Eco-friendly approach for preparation of hybrid silica aerogel via freeze drying method

Journal of Materials Science - In this paper, an eco-friendly method of producing hybrid silica aerogels by freeze-drying method (FD) is proposed. In the freeze-drying system, deionized water was...     

Effect of malondialdehyde oxidation on structure and physicochemical properties of amandin

Oil, accounting for 45% of almonds, is easily oxidised and can further induce the protein oxidation to reduce their quality. Structure and physicochemical properties of amandin, the main water-soluble protein in almonds, inducing oxidation by malondialdehyde (MDA) were investigated. The results showed that the content of carbonyl group increased from 5.23 to 33.25 nmol mg⁻¹ of protein with the increase in MDA concentration (P < 0.05). However, the sulphydryl content, surface hydrophobicity, particle size and the absolute value of ζ-potential first increased and then decreased. Fourier-transformed infrared spectroscopy (FT-IR) confirmed that the structure of amandin changed from order to disorder. Fluorescence spectroscopic analysis revealed that mild oxidation (0–0.1 mmol L⁻¹ MDA) exposed hydrophobic groups of the protein. Sodium dodecyl sulphate polyacrylamide gel electrophoresis (SDS-PAGE) suggested that protein oxidation promoted crosslinking between protein molecules. Furthermore, protein oxidation markedly declined the total amino acid content of amandin (P < 0.05). In conclusion, MDA oxidation changed the structure and amino acid content of amandin, and caused the protein aggregate and crosslink through hydrophobic interaction and electrostatic interaction.     

4140钢弯壳体断裂原因分析和改进措施

某钻具厂生产的一个批次的4140钢螺杆钻具弯壳体出现较多断裂。通过化学成分、力学性能和显微组织分析对失效弯壳体断裂原因进行了研究,并相应优化了热处理工艺。结果表明:弯壳体失效断裂主要原因是由于淬火过程中未淬透,导致显微组织存在大量条状和块状铁素体,未淬透的组织导致材质的强度、硬度和冲击性能较差,从而导致断裂。采用优化的淬火工艺,材料寿命达到了正常水平。     

金沙江上游水电站应对白格堰塞湖灾害的措施及经验

2018年10月、11月,西藏自治区昌都市江达县白格村两次发生山体滑坡造成金沙江断流并形成白格堰塞湖,给金沙江上游沿岸人民生产生活设施造成巨大安全威胁和超过百亿元的经济损失。华电金沙江上游水电开发有限公司组织所属企业及参建单位快速应对,采取撤离避让、工程防护、人工干预、生产恢复,推动后续处置、风险评估等措施,最大限度减轻了对金沙江上游叶巴滩、拉哇、巴塘、苏洼龙等在建水电站的灾害损失和后续影响,为类似灾害的处置提供借鉴经验。     

An efficient NFEM for optimal control problems governed by a bilinear state equation

In this paper, a nonconforming finite element method (NFEM) is proposed for the constrained optimal control problems (OCPs) governed by a bilinear state equation. The state and adjoint state are approximated by the nonconforming $E{Q}_1^{rot}$ element, and the control is approximated by the orthogonal projection through the state and adjoint state. Some superclose and superconvergence properties are obtained by full use of the distinguish characters of this $E{Q}_1^{rot}$ element, such as the interpolation operator equals the Ritz projection, and the consistency error is one order higher than its interpolation error in the broken energy norm. Finally, some numerical results are provided to verify the theoretical analysis.     

离子色谱-电导法检测酱油中氯化钠的含量

该研究采用灰化预处理+离子色谱-电导法检测酱油中食盐的含量，并与莫尔法、电位滴定法进行比较。结果表明，莫尔法存在滴定过量问题，电位滴定法对温度等外界环境条件和仪器操作要求苛刻，而离子色谱-电导法具有操作简便快速并具有较好的准确度和精密度。实验结果表明，氯化钠含量处于11.56～11.61 g/100 mL之间，回收率实验结果为96.00%～102.10%，相对标准偏差为0.089%。干扰实验对结果无明显影响，且能同时测定多种离子，可用于成品酱油中氯化钠含量的检验。     

Efficient MOF- derived V–Ni3S2 nanosheet arrays for electrocatalytic overall water splitting in alkali

The synergistic achievement of low-cost earth-abundant electrocatalysts and high efficiency to meet renewable energy need is highly desirable yet challenging. Here, we developed a simple Ni foam self -templating route for V-doped Ni₃S₂ nanosheet arrays through in situ formation of metal-organic frameworks (MOFs) combined with subsequent conversion. The as-prepared MOF-V-Ni₃S₂/NF catalyst delivers outstanding electrocatalytic performance in the alkaline solution, which requires low overpotentials of 118.1 mV @10 mA cm^?2 and 268 mV @10 mA cm^?2 for hydrogen evolution reaction and oxygen evolution reaction, respectively. The V-doping and MOF-derived 3D hieratical nanostructure play a vital role in the catalytic process, which provides efficient active sites and large surface areas. Furthermore, an alkaline electrolyzer was assembled with two pieces of MOF-V-Ni₃S₂/NF, which achieves efficient water splitting at 1.58 V @10 mA cm^?2. This strategy opens up new channels to synthesize MOF-based bifunctional electrocatalysts toward overall water spitting.     

DP980高强钢连续退火后的组织与性能

研究了不同工艺参数对980 MPa级连续退火双相钢组织及力学性能的影响,利用光学显微镜、透射电镜(TEM)以及拉伸试验对双相钢的微观组织和力学性能进行测试及分析。结果表明:DP980钢的退火组织主要由铁素体、马氏体岛和少量的贝氏体组成,马氏体岛附近的位错密度较高。随着均热温度的升高,DP980钢的抗拉强度呈现先降低后升高的趋势,屈服强度与抗拉强度的趋势一致,伸长率先升高后降低。随着过时效温度的升高,DP980钢的抗拉强度和屈服强度降低,降低幅度较小,伸长率上升,但变化不明显,说明通过调整过时效温度来调控其力学性能的作用较小。     

Solution-Processed Organic Solar Cells with High Open-Circuit Voltage of 1.3 V and Low Non-Radiative Voltage Loss of 0.16 V

Compared with inorganic or perovskite solar cells, the relatively large non-radiative recombination voltage losses (ΔV_non-rad) in organic solar cells (OSCs) limit the improvement of the open-circuit voltage (V_oc). Herein, OSCs are fabricated by adopting two pairs of D–π–A polymers (PBT1-C/PBT1-C-2Cl and PBDB-T/PBDB-T-2Cl) as electron donors and a wide-bandgap molecule BTA3 as the electron acceptor. In these blends, a charge-transfer state energy (E_CT) as high as 1.70–1.76 eV is achieved, leading to small energetic differences between the singlet excited states and charge-transfer states (ΔE_CT ≈ 0.1 eV). In addition, after introducing chlorine atoms into the π-bridge or the side chain of benzodithiophene (BDT) unit, electroluminescence external quantum efficiencies as high as 1.9 × 10⁻³ and 1.0 × 10⁻³ are realized in OSCs based on PBTI-C-2Cl and PBDB-T-2Cl, respectively. Their corresponding ΔV_non-rad are 0.16 and 0.17 V, which are lower than those of OSCs based on the analog polymers without a chlorine atom (0.21 and 0.24 V for PBT1-C and PBDB-T, respectively), resulting in high V_oc of 1.3 V. The ΔV_non-rad of 0.16 V and V_oc of 1.3 V achieved in PBT1-C-2Cl:BTA3 OSCs are thought to represent the best values for solution-processed OSCs reported in the literature so far.