Influence of Se and Te substitutions at Tl-site of Tl(Ba,Sr)CaCu2O7 superconductor on the AC susceptibility and electrical properties

The Sr and Ba bearing Tl-1212 phase, Tl(Ba,Sr)CaCu₂O₇ is an interesting superconductor. The Sr only bearing TlSr₂CaCu₂O₇ is not easily prepared in the superconducting form. The Ba only bearing TlBa₂CaCu₂O₇ on the other hand does not show improvement in the transition temperature with elemental substitution. In this work the influence of multivalent Se (non-metal) and Te (metalloid) substitutions at the Tl-site of Tl_1-xM_x(Ba,Sr)CaCu₂O₇ (M = Se or Te) superconductors for x = 0–0.6 was studied. The samples were prepared via the conventional solid-state reaction method. XRD patterns showed a single Tl-1212 phase for x = 0 and 0.1 Se substituted samples. The critical current density at the peak temperature, T_p of the imaginary (χ”) part of the AC susceptibility (χ = χ’ +χ”), J_c-inter(T_p) for all samples was between 15 and 21 A cm⁻². The highest superconducting transition temperature was shown by the x = 0.3 Se-substituted sample (T_c-onset = 104 K, T_c-zero = 89 K, T_cχ’ = 104 K and T_p = 80 K). Te suppressed the superconductivity of Tl-1212 phase. The order of highest transition temperatures are as follows: Tl_1-xTe_x(Ba,Sr)CaCu₂O₇<Tl(Ba,Sr)CaCu₂O₇<Tl_1-xSe_x(Ba,Sr)CaCu₂O₇. This work showed that Se was better than Te in improving the transition temperature and flux pinning of the Tl-1212 phase. The roles of ionic radius of Se and Te on the superconductivity of Tl(Ba,Sr)CaCu₂O₇ are discussed in this paper.     

Dielectric properties of alumino-silicate ceramics synthesized by plasma sintering

The polycrystalline ceramic specimens of three different alumino-silicate solid solutions (Al_0.70Si_0.30O, Al_0.73Si_0.27O and Al_0.75Si_0.25O) consisting of different alumina and silica concentrations have been synthesized by thermal plasma sintering technique. From structural analysis carried out by X-ray diffraction, the ceramics are mostly found to consist of two different phases of mullite and sillimanite. SEM images of these ceramics reveal a high dense and less porous microstructure with homogeneous distribution of grains throughout their surface. These materials exhibit high dielectric constant value (>10³) with low dissipation factor. The AC conductivity analysis reveals that Al_0.70Si_0.30O and Al_0.75Si_0.25O ceramics possess room temperature conductivity values of the order of 10^?5, whereas Al_0.73Si_0.27O has conductivity of 10^?7 order that increases with rise in temperature. From the Nyquist plots, the grain and grain boundary conductivities are distinguished and negative temperature coefficient of resistance behavior is identified in these ceramics with small positive temperature coefficient of resistance effect.     

基于Stateflow电力机车变流器控制设计与实现

某出口型号交流电力机车牵引控制系统要求变流器控制逻辑具备接触器控制、牵引系统数据交互、变流器故障保护、变流器启动自检等功能。针对以上功能,基于MATLAB中的Simulink/Stateflow可视化编程工具进行牵引控制模型的搭建,遵循模块化编程理念,采用较少的程序代码编写实现复杂的逻辑控制模型,生成逻辑清晰的控制功能流程图,进行半实物仿真测试,增强控制模型的可靠性。通过该变流器产品型式试验检验,验证变流器控制逻辑的功能可以满足控制系统的需求。     

Full AC analysis of value of DER to the grid and optimal DER scheduling

This paper presents part of the work ComEd and Quanta Technology have performed to quantify the locational and temporal value of DER to avoid distribution grid upgrade investments. It focuses on the formulation of a robust and efficient algorithm for DER optimal dispatch on a distribution feeder to mitigate the violation of current and voltage limits using the allocated cost of capacity and locational marginal value of real and reactive DER injection/withdrawal.     

一种交直流混合输电系统直流侧双极故障保护策略

为进一步分析含柔性直流输电(MMC-HVDC)的交直流混合输电系统的故障特征,基于交直流混合输电系统和模块化多电平换流器(MMC)的拓扑结构,推导了MMC的数学模型,研究了直流系统双极短路的故障机理和故障特征,针对含MMC-HVDC的交直流混合输电系统的双极短路故障,设计了限流电路及闭锁换流站与交流断路器跳闸相结合的故障保护方案。以厦门市柔性直流输电系统为例,在PSCAD/EMTDC中搭建了交直流混合系统,并对保护方案进行了仿真验证。结果表明,提出的保护策略能有效地降低故障电流,提高系统稳定性。     

Power flow calculation for a distribution system with multi-port PETs: an improved AC-DC decoupling iterative method

Recently, power electronic transformers (PETs) have received widespread attention owing to their flexible networking, diverse operating modes, and abundant control objects. In this study, we established a steady-state model of PETs and applied it to the power flow calculation of AC–DC hybrid systems with PETs, considering the topology, power balance, loss, and control characteristics of multi-port PETs. To address new problems caused by the introduction of the PET port and control equations to the power flow calculation, this study proposes an iterative method of AC–DC mixed power flow decoupling based on step optimization, which can achieve AC–DC decoupling and effectively improve convergence. The results show that the proposed algorithm improves the iterative method and overcomes the overcorrection and initial value sensitivity problems of conventional iterative algorithms.     

Co-substitution of zirconium and neodymium on hyperfine interactions and AC susceptibility of SrFe_(12)O_(19) nanohexaferrites

This study presents the influence of Zn and Nd co-substitution on structure,morphology,AC susceptibility and ZFC-FC magnetizations of Sr nanohexaferrites(NHFs),SrFe_(12-x)(Zn,Nd)_xO_(19)(0.0≤x≤1.0),which was produced by sol-gel approach.XRD powder patterns,scanning electron microscopy(SEM) and high-resolution transmission electron spectroscopy(HR-TEM) approve the synthesis of Sr M-type hexaferrite.Mossbauer spectra show that Zn~(2+)ions occupy 2 b and 4f_1 sites while Nd~(3+)ions locate at 2 a,4f_2 and 12 k sites.The magnetic properties of the produced Sr-NHFs were investigated also by ZFC-FC magnetizations and AC susceptibility.According to the M_(FC)-M_(ZFC) results(between 2 and 400 K),no blocking temperature was detected which indicates the ferromagnetic(FM) behavior of NHFs.At lower temperatures,a super-spin glass like behavior is discerned.The AC susceptibility indicates that the magnetic interactions are improved due to the inclusion of low content(x=0.1) of Nd~(3+)and Zn~(2+)ions into the Sr-NHFs.However,with further increasing the Nd~(3+)and Zn~(2+)contents(x=0.9),the magnetic interactions are weakened.     

Transmission system restoration with co-optimization of repairs,load pickups,and generation dispatch

This paper studies the restoration of a transmission system after a significant disruption such as a natural disaster. It considers the co-optimization of repairs, load pickups, and generation dispatch to produce a sequencing of the repairs that minimizes the size of the blackout over time. The core of this process is a Restoration Ordering Problem (ROP), a non-convex mixed-integer nonlinear program that is outside the capabilities of existing solver technologies. To address this computational barrier, the paper examines two approximations of the power flow equations: The DC model and the recently proposed LPAC model. Systematic, large-scale testing indicates that the DC model is not sufficiently accurate for solving the ROP. In contrast, the LPAC power flow model, which captures line losses, reactive power, and voltage magnitudes, is sufficiently accurate to obtain restoration plans that can be converted into AC-feasible power flows. An experimental study also suggests that the LPAC model provides a robust and appealing tradeoff between accuracy and computational performance for solving the ROP.     

AC susceptibility and hyperfine interactions of vanadium substituted barium nanohexaferrites

Vanadium ions substituted BaFe₁₂O₁₉ nanohexaferrites, BaFe_12-xV_xO₁₉ (0.0?≤x?≤?0.1), were produced through the sol-gel auto-combustion route. The structure, morphology and the elemental compositions of various products were examined using X–ray powder diffraction, scanning electron microscopy coupled with EDX and EDS elemental mapping. These techniques confirmed the formation of the desired Ba-nanohexaferrite phases. The crystallites size was found to be 55–58?nm range for all products. The magnetic properties of BaFe_12-xV_xO₁₉ nanohexaferrites were investigated by Mossbauer spectroscopy, ZFC-FC magnetizations and AC susceptibility. The evolutions in the values of hyperfine magnetic field, isomer shift, quadrupole splitting, and line width were deduced via Mossbauer analysis. The experiments of ZFC and FC magnetizations indicated that no blocking temperature is observed in the temperature interval 2–400?K, which signals the typical ferromagnetic (FM) behavior for the produced nanohexaferrites. A super-spin glass like behavior is noticed at lower temperatures. The experiments AC susceptibility confirmed that the strength of magnetic interactions is enhanced for lower content of V³⁺ (x?=?0.02). For higher amount of V³⁺, the magnetic interactions are weakened. The obtained results are mainly accredited to the substitutions of Fe³⁺ ions by V³⁺ ions.