薄膜厚度对TGZO透明导电薄膜光电性能的影响

利用直流磁控溅射法,在室温水冷玻璃衬底上成功制备出了可见光透过率高、电阻率低的钛镓共掺杂氧化锌(TG-ZO)透明导电薄膜。X射线衍射和扫描电子显微镜研究结果表明,TGZO薄膜为六角纤锌矿结构的多晶薄膜,且具有c轴择优取向。研究了厚度对TGZO透明导电薄膜电学和光学性能的影响,结果表明厚度对薄膜的光电性能有重要影响。当薄膜厚度为628 nm时,薄膜具有最小电阻率2.01×10-4Ω.cm。所制备薄膜在波长为400~760 nm的可见光中平均透过率都超过了91%,TGZO薄膜可以用作薄膜太阳能电池和液晶显示器的透明电极。     

ZnO∶Nb透明导电薄膜的制备及光电特性研究

采用直流磁控溅射法在玻璃衬底上沉积铌掺杂氧化锌(NZO)透明导电薄膜。通过X射线衍射(XRD)、扫描电镜(SEM)以及透射光谱等测试研究了溅射功率对薄膜结构、形貌以及光电性能的影响。实验结果表明NZO薄膜是多晶膜,具有ZnO的六角纤锌矿结构,最佳取向为(002)方向。溅射功率从40W增加到80W时,薄膜的电阻率迅速下降;功率超过80W时,电阻率趋于平稳。在溅射功率为100W时,电阻率具有最小值5.89×10-4Ω.cm,光学带隙具有最大值3.395eV。实验制备的NZO薄膜附着性能良好,在可见光范围内的平均透过率均超过86.6%。     

超声波雾化加湿器原理及检修

超声波雾化加湿器利用超声波对液体进行雾化作用，能将水雾化后喷至工作场所、居住房间改善环境湿度，净化环境空气，或将雾化药水直接喷至病灶部位，以提高治疗效果。已广泛应用在办公室、车间、卧室、医疗部门等地方。虽然它们型号各异、功率大小不同但基本工作原理相同。超声波雾化加湿器主要由电源电路、超声波发生电路、水槽、     

p-Si TFT栅绝缘层用SiN薄膜的研究

以NH3和SiH4为反应源气体,采用射频等离子体增强化学气相沉积(RF-PECVD)法在多晶硅(p-Si)衬底上沉积了一系列SiN薄膜,并利用椭圆偏振测厚仪、超高电阻-微电流计、C-V测试仪对所沉积的薄膜作了相关性能测试.系统分析了沉积温度和射频功率对SiN薄膜的相对介电常数、电学性能及界面特性的影响.分析表明,沉积温度和射频功率主要是通过影响SiN薄膜中的Si/N比影响薄膜的性能,在制备高质量的p-Si TFT栅绝缘层用SiN薄膜方面具有重要的参考价值.     

溅射压强对柔性PET衬底ZnO薄膜性能的影响

利用直流磁控溅射法,在室温水冷柔性PET衬底上成功制备出了掺钛氧化锌(ZnO:Ti,TZO)透明导电薄膜。通过X射线衍射(XRD)研究了薄膜的结构,用扫描电镜(SEM)研究了薄膜的表面形貌,用四探针和紫外-可见分光光度计等仪器对薄膜的特性进行测试分析,研究了溅射压强对ZnO:Ti薄膜表面结构、形貌、力学、电学和光学性能的影响。结果表明,溅射压强对PET衬底上的TZO薄膜的性能有显著的影响,实验制备的ZnO:Ti薄膜为具有C轴择优取向的六角纤锌矿结构的多晶薄膜;当溅射压强从2Pa增加到4Pa时,薄膜的电阻率由10.87×10-4Ω.cm快速减小到4.72×10-4Ω.cm,随着溅射压强由4Pa继续增大到6Pa,薄膜的电阻率变化平缓,溅射压强为5Pa时薄膜的电阻率最小,为4.21×10-4Ω.cm;经计算得到6Pa时样品薄膜应力最小,为0.785 839GPa;所有样品都具有高于91%的可见光区平均透过率。     

缓冲层厚度对透明导电薄膜ZnO∶Zr性能的影响(英文)

利用直流磁控溅射法在有ZnO∶Zr缓冲层的水冷玻璃衬底上成功制备出了ZnO∶Zr透明导电薄膜,缓冲层的厚度介于35～208nm。利用XRD、SEM、四探针测试仪和紫外-可见分光光度计研究ZnO∶Zr薄膜的结构、形貌、电光性能。结果表明,薄膜的颗粒尺寸和电阻率对缓冲层厚度具有较强的依赖性。当缓冲层厚度从35nm增加到103nm时,薄膜的颗粒尺寸增大,电阻率减小。而当缓冲层厚度从103nm增加到208nm时,薄膜的颗粒尺寸减小,电阻率增大。当缓冲厚度为103nm时,薄膜的电阻率最小为2.96×10^-3Ω.cm,远小于没有缓冲层时的12.9×10^-3Ω.cm。实验结果表明,在沉积薄膜之前先沉积一层适当的缓冲层是提高ZnO∶Zr薄膜质量的一种有效方法。     

Influence of the sputtering pressure on the properties of transparent conducting zirconium-doped zinc oxide films prepared by RF magnetron sputtering

Transparent conducting zirconium-doped zinc oxide films with high transparency and relatively low re-sistivity have been successfully prepared on water-cooled glass substrate by radio frequency magnetron sputtering at room temperature. The Ar sputtering pressure was varied from 0.5 to 3 Pa. The crystallinity increases and the electri-cal resistivity decreases when the sputtering pressure increases from 0.5 to 2.5 Pa. The cystallinity decreases and the electrical resistivity increases when the sputtering pressure increases from 2.5 to 3 Pa. When the sputtering pressure The deposited films are polycrystalline with a hexagonal structure and a preferred orientation perpendicular to the substrate.     

Influence of the distance between target and substrate on the properties of transparent conducting Al-Zr co-doped zinc oxide thin films

Highly transparent and conducting Al-Zr co-doped zinc oxide (ZAZO) thin films were successfully prepared on glass substrate by direct current (DC) magnetron sputtering at room temperature.The distance between target and substrate was varied from 45 to 70 mm.All the deposited films are polycrystalline with a hexagonal structure and have a preferred orientation along the c-axis perpendicular to the substrate.The crystallinity increases obviously and the electrical resistivity decreases when the distance betwe...     

Low-temperature deposition of transparent conducting Mn-W co-doped ZnO thin films

Mn-W co-doped ZnO(ZMWO) thin films with low resistivity and high transparency were successfully prepared on glass substrate by direct current(DC) magnetron sputtering at low temperature.The sputtering power was varied from 65 to 150 W.The crystallinity and resistivity of ZMWO films greatly depend on sputtering power while the optical transmittance and optical band gap are not sensitive to sputtering power.All the deposited films are polycrystalline with a hexagonal structure and have a preferred orientat...     

直流磁控溅射法制备ZnO∶Zr透明导电薄膜及性能研究

利用直流磁控溅射法在玻璃衬底上制备了ZnO∶Zr(ZZO)透明导电薄膜。研究了厚度对薄膜结构及光电性能的影响。研究结果表明,厚度对薄膜的结构和电学性能有很大的影响。制备的ZZO薄膜为六角纤锌矿结构的多晶薄膜,具有c轴择优取向。在厚度为593nm时,薄膜的电阻率具有最小值1.9×10-3Ω·cm。所制备薄膜样品的可见光平均透过率都超过93%。