能的变化规律。 相似文献
12.
目的:在空腹和餐后条件下,评价两种苯磺酸氨氯地平片在中国健康受试者中的生物等效性。方法:入组24例健康受试者,采用随机、开放、两周期自身交叉试验设计,分别在空腹和餐后条件下给予受试制剂或参比制剂,用液质联用法(LC-MS/MS)测定给药后氨氯地平的血浆浓度,计算主要药代动力学参数,评价受试制剂与参比制剂的生物等效性。结果:健康受试者在空腹口服氨氯地平片后,受试制剂和参比制剂Cmax、AUC0-t、AUC0-∞的均值分别为(3 462.08±683.46) pg/mL、(159 891.00±45 951.00)pg·mL-1·h、(194 850.00±63 829.00) pg·mL-1·h和(3 346.09±710.09) pg/mL、(159 065.00±45 214.00) pg·mL-1·h、(190 461.00±66 160.00) pg·mL-1·h;几何均值的比值及其90%置信区间分别为104.82%(100.35%,109.50%)、103.32%(98.13%,108.78%)、103.98%(97.95%,110.38%)。餐后服用盐酸氨氯地平片后,受试制剂和参比制剂Cmax、AUC0-t、AUC0-∞的均值分别为(2 785.00±600.91) pg/mL、(138 289.00±30 684.00) pg·mL-1·h、(158 765.00±39 260.00) pg·mL-1·h和(2 960.00±671.27) pg/mL、(140 990.00±33 326.00) pg·mL-1·h、(163 996.00±43 606.00) pg·mL-1·h;几何均数的比值及其90%置信区间分别为94.89%(88.94%,101.23%)、97.96%(92.85%,103.34%)、97.26%(91.61%,103.25%)。结论:在空腹和餐后状态下受试制剂和参比制剂的吸收速度和程度均一致,两制剂生物等效,同时两制剂在中国健康受试人群中具有相似的安全性和耐受性。 相似文献
13.
本文求解了矩形长板镦粗时 (出现鼓肚 )的应力场。理论解析解表明 :水平应力 σx 等值曲线呈椭圆形 ;镦粗体内存在呈椭圆曲线界定的拉应力区。探讨了拉应力区与摩擦因子及镦粗体几何参数的关系。 相似文献
14.
15.
动态系统优化是过程设计、操作及控制的一个重要课题,但有效地求出其全局最优解是困难的.现今各种算法求解此问题时需要增强算法的优化性能和算法的简洁性;而遗传算法求此类问题时需要进行离散化,本文为此提出用粒子群复形法求解此类问题.此算法是在充分考虑粒子群算法与复形法的特性,保持复形法的迭代机理,同时加入粒子群算法基本思想,再结合几何分点、梯度与信赖域等的基础上提出的;以克服粒子群算法与复形法易陷局部极值的不足.性能测试的结果表明:该算法简便、可行、高效;最后将所提出的算法用于Park-Ramirez生物反应器补料流率的动态优化,也取得了满意的效果. 相似文献
16.
Gang Ji Daniel Goran Frdric Bernard Thierry Grosdidier Eric Gaffet Zuhair A. Munir 《Journal of Alloys and Compounds》2006,420(1-2):158-164
This paper aims to characterize a bulk dense FeAl (47 at.%) alloy synthesized and consolidated by one-step current-activated pressure-assisted processing of nanocrystalline elemental powders. The end-product was analyzed using a combination of scanning (SEM) and transmission electron microscopies (TEM), electron back-scattering diffraction (EBSD) as well as electron probe microanalysis (EPMA). Special attention was paid to verify the grain size (32–89 nm) previously determined by X-ray diffraction peak profile analysis. It has been found that this material displays equiaxed grains (0.8–4 μm in size) and contains limited structural defects like subgrains and dislocations. The EPMA result reveals that a variability in Al content (36–47 at.%) is present within the synthesized FeAl phase. Thus, the local variation of lattice parameters resulting from this heterogeneity accounts for the broadening of X-ray diffraction peaks instead of the common idea that the broadening is due to the small grain size. The formation mechanisms of the structure and the composition heterogeneity are also discussed and related to the combustion reaction process. 相似文献
17.
The effect of grinding on the surface layer properties of ceria and yttria partially stabilized zirconia plasma-sprayed coatings
(CePSZ, YPSZ, respectively) has been studied by X-ray diffraction methods. For this purpose, the modified model of line broadening
analysis has been derived. The model considers elastic anisotropic properties along with more random paracrystal imperfections,
both affecting X-ray line broadening. Grinding-induced microstructural changes were also studied using an estimation from
the quantitative Orientation Distribution Function (ODF) texture. It was concluded, based on this work, that CePSZ ceramic
is less mechanically stable compared to YPSZ. Consequently, more beneficial mechanical properties of a ground surface layer
can be expected for CePSZ plasma-sprayed coatings. 相似文献
18.
19.
20.
圆环镦粗法是塑性成形中常用的摩擦因子测试方法,圆环试样尺寸直接影响测试的灵敏度。以两种摩擦条件下内径变化量的差值作为目标,基于有限元模拟采用多岛遗传算法进行圆环试样尺寸的优化,优化结果比例为30∶13∶5,与经典尺寸比例(6∶3∶2)相比,内径变化量的差值提高了47.31%。在此基础上,将优化尺寸与经典尺寸比例作进一步对比,从等效应变场、金属流线分布、接触正压力以及标定曲线等结果,分析了优化尺寸比例的优势。根据优化的试样尺寸比例,开展了相关的实际测试工作,测出3种不同润滑剂的摩擦因子,证实优化方案的可用性。 相似文献