940nm高功率激光二极管及线阵

设计并制作出了940 nm无铝有源区高功率激光二极管和激光条.通过MOCVD法生长出应变量子阱材料,器件显示出极好的性能,100μm条宽的激光二极管最大输出功率达800mW(室温),填充因子为17%的激光二极管条发射功率达32 W.     

基于PLC的多组空压机组监控系统的研制

介绍PLC在多组空压机组自动控制中的应用，叙述了系统的硬件配置和软件设计。投入运行后，大大提高了空压机运行的安全可靠程度和自动化控制水平。     

几种典型凸轮裹包执行机构的从动系统运动规律的理论分析

详细分析了裹包执行机构的正弦型和正切型从动系统的运动规律，用数学方法对运动规律进行了详尽的理论分析。     

八尺门特大桥φ2.8 m桩基施工质量控制

介绍了八尺门特大桥的工程建况、水文地质情况和施工方案的确定，并较为系统、全面地阐述了该大桥φ2.8m大直径钻孔桩的施工过程。从钢护筒沉桩到灌注过程、每道施工程序、采用的方法、质量的控制要点以及施工中的其它问题进行了较具体的讨论与分析，取得了良好的施工效果。     

水电站复杂输水系统恒定流的数值计算

对单元总体方程进行了局部修改，使方程的求解具有唯一性和更高的可靠性。提出水电站恒定流数值计算只有四种给定条件，每种条件都能保证计算结果的唯一性；计算实例证明，相同工况条件下根据四种给定条件求解的计算结果非常吻合。     

Nutrient removal performance of an anaerobic–anoxic–aerobic process as a function of influent C/P ratio

The laboratory scale anaerobic–anoxic–aerobic (A²O) process fed with synthetic brewage wastewater was designed to investigate the effects of changing feed C/P ratio on the performance of biological nutrient removal (BNR) processes. In the experiment, the influent chemical oxygen demand (COD) concentration was kept at approximately 300 mg L^?1 while the total phosphorus concentration was varied to obtain the desired C/P ratio. Results showed that when the C/P ratio was lower than 32, phosphorus removal efficiency increased as C/P ratio increased linearly, while when the C/P ratio was higher than 32, the P removal efficiency was maintained at 90–98%, and effluent P concentration was lower than 0.5 mg L^?1. However, regardless of the C/P ratio, excellent COD removal (90% or higher) and good total nitrogen removal (75–84%) were maintained throughout the experiments. It was also found that very good linear correlation was obtained between COD uptake per unit P released in the anaerobic zone and C/P ratio. In addition, the P content in the wasted activated sludge increased with the decrease in the C/P ratio. Based on the results, it was recommended that the wastewater C/P ratio and its effects be incorporated into BNR design and operational procedures, appropriate C/P ratios were used to achieve the effluent treatment goals. Copyright © 2005 Society of Chemical Industry     

Infrared and ultraviolet–visible spectroscopic studies of silica, [(Cp)2ZrCl2] and trimethylaluminum interactions

Infrared and UV–vis studies of metallocene immobilization on silica are reported here. The results have indicated changes in the Zr coordination sphere of metallocene depending on the immobilization route used. The reaction of [(Cp)₂ZrCl₂] with silica formed [(Cp)₂ZrCl]⁺[SiO]⁻ species. The same metallocene, reacting with TMA modified silica, formed monomethylated and dimethylated species by the substitution of chloro for methyl ligands, stabilized on the surface by interaction with “MAO-like” species (methylaluminoxane, MAO). These monomethylated and dimethylated cationic zirconium species are the active centers for the polymerization reaction. Different order of TMA addition in the silica modification step generated surface species of a similar nature, differing in their relative quantities. The highest amount of these active species was obtained when the support was added to the TMA solution rather than adding the TMA solution to the silica support. This was the most significant parameter affecting catalytic activity in ethylene polymerization.     

光电双基区晶体管(PDUBAT)的器件模型

本文在考虑了晶体管的小注入效应和大注入效应以及基区宽变效应等因素后,首次用近似和简化的数学表示式和相应的等效电路,描述了光电双基区晶体管(PDUBAT)负阻形成的机理并使负阻区和谷值区的理论计算和实验结果一致性很好.     

对包装工程教育的认识及其本科教育模式的探索

在对高等工程教育本质以及存在问题进行分析的基础上，针对包装工程教育进行了深入探讨。并结合郑州大学包装工程专业的特点，对复合型人才培养的教育模式进行了探索与实践。     

基于ARX模型的压电智能结构振动预测控制

采用预测控制法对压电智能结构的振动主动控制进行了实验研究，通过实验方法建立了系统的ARX模型，并在此基础上设计了预测控制器对结构进行振动主动控制。实验结果验证了该方法在压电智能结构振动主动控制中的可行性和有效性。